- The problem
- Mounting of the pitman arm may loosen and lead to excessive wear in either the pitman arm splines or the steering gear shaft splines, or both. This condition is due to incorrect tightening of the mounting screws during assembly.
- The fix
- The dealer will inspect and properly tighten the pitman arm retaining screws.
Steering
1978 Mack RWL Steering problems
No owner has filed a complaint about the 1978 Mack RWL's steering with NHTSA. Loss of power steering, stiff or loose steering, wandering, column and rack problems.
- Complaints
- 0
- Recalls
- 3
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Steering recalls for the 1978 Mack RWL
- The problem
- The pitman arm retaining nut may not have been torqued to manufacturer specifications. This could result in inadequate retention of the nut at the output shaft, allowing the pitman arm to become loose.
- The fix
- Dealer will inspect and retorque pitman arm, if necessary, at no cost to owner.
- The problem
- It has been determined that two screws that are part of the bearing assembly located at the cab dash sheet may not have been tightened properly. As a result, the upper steering shaft may be free to "float" throughout much of its length which may result in inadequate engagement in the slip splines of the lower steering shaft. Axle articulation could result in disengagement of the lower steering shaft slip splines.
- The fix
- Dealer will install a sleeve between the dash sheet bearing and the upper steering shaft lower yoke to assure positive upper steering shaft location.
Steering complaints
No complaints about this area yet.
Mack RWL steering complaints by year
RWL steering problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data