Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Vehicle safety record

1998 Kenworth T800 Problems, complaints & recalls

Owners have filed 1 complaint about the 1998 Kenworth T800 with NHTSA, most often about the brakes (1). It is covered by 8 recalls, the latest in July 2003 for the vehicle speed control. For comparison, the 1997 has 1 and the 1999 has 4.

NHTSA data checked

CAbout as many problems as a typical T800 year, for its age

#368 most complained-about 1998 vehicle

Complaints
1
Recalls
8
Crashes
0
Fires
0
Injuries
0
Deaths
0

Most common 1998 Kenworth T800 problems

Share of all 1 complaints. One complaint can name more than one area. Tap an area for its complaints and recalls.

1998 Kenworth T800 recalls 8

Recall repairs are free. Your dealer fixes them whether or not you bought the car there - check your VIN at nhtsa.gov/recalls to see if yours is done. What to do

Vehicle speed control

03V24500018 vehicles affected

The problem
On certain vehicles equipped with cummins electronic control modules on the c8.3G and l10g engines, the ecm does not have the ability to detect a throttle fail-safe engine shutdown command. This could result in an unanticipated, uncommanded open throttle condition without warning.
The risk
If this event occurs, the vehicle operator will not have control of the engine speed, possibly resulting in a vehicle crash.
The fix
Cummins will notify the customers and replace the ecm. Owners should contact cummins at 1-800-343-7357 or kenworth at 1-425-828-5440.

Suspension: hub

03V125000154 vehicles affected

The problem
On certain trucks equipped with truck hub units manufactured by skf exclusively for use on arvinmeritor's ff98x series non-drive steer axles, the hub unit bearings can wear prematurely.
The risk
Seizure of the bearings can cause wheel separation or wheel end fire.
The fix
Dealers will replace all front axle hubs. Notification began july 16, 2003. The manufacturer has advised us that parts will not be available until september 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy with a reasonable time should contact peterbilt at 940-591-4201 or kenworth 425-828-5440.

Service brakes

03V12600045 vehicles affected

The problem
Certain trucks equipped with meritor p 18x7 brakes with 36" brake chambers fail to comply with the requirements of federal motor vehicle safety standard (fmvss) no. 121, "Air brake systems." These trucks were manufactured with a combined air reservoir volume less than 12 times the combined volume of all service brake chambers.
The risk
This does not meet the requirements of the standard.
The fix
Dealers will add an additional tank or change one of the existing air tanks to a larger size. Owner notification began on may 5, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1-425-828-5440.

Suspension: rear

02V061001116 vehicles affected

The problem
On certain heavy duty trucks equipped with replacement dana spicer tandem drive axle models ds463 and ds521, installed on vehicles from may 1, 2001 through february 1, 2002, an undersized attachment weld may fracture without warning.
The risk
The loss of this attachment to the vehicle chassis can adversely affect vehicle handling or driver control.
The fix
Dana is conducting the owner notification and remedy for this campaign. The dealers will remove the suspect bracket, inspect the axle housing, and reweld the bracket to the axle housing. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact dana at 616-567-1088 or kenworth at 425-828-5440.

Equipment: labels

01V14200014 vehicles affected

The problem
Vehicle description: heavy duty trucks equipped with meritor fg941 steer axles. The gross axle weight rating (gawr) was determined incorrectly and over-stated on the vehicle certification label. With the incorrect gawr listed, these labels do not meet the certification requirements of part 567, "requirements for manufacturers of motor vehicles." Vehicles will be remedied either by assigning the proper weight rating or, if possible, by changing the necessary components to meet the currently assigned weight rating.
The risk
These vehicles would not be in compliance with federal regulations.
The fix
Vehicles will be remedied either by assigning the proper weight rating or, if possible, by changing the necessary components to meet the currently assigned weight rating. Owner notification began june 22, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1-425-828-5000.

Suspension: lower arm

01V051000209 vehicles affected

The problem
Vehicle description: vehicles equipped with 54" rear axle spacing configuration of the airglide 200 suspension with the service application identified as logger, dump truck, or tanker. The rear suspension is regularly subjected to extreme articulation, resulting in flexing of the joint.
The risk
Failure of the lower sway arm attaching bolts could result in loss of vehicle control.
The fix
Dealers will replace the lower sway arm brackets. Owner notification began march 27, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1-425-828-5000.

Electrical system: module

99V181001272 vehicles affected

The problem
Vehicle description: heavy duty trucks equipped with caterpillar engines and eaton autoshift transmissions. The engines can stall because of software problems.
The risk
INCREASED STEERING EFFORT CAN OCCUR.
The fix
Dealers will update these engines with software changes. Caterpillar is conducting the owner notification and remedy of this recall.

Electrical system: front underhood

98V1290009,500 vehicles affected

The problem
Vehicle description: heavy duty trucks equipped with caterpillar 3406e engines. The routing of the electrical and fuel lines can cause chaffing of the wiring harness on the fuel line.
The risk
This chaffing can cause fuel leakage and a potential for a fire in the engine compartment.
The fix
Dealers will inspect, adjust, and repair, if necessary, the fuel line and electrical harness.

What owners say

Be the first T800 owner to share.

Problems or none - your experience is exactly what the next buyer is looking for. Write it now

1 complaints about the 1998 Kenworth T800

Newest first, as filed with NHTSA by owners.

Brakes

Abs light comes on intermittently, abs capability intermittently. *Ak

Filed Incident Service brakes, airNHTSA 880371

Kenworth T800: every year compared

YearComplaintsRecallsCrashesFiresTop problemGrade
20020600-B
200111000BrakesC
200011000Electrical systemC
199941200SuspensionD
19981800BrakesC
19971900Engine & coolingC
19961810-C
19952520SteeringB
19942300BrakesA
All T800 years

1998 Kenworth T800 vs rivals

VehicleComplaintsRecallsCrashesGrade
1998 Kenworth T800180C
1998 Kenworth W900360CCompare
1998 Kenworth T2000340CCompare
1998 Kenworth Kenworth100ACompare

More sales usually means more complaints, so compare similar vehicles of the same year. The grade compares each vehicle with its own model's other years.

Own a 1998 Kenworth T800? Share your experience.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Questions about the 1998 Kenworth T800

Does the 1998 Kenworth T800 have any recalls?

Yes - NHTSA lists 8 recalls for the 1998 Kenworth T800: vehicle speed control (July 2003); hub (April 2003); service brakes, air (March 2003); rear (February 2002) and more. Recall repairs are free at any authorized dealer. Enter your VIN at nhtsa.gov/recalls to see whether yours has been fixed.

What are the most common problems with the 1998 Kenworth T800?

By the complaints owners filed with NHTSA, the most common problem areas are the brakes (1).

How many complaints has the 1998 Kenworth T800 had?

1 complaints have been filed with NHTSA, the first on February 12, 2001 and the latest on February 12, 2001. Of these, 0 describe a crash and 0 a fire, and together they report 0 injuries and 0 deaths.

Is the 1998 Kenworth T800 a reliable vehicle?

Its Safety Index is 57 out of 100 (grade C: about as many problems as a typical Kenworth T800 year, for its age). The index weighs complaints, crashes, fires, injuries, deaths and recalls against how long the vehicle has been on the road, compared with the same model's other years. It is not a measure of every repair - read the complaints and owner experiences, and have any used vehicle inspected before you buy.

Which Kenworth T800 years have the most complaints?
What should I do if my 1998 Kenworth T800 has a problem?

If it is a safety problem, stop driving it if it is unsafe and contact your dealer. Report it to NHTSA at nhtsa.gov/report-a-safety-problem - enough reports start investigations and recalls - and share your experience here so other owners know what to look for.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience