During hard or emergency braking at higher speeds, the Anti-Lock Braking System (ABS) activates and pulsates normally for approximately 1 to 2 seconds, then abruptly fails and stops pumping. Immediately after the ABS cuts out, the wheels lock up completely, causing the vehicle to skid with loss of traction/stability control, reduced steering control, and extended stopping distances. At the exact moment the ABS stops pumping and the wheels lock, the dashboard displays a "Smart Brake System Malfunction" warning...
Read the full complaint
message and illuminates both the ABS warning light and the TCS/DSC (Traction Control / Dynamic Stability Control) indicator light. However, as soon as the braking event ends, all warning lights and the error message turn off automatically on their own without needing to restart the vehicle. Because the fault clears itself immediately during the drive, there is no active warning on the dashboard showing that the ABS, TCS/DSC, and Smart Brake systems are compromised until the next high-speed emergency braking situation occurs. Vehicle diagnostic scans recorded error codes U3003-16-68 (Circuit voltage below threshold), U0316-09-08 (Error signal received from DSC/ABS module), and B13D3-16-8A. The vehicle has been inspected and serviced twice by an authorized Mazda dealership for this exact safety defect: on 8-Sep-2026, the dealership replaced the 12V vehicle battery, and on Oct-5-2026, the dealership replaced the ABS module. Neither repair resolved the issue, and on both occasions the dealership returned the vehicle claiming it was fixed. Testing the brakes confirmed the defect persists: under hard braking, the ABS still cuts out after 1 to 2 seconds, locks the wheels, and momentarily triggers the ABS light, TCS/DSC light, and "Smart Brake System Malfunction" warning before clearing itself again.