Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Vehicle safety record

2003 Kenworth T300 Problems, complaints & recalls

No owner complaints about the 2003 Kenworth T300 have been filed with NHTSA. It is covered by 5 recalls, the latest in March 2007 for the automatic transmission.

NHTSA data checked

CAbout as many problems as a typical T300 year, for its age

Complaints
0
Recalls
5
Crashes
0
Fires
0
Injuries
0
Deaths
0

2003 Kenworth T300 recalls 5

Recall repairs are free. Your dealer fixes them whether or not you bought the car there - check your VIN at nhtsa.gov/recalls to see if yours is done. What to do

Power train: automatic transmission

07V1070004,592 vehicles affected

The problem
On certain trucks, the wiring, parts, or transmission programming required for the auto neutral feature to function as designed were either not installed, connected, or programmed properly.
The risk
If any of these conditions exists, the transmission will not automatically shift into neutral when left in drive with the parking brake set engaged. The vehicle could move without warning increasing the risk of a crash.
The fix
Dealers will inspect the affected vehicles to ensure the auto neutral feature functions properly and, if needed, will make the necessary repairs free of charge. The recall began on may 9, 2007. Owners may contact kenworth at 425-828-5440.

Engine and engine cooling: fan

04V1690002,586 vehicles affected

The problem
On certain trucks equipped with caterpillar c7 or 3126e 2002 engines and horton fan hubs, the fan hub mounting bolts can fail, resulting in the hub and fan assembly separating from the engine. This loss of clamp load causes unwanted vibration in the assembly that leads to bolt failure.
The risk
If the bolts fail, the complete hub and fan assembly could separate from the engine resulting in equipment damage and/or personal injury.
The fix
Dealers will install a new journal bracket. The recall began may 11, 2004. Owners should contact kenworth at 1-425-828-5440.

Power train: axle hubs

03V288000132 vehicles affected

The problem
On certain heavy duty trucks, the locking tab that locks the outer spindle nut onto the spindle was not engaged or properly bent over.
The risk
Failure to properly engage the locking feature into the nut could cause the nut to loosen which will eventually cause the wheel bearing to over heat and fail if undetected. If the loose nut is not detected, the outer end (tire, wheel and hub assembly) could become separated from the vehicle, increasing the risk of a crash.
The fix
Dealers will inspect the hubs to determine if the locking tabs are properly bent. If the locking tabs are not bent, then dealers will inspect the appropriate components for premature wear and replace such components as required and properly secure the retaining nut by bending over the locking tab. Owner notification began september 17, 2003. Owners should contact kenworth at 1-425-828-5440 or peterbilt at 940-591-4201.

Trailer hitches: fifth wheel assembly

03V168000483 vehicles affected

The problem
On certain trucks equipped with jost international jsk 37u series fifth wheels, a fatigue crack can develop in the bracket pin weld under certain loading conditions.
The risk
If left undetected or corrected it could lead to the separation of the fifth wheel top plate from its mounting structure, possibly resulting in a crash.
The fix
Dealers will replace the bracket pins and repair instructions free of charge. Peterbilt's owner notification began june 20, 2003. Kenworth's owner notification began june 12, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact peterbilt at 940-591-4201 or kenworth 425-828-5440.

Exterior lighting

03V0450009,890 vehicles affected

The problem
Certain trucks equipped with trailer connections fail to comply with the requirements of federal motor vehicle safety standards (fmvss) no. 121, "Air brake systems," and no. 108, "Lamps, reflective devices, and associated equipment." The supplier removed a rubber grommet from the trailer light line connector. The vehicles are experiencing corrosion at the 7-way trailer connection. This causes intermittent flashing/flickering of the trailer lights.
The risk
This could cause an electrical short and/or possible fire hazard.
The fix
Dealers will install the missing grommet on all affected chassis. If a connector is found defective, it will be replaced with a new connector. Owner notification is began on march 14, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1-425-828-5440.

What owners say

Be the first T300 owner to share.

Problems or none - your experience is exactly what the next buyer is looking for. Write it now

No complaints about the 2003 Kenworth T300 yet

No owner has filed a complaint about this vehicle with NHTSA. If yours has a problem, share it here and report it to NHTSA.

Kenworth T300: every year compared

YearComplaintsRecallsCrashesFiresTop problemGrade
20073500SteeringD
20060400-C
20051200Fuel systemB
20041401Electrical systemC
20030500-C
20020400-C
20012500SuspensionD
20000600-D
19990600-D
All T300 years

2003 Kenworth T300 vs rivals

More sales usually means more complaints, so compare similar vehicles of the same year. The grade compares each vehicle with its own model's other years.

Own a 2003 Kenworth T300? Share your experience.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Questions about the 2003 Kenworth T300

Does the 2003 Kenworth T300 have any recalls?

Yes - NHTSA lists 5 recalls for the 2003 Kenworth T300: automatic transmission (March 2007); fan (April 2004); axle hubs (August 2003); fifth wheel assembly (May 2003) and more. Recall repairs are free at any authorized dealer. Enter your VIN at nhtsa.gov/recalls to see whether yours has been fixed.

How many complaints has the 2003 Kenworth T300 had?

None have been filed with NHTSA so far.

Is the 2003 Kenworth T300 a reliable vehicle?

Its Safety Index is 42 out of 100 (grade C: about as many problems as a typical Kenworth T300 year, for its age). The index weighs complaints, crashes, fires, injuries, deaths and recalls against how long the vehicle has been on the road, compared with the same model's other years. It is not a measure of every repair - read the complaints and owner experiences, and have any used vehicle inspected before you buy.

Which Kenworth T300 years have the most complaints?
What should I do if my 2003 Kenworth T300 has a problem?

If it is a safety problem, stop driving it if it is unsafe and contact your dealer. Report it to NHTSA at nhtsa.gov/report-a-safety-problem - enough reports start investigations and recalls - and share your experience here so other owners know what to look for.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience