Brand new travel trailer delivered from the factory with damaged brake electrical connector to the ABS Module. This resulted in an immediate and total loss of trailer braking capability while towing the vehicle, creating an extreme safety hazard and increased stopping distances on public roads. I was able to reach my destination with extreme caution and upon investigation I found the clip that's supposed to keep the connector securely in place, completely severed and the entire harness loose and disconnected.
Brakes
Keystone Cougar Brake problems by year
10 complaints filed with NHTSA about the Keystone Cougar's brakes. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
Brake complaints by model year
Latest Cougar brake complaints
Vehicle was taken to the RV dealer to have annual maintenance done. During inspection it was discovered that 3 of 4 brakes were covered with grease from blown bearing seals. The vehicle has less than 3,000 miles and if not addressed could have resulted in an accident due to inability to stop the trailer using the designed braking systems. The supplier of the axles and brake systems was contacted and they informed us the seals are only warranted for 1 year. Seal failures are very common on RV's and need to be addressed to provide a design which will not fail prematurely (Less than 1 trip across the country). There are no warning indicators or messages indicating brake failure.
Tl* the contact owns a 2019 keystone cougar. While driving and making a right turn, the emergency brake release cable separated and became caught underneath the towing vehicle. As a result, the vehicle straightened up and the trailer brakes seized, which resulted in the trailer being dragged for approximately four miles. The contact was alerted by another motorist about the trailer being dragged and that the wheels on the trailer were smoking. The contact turned the vehicle around and drove back home. Contact...
Read the full complaint
noticed and smelled burning brakes. The contact inspected the trailer brakes and found that the brake release cable had detached and caused the failure. Consumer returned to cab of truck to inspect brake controller settings, which was not the problem. Decide to move vehicle and trailer nacho pavement to see if the brakes had released, drove around the block when realized they had not, pulled trailer into back yard to drop, walked toward nose of trailer and noticed breakaway cable disengaged from the trailer at the switch. Opened tailgate and found entire cable, truck end attached at hitch handle switch interlock end in the bed of the truck and cable pinched under bracket of the glider hitch. Reattached, emptied trailer, called repairman at bogue rv to get his take on possible damage, said he was concerned over the wheel bearings having been destroyed from the heat. Waited again for the brakes to cool, hooked next day, tested for disengagement of brakes after ensuring switch cable was free from catching on tested forward and backward motion without dragging of trailer, then drove trailer 14 miles to rv dealer for inspection and repair.The contact called an unknown dealer and scheduled an appointment. The contact was able to untangle the brake release cable; therefore, the trailer brakes released and the trailer was able to roll freely. The vehicle was currently at the dealer for diagnosis and a repair estimate. The manufacturer stated that the brake release cable was not covered under warranty and promised the contact would receive a call from a supervisor. There was no mileage. *Dt *jb
We have two issues with the fifth wheel camper in question. We only felt it neccesary to contact the nhtsa because the manufacturer refused to remedy the obvious problem when we were at an authorized service center and asked them to in the interest of our safety and that of other motorists. The fifth wheel came with the wrong size wheel and tire with three being larger tires on 16' rims and one being a smaller tire on a 15' rim. It caused the unit which is a 40' long fifth wheel. A new unit from the dealer. When we...
Read the full complaint
realized what was going on we stopped at the nearest authorized service center. Keystone refused to do anything about the issue at the time leaving us in another state on the side of the road not knowing what to do. Our dealer told us this is common.
From the time I left the dealer lot, I never had brakes that worked properly. Increasing the output from the brake controller didn't help. The brakes would over heat and never felt that I had enough brake to stop the trailer/truck. Had the brakes checked by several rv dealers which led to an adjust only. Recent trip caused "hot" brakes/wheels and brake smell. Went to a facility that specializes in rv repair and told them to tear the system apart and fix the problem. They found not enough voltage at brakes. ...
Read the full complaint
Further investigation found excessive length and small gage wire installed by manufacturer. Not enough current going to brakes. Keystone installed 14 gage wire and it should have been 12 gage.
The electric brakes have a very flimsy connection behind each brake plate. A very small wire is exposed to the elements. In our case, something broke the wire and the brakes failed. Keystone had their dealer repair the wire to its original flimsy state. A few months ago the trailer brakes were irratic (unreliable). I took the trailer to repair facility. In searching for the problem, they discovered that the rubber gasket on all four inner grease seals were severely damaged because they were undersized. If...
Read the full complaint
the grease isn't contained in the bearings, eventually the wheels will fall off. Pictures are attached. The heat in the interior lights has always been of concern. Pictures of a partially melted light bulb and lenses are attached. Various articles say glass will melt at 900f isn't a 900f a fire hazard. I replaced the bulbs with led's which was a simple process. I wrote to the president of keystone. He said the director of owner relations call me; she the conditions I reported were normal and that keystone wouldn't participate in fixing these issues nor reimburse me for fixing these problems.
I purchased a new travel trailer manufactured by keystone in may of 2015. I took it back to the dealer after my first trip when I realized the brakes barely functioned. After 4 months of trying to get the manufacture to acknowledge the brakes did not work from the factory keystone stated that they felt the brakes functioned properly. The dealer, rcd sales agreed with me that the brakes did not work and they had a second 2016 trailer on their lot which the brakes did not function either and they were scared to sale...
Read the full complaint
it. I reviewed the brakes myself they weekend and discovered that the wiring used by the manufacture was too small. There was nearly a 3 volt (25%) voltage drop from the wiring harness to the brake drums. After replacing what appeared to be 16 gauge wire with 12 gauge wire the brakes now work properly. Keystone however is still manufacturing trailers with inadequate braking caused by undersized wiring and insisting they are safe.
The electric brake wiring that connects the coach body to the front axle was rubbing on the inside sidewall of the lf tire of the trailer. It has rubbed a polished groove in the sidewall of the tire. The wiring connecting the rear axle to the coach was rubbing on the interior surface of the lr wheel. I secured the wiring away from the tire and wheel and returned the fifth wheel to the dealer where I purchased it. Keystone rv's attitude surprises me, they claim that the wire couldn't have been rubbing on the...
Read the full complaint
tire and wheel, because the wire would have been instantly ripped off. I have pictures to prove the wiring job was inadequate and shoddy. This issue can't be an isolated incident. I feel that keystone needs to have it's dealers inspect all trailer brake wiring. If the wires had been torn loose or shorted out, my 9,000 pound fifth wheel would have become a giant weight pushing me down hills! This is a clear safety issue. Please let me know if you want my pictures forwarded to you. Thank you! *Tr updated 09/26/12*lj
Tl*the contact owns a 2008 keystone cougar fifth wheel. While driving 55 mph, the two passenger side tires blew out. The contact believes that the weight of the fifth wheel caused the tires to fail. He stated that the manufacturer put cheap wheels on the vehicle in order to save money. The failure mileage was not applicable. Updated 08/31/09 *bf the brakes on the rv were extremely loud everytime they were applied. Updated 09/09/09. Jb
Tl*the contact owns a 2008 keystone cougar. While driving at an unknown speed, the brakes failed. The contact examined the vehicle and noticed that the brake wire was pinched by the dump valve shafts. The dealer stated that the brake wires needed to be replaced and secured. The failure mileage was 10,000.Update 09/10/08 *cw the consumer stated the wires were laying loose and not secured in the area of the dump valves. Updated 09/16/08. *Jb
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data