Emergency brake not working properly consistently, loosens, has been repaired, replaced, still fails, loosens. Have had 2 accidents related to this, leg was run over. Second time rolled into tree almost 12000 dollars in damage, issues just about since purchase, saw multiple dealers, issue continues
Brakes
Jeep Gladiator Brake problems by year
50 complaints filed with NHTSA about the Jeep Gladiator's brakes. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
Brake complaints by model year
Latest Gladiator brake complaints
Clutch overheated and cause an immense amount of smoke during drive with no warning indication from hud. Dealer stated that clutch has gotten well passed 390c Heat from clutch has also caused front driver caliper to lock up and damage rotors.
This happened on a 2024 Jeep Gladiator. When parking I went to set the parking brake and as I pulled the handle I heard a pop and felt the handle release all pressure. With the handle up there was no braking effect. Dealer repaired by hooking the right wheel cable back onto the bracket located under the center console, and then adjusting.
Front brake caliper(s) was seizing up causing smoking and a burning smell. Vehicle was also pulling to the right when braking. Brake fluid or something like it coated the front drivers side wheel. Took vehicle back to dealership where vehicle was purchased new. Vehicle is still under warranty/extended warranties. The dealer did inspect and found front calipers to be seizing up causing excessive wear on brake pads and rotors. They did replace both front calipers but not the brake hoses. They also replaced and...
Read the full complaint
charged me for new brake pads and rotors. Not even a week later, I called the dealer to report the same problem, the brakes were again seizing up and there was a smoking/burning smell. The dealer ordered the new brake hoses, found that the brake hoses they attempted to re-use had collapsed causing all the above mentioned problems. The dealer had them installed and so far so good.
Parking brake would not hold vehicle on hill. When the handle was released, a metalic clinking noise was heard. Castle rock jeep dealership said all was fine. Upon my inspection, I found the parking brake cable connection under teh center console was no longer connected. The cable was reconnected, and the cable was tightened to specifications indicated my Jeep. THe vehicle had 6200 miles on it. p.s. THis was after the warranty replacement of the engine. THe dealership indicated they tested several other jeeps and they all acted as mine. No concern for safety.
My 2024 Jeep Gladiator Mojave has an ongoing brake issue that persists despite inspections by multiple dealerships. When starting the vehicle in the morning, the brake pedal is unusually hard and sits lower than expected, requiring excessive force before the engine will engage. Once the engine is running, pedal pressure returns to normal. For comparison, I also regularly drive a 2020 Jeep Gladiator and a 2023 Jeep Wrangler, neither of which exhibit this condition. Additionally, after driving for approximately one...
Read the full complaint
hour or longer, the vehicle experiences significant brake fade. Increased pedal pressure is required to slow or stop the vehicle, particularly during downhill driving. I routinely drive long distances between Seattle and Tucson and consider this a serious safety concern. In an attempt to address the issue, I spent several hundred dollars upgrading the braking system with ceramic brake pads and drilled rotors. While overall braking performance improved somewhat, the hard brake pedal during startup and brake fade issues remain constant and unresolved. I have worked extensively with two Jeep dealerships regarding this matter: Larry H. Miller Chrysler Jeep Tucson and West Hills Chrysler Jeep Dodge RAM. I also contacted a Jeep customer service representative, who advised that if dealership technicians could not identify a problem, then no issue existed. An independent mechanic suggested the symptoms may indicate a vacuum leak affecting the brake booster system, which could explain the excessive pedal force required during startup. However, to the best of my knowledge, neither dealership has performed a thorough investigation of the brake booster or vacuum system.
This vehicle suffered a sudden; catastrophic hydraulic brake fluid leak and complete system failure shortly after a service visit with only 700 miles total on the new vehicle. Hours prior to the failure, Lindsay Chrysler Dodge Jeep Ram of Manassas, VA (where the vehicle was purchased new, earlier that month) performed and signed off on a multi-point inspection as fully functional while the vehicle was taken in for other warranty service (non safety or brake related). As a former mechanic, I inspected the vehicle...
Read the full complaint
immediately when I arrived home on the same day and discovered the brake fluid reservoir was almost half empty with fluid actively leaking and pooling on the frame and around the inner fender! Due to the catastrophic safety risk, the vehicle was immediately towed to Safford Jeep of Fredericksburg, VA to due it being geographically closer to my home, confirming the safety failure, and fixing the following defective components: Brake Hydraulic Control Unit and ABS Module. Lindsay Chrysler Dodge Jeep Ram of Manassas, VA (the originally servicing dealership) completely falsified the multi-point safety inspection that they signed off on, sending my vehicle on public roads in Northern Virginia, some of the most dangerous traffic in the world. Of note, I also drive the vehicle to/from work almost 100 miles per day during the week to/from Stafford, VA to Washington, DC. If I had not inspected the vehicle myself and waited until the first appointment for the first oil change, this would have without a doubt, caused a serious accident in [[redacted]] , which is the route i mostly travel, a large amount of property damage, likely injury or possible death, due to the absolute fact that I would have lost all brake fluid and have had no brakes at all. There were no warning lamps illuminated at all. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
While my vehicle was still under factory warranty, a mechanical issue was diagnosed by the dealership and a replacement part was ordered. The part was placed on backorder, and I was advised I would be contacted once it arrived. I was never notified when the part became available. By the time I was contacted weeks later, the warranty period had expired. I immediately scheduled service once I learned the part was available. During the repair visit, I was informed that the prolonged delay resulted in additional...
Read the full complaint
damage, including components related to braking and sealing. These components are available for inspection and were identified by the servicing dealership. Brake system involvement raises safety concerns, as reduced braking effectiveness can increase stopping distance and risk to occupants and others. The condition was confirmed by dealership technicians during service. The issue was not caused by misuse and occurred due to a delayed repair that originated under warranty but could not be completed due to parts unavailability and lack of notification. The vehicle remains under dealer inspection and repair. Warning symptoms were present prior to service, and the condition was confirmed by the dealership upon inspection.
I was turning right and while turning the vehicle froze on me, these included the steering wheel brakes and almost crash into upcoming traffic since it was hard to turn I end up in the upcoming traffic lane
My Jeep Gladiator has recently been having multiple random error messages popping up. ABS warning, service 4WD, service shifter, traction control and others. Dealership charged $200 to diag a bad ABS module and charged $1400 to replace the module and controller. Less than 24 hrs later same issue occurred . Doing my own research this seems to be a common issue not just with Gladiators but other Jeeps as well. Many forums are saying it's bad wire connectors or broken wires from improper initial installation. Causes issues with speed control, braking, and power steering.
Driver side rear wheel speed sensor. This is a known issue national back order on the part, mechanic installed new part system does not reset and clear. In the current state, abs offline four-wheel drive system service required traction control service required. What is the true fix for this?
The contact owns a 2020 Jeep Gladiator. The contact stated that while driving at approximately 40 MPH, the vehicle had suddenly started to vibrate and shake. The contact stated that the vehicle was maintaining its lane but was lurching from left to right. No warnings illuminated. The contact stated that she pulled off to the side of the road; however, when she turned the vehicle on, it would start shaking again. The contact stated that she would keep driving while the vehicle was shaking, and the shaking would...
Read the full complaint
eventually stop. The contact stated that the shaking was occurring at any speed and was also triggered when she would drive over any small bumps or dips in the road. The contact stated recently, while she was driving in traffic at approximately 10 MPH, the vehicle started to shake again, however, this time violently. The contact stated that at the time, it was raining. The contact stated that it felt like the vehicle had lifted up, and then she crashed into the guard rail on the driver's side front bumper. The contact stated that the bumper and an LED light bar attached to the front grill had made contact and were slightly damaged, and the driver's side headlight stopped functioning. The police were not called, and the contact was not injured. The contact reported that the driver's side front air bag had deployed but had not inflated and was draped on her lap. The contact had not taken the vehicle to a local dealer or independent mechanic. The vehicle was not diagnosed and was not repaired. The contact reported that after the crash, she observed the check oil and check brake warnings illuminated. The contact stated that she needed to depress the brake pedal with more force in order to stop. The manufacturer was not informed of the failure. The failure mileage was approximately 109,000.
Date of Incident: [[redacted]] Time: [[redacted]] Location: Mount Pleasant, South Carolina Vehicle: 2024 Jeep Gladiator Rubicon X Mileage at Time of Incident: Approximately 11,000 miles System Involved: Adaptive Cruise Control / Braking System Speed at Time of Incident: 45 MPH in a 45 MPH zone Road & Weather Conditions: Dry, clear weather, good road conditions Description of Incident: While driving at approximately 45 MPH with the adaptive cruise control engaged, the traffic light ahead turned yellow. As I have...
Read the full complaint
done many times before in similar conditions, I applied the brakes firmly to slow and stop for the light. However, the vehicle did not slow down as normally expected. As the light turned red and cross traffic began entering the intersection, I pressed the brakes as hard as possible. The vehicle began to slow, and the tires felt like they were "hopping," but the vehicle never came to a complete stop. Because I was now in the middle of the intersection with a red light and vehicles entering from other directions, I released the brake to avoid a collision. At that point, the vehicle lurched forward, and I realized the cruise control system was still engaged and was actively propelling the vehicle forward. A short time later, the cruise control system finally disengaged on its own. This malfunction nearly caused a serious accident. Under normal operation, pressing the brake pedal firmly at any speed should immediately disengage adaptive cruise control, but this did not occur. Dealer Response: Immediately after the incident, the vehicle was taken to the Mount Pleasant Jeep dealership, SC. The dealership's technician connected a diagnostic code reader and stated there were no fault codes. They also checked for Technical Service Bulletins (TSBs) and stated none existed for this issue. The technician told me there was nothing further they could do. The dealership did not perform a road test, did not escalate the issue to the manufacturer. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Brake pedel to close to gas pedel.. When the driver pushes on brake pedel he can push on the gas pedel.. The truck went forward very fast./. I brought the truck used
During normal driving, dash would display multiple warning lights. There would be traction control, ABS inactive, and transmission errors displayed on the screen. Twice, there was a loss of power steering while driving. All signs pointed to a CAN buss issue, but dealer could not/ would not find it. Doing research, I found that the CAN buss connector located behind the glove compartment was known in the Jeep community to fail and cause these symptoms. The only replacement is offered by Mopar/Stellantis. Multiple...
Read the full complaint
models and makes under Stellantis company use this same connector that has bad solder connections inside. It causes increased resistance inside the connector, and causes CAN buss communication errors, and setting any one of hundreds of possible DTC. In every occasion, there was a loss of stability control, ABS, and multiple occasions of vehicle being locked in Park. In two occasions, the electric assist power steering was disabled.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data