- The problem
- On certain trucks equipped with truck hub units manufactured by skf exclusively for use on arvinmeritor's ff98x series non-drive steer axles, the hub unit bearings can wear prematurely.
- The risk
- Seizure of the bearings can cause wheel separation or wheel end fire.
- The fix
- Dealers will replace all front axle hubs. Notification began july 16, 2003. The manufacturer has advised us that parts will not be available until september 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy with a reasonable time should contact peterbilt at 940-591-4201 or kenworth 425-828-5440.
Vehicle safety record
1998 Kenworth W900 Problems, complaints & recalls
Owners have filed 3 complaints about the 1998 Kenworth W900 with NHTSA, most often about the body, doors & structure (2) and the electrical system (1). It is covered by 6 recalls, the latest in April 2003 for the hub. For comparison, the 1997 has 1 and the 1999 has 3.
NHTSA data checked
CAbout as many problems as a typical W900 year, for its age
#254 most complained-about 1998 vehicle
- Complaints
- 3
- Recalls
- 6
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Most common 1998 Kenworth W900 problems
Share of all 3 complaints. One complaint can name more than one area. Tap an area for its complaints and recalls.
1998 Kenworth W900 recalls 6
Recall repairs are free. Your dealer fixes them whether or not you bought the car there - check your VIN at nhtsa.gov/recalls to see if yours is done. What to do
- The problem
- On certain heavy duty trucks equipped with replacement dana spicer tandem drive axle models ds463 and ds521, installed on vehicles from may 1, 2001 through february 1, 2002, an undersized attachment weld may fracture without warning.
- The risk
- The loss of this attachment to the vehicle chassis can adversely affect vehicle handling or driver control.
- The fix
- Dana is conducting the owner notification and remedy for this campaign. The dealers will remove the suspect bracket, inspect the axle housing, and reweld the bracket to the axle housing. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact dana at 616-567-1088 or kenworth at 425-828-5440.
- The problem
- Vehicle description: heavy duty trucks equipped with meritor fg941 steer axles. The gross axle weight rating (gawr) was determined incorrectly and over-stated on the vehicle certification label. With the incorrect gawr listed, these labels do not meet the certification requirements of part 567, "requirements for manufacturers of motor vehicles." Vehicles will be remedied either by assigning the proper weight rating or, if possible, by changing the necessary components to meet the currently assigned weight rating.
- The risk
- These vehicles would not be in compliance with federal regulations.
- The fix
- Vehicles will be remedied either by assigning the proper weight rating or, if possible, by changing the necessary components to meet the currently assigned weight rating. Owner notification began june 22, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1-425-828-5000.
- The problem
- Vehicle description: vehicles equipped with 54" rear axle spacing configuration of the airglide 200 suspension with the service application identified as logger, dump truck, or tanker. The rear suspension is regularly subjected to extreme articulation, resulting in flexing of the joint.
- The risk
- Failure of the lower sway arm attaching bolts could result in loss of vehicle control.
- The fix
- Dealers will replace the lower sway arm brackets. Owner notification began march 27, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1-425-828-5000.
- The problem
- Vehicle description: heavy duty trucks equipped with caterpillar engines and eaton autoshift transmissions. The engines can stall because of software problems.
- The risk
- INCREASED STEERING EFFORT CAN OCCUR.
- The fix
- Dealers will update these engines with software changes. Caterpillar is conducting the owner notification and remedy of this recall.
- The problem
- Vehicle description: heavy duty trucks equipped with caterpillar 3406e engines. The routing of the electrical and fuel lines can cause chaffing of the wiring harness on the fuel line.
- The risk
- This chaffing can cause fuel leakage and a potential for a fire in the engine compartment.
- The fix
- Dealers will inspect, adjust, and repair, if necessary, the fuel line and electrical harness.
What owners say
Problems or none - your experience is exactly what the next buyer is looking for. Write it now
3 complaints about the 1998 Kenworth W900
Newest first, as filed with NHTSA by owners.
Reference voq#10259426. I filed a complaint in february 2009 for a frame rail that cracked on my 1998 kenworth w900. I spent $11,470 to have the rail replaced at an authorized kenworth dealer. I purchased this truck new, with no extras or add-ons since owning the truck. All servicing has been done at authorized kenworth repair facilities and I have kept up with all dot/cvsa inspections; this truck has been well maintained. In december 2010, I experienced another frame rail crack in approximately the same location...
Read the full complaint
as the first, behind the rear shackle of the front spring. This time the engine shifted and forced the fan into the radiator. The truck was taken to a local frame shop where the rail was replaced again. The tech there said he had just done another rail on a peterbuilt of the same vintage and felt this should not have happened so quickly on my truck, plus being a safety issue as well. I believe this could be an issue with other kenworth/peterbuilt tractors. Updated 03/09/12 *bf *tr
Tl*the contact owns a 1998 kenworth w900. While driving at an unknown speed, the contact noticed that the hood was knocking on the main cab and was not aligned properly. The vehicle was driven to a local repair shop and the mechanic stated that the chassis was cracked and defective. The manufacturer stated that they were not liable for the repairs. The vehicle was repaired. The current and failure mileages were 158,117. Updated 3/16/09 *cn updated 03/19/09. *Jb updated 05/03/12. *Jb
While driving the fuel line chafed a hole, causing fuel leakage. A recall was ordered on make model and year. This particular truck was not included under recall 98v-129000. The dealer has been notified. *Ak
Kenworth W900: every year compared
All W900 years1998 Kenworth W900 vs rivals
| Vehicle | Complaints | Recalls | Grade | |
|---|---|---|---|---|
| 1998 Kenworth W900 | 3 | 6 | C | |
| 1998 Kenworth T2000 | 3 | 4 | C | Compare |
| 1998 Kenworth T800 | 1 | 8 | C | Compare |
| 1998 Kenworth Kenworth | 1 | 0 | A | Compare |
More sales usually means more complaints, so compare similar vehicles of the same year. The grade compares each vehicle with its own model's other years.
Questions about the 1998 Kenworth W900
Does the 1998 Kenworth W900 have any recalls?
Yes - NHTSA lists 6 recalls for the 1998 Kenworth W900: hub (April 2003); rear (February 2002); labels (April 2001); lower arm (February 2001) and more. Recall repairs are free at any authorized dealer. Enter your VIN at nhtsa.gov/recalls to see whether yours has been fixed.
What are the most common problems with the 1998 Kenworth W900?
By the complaints owners filed with NHTSA, the most common problem areas are the body, doors & structure (2), electrical system (1), fuel system (1).
How many complaints has the 1998 Kenworth W900 had?
3 complaints have been filed with NHTSA, the first on September 8, 1998 and the latest on February 16, 2012. Of these, 0 describe a crash and 0 a fire, and together they report 0 injuries and 0 deaths.
Is the 1998 Kenworth W900 a reliable vehicle?
Its Safety Index is 59 out of 100 (grade C: about as many problems as a typical Kenworth W900 year, for its age). The index weighs complaints, crashes, fires, injuries, deaths and recalls against how long the vehicle has been on the road, compared with the same model's other years. It is not a measure of every repair - read the complaints and owner experiences, and have any used vehicle inspected before you buy.
Which Kenworth W900 years have the most complaints?
2000 (7), 1998 (3), 1999 (3). See every Kenworth W900 year compared.
What should I do if my 1998 Kenworth W900 has a problem?
If it is a safety problem, stop driving it if it is unsafe and contact your dealer. Report it to NHTSA at nhtsa.gov/report-a-safety-problem - enough reports start investigations and recalls - and share your experience here so other owners know what to look for.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data