Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Acceleration & cruise control

2013 Ram 3500 Acceleration problems

Owners have filed 15 complaints about the 2013 Ram 3500's acceleration & cruise control with NHTSA - 13% of all its complaints, most recently on April 17, 2023. Unintended acceleration, surging, throttle problems and cruise or adaptive cruise faults.

Complaints
15
Recalls
0
Crashes
0
Fires
0
Injuries
0
Deaths
0

Acceleration complaints

SteeringSuspensionAcceleration & cruise control

Truck was repaired June 2019. They welded the jam nut which made it impossible to get an alaignment.Been having a open claim with Chrysler Jeep and Dodge going on 2 years per claim #78469040 Front Suspension Track Bar Frame Bracket ( vehicle recently started to do the death wobble again)

Filed Incident Steering · Suspension · Vehicle speed controlNHTSA 11517380
SteeringSuspensionAcceleration & cruise control

Took truck to Mac Haik here in Houston to perform the recall.The jam nut on drag link was welded,which was not a fix.Went back after being told truck can't be aligned with the drag link being welded.Was told I'd have to pay out of pocket for the weld to be cut,which sense have led to other issues with the front suspension. Attached is docs concerning this matter .....I been having a open claim with Dodge Chrysler and Jeep for over 2 years.Is there any remedy for such a problem?

Filed Incident Steering · Suspension · Vehicle speed controlNHTSA 11504071
Acceleration & cruise control

Tl* the contact owns a 2013 ram 1500. While driving 70 mph, the vehicle began accelerating on its own and would not decelerate even when the brake pedal was depressed. The contact placed the vehicle into neutral, but the engine continued to rev. Eventually, the vehicle began to slow down. When the contact attempted to accelerate, the accelerator pedal traveled to the floorboard and stalled. The failure continued until the contact was able to coast the vehicle into an abandoned parking lot. Cortland chrysler dodge...

Read the full complaint

jeep (3878 west rd, cortland, ny 13045, (607) 218-7520) was contacted and stated that the failure also occurred on other vehicles and that the engine control module needed to be updated. The contact was able to drive the vehicle home without incident. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 21,000. *Dt*jb

Filed Incident Vehicle speed controlNHTSA 11232748
Acceleration & cruise control

Tl* the contact owns a 2013 ram 3500. While accelerating from a stop, the accelerator pedal traveled to the floorboard independently and the service throttle warning indicator illuminated. The driver managed to depress the brake pedal to stop the vehicle approximately one mile later. While the vehicle was idling, the driver waited for the failure codes to clear before driving home. The contact called diehl chrysler dodge jeep ram of salem (located at 400 legacy ln, salem, oh 44460, (330) 337-3475) and was advised...

Read the full complaint

to have the vehicle towed to their facility. The manufacturer was notified of the failure and provided case number: 57569312. The approximate failure mileage was 52,393. *Dt*jb *dt*jb

Filed Incident Vehicle speed controlNHTSA 11155975
Transmission & drivetrainAcceleration & cruise controlEngine & cooling

My ram truck went into a malfunction and limited the speed to 5 miles per hour causing a major highway safety issue. The truck put all passengers and operators in danger. The def system in this vehicle can only be reset by a ram dealer which causes other issues besides extreme dangers driving conditions.

Filed Incident Power train · Vehicle speed control · EngineNHTSA 11012070
Electrical systemAcceleration & cruise controlFuel system

The new dodge ram equipped with cummins diesel experience a dead pedal, or pedal delay when pressing the gas pedal 3/4 to full throttle. This poses a serious risk when needing to get out of the way, or move the vehicle under emergency circumstances. This happens under all conditions: stopped, rolling, under acceleration etc. If you push the pedal too far the truck will not respond to operator commands and will take 1.5-2 Seconds to start picking up speed. This is a seriously dangerous situation and someone is...

Read the full complaint

going to get killed or seriously injured. There is not excuse for a vehicle not responding to driver input. Manufacture claims "turbo lag", this is simply not true. You can build turbo boost, monitored on the vehicle gauge, then press the pedal to the floor, the truck will not respond for 1.5 To 2 seconds. Please look at further information on the cummins forum below, it has numerous articles about this issue. Here as a link to just one of them. Http://www.Cumminsforum.Com/forum/2013-general-discussion/1836593-very-slow-throttle-response.Html please, help fix this issue before someone gets hurt or killed due to the inability to move the vehicle out of harms way. This tsb somewhat addresses the problem, but only fixes it partially, not to the point that it is safe. Tsb 18-041-15 I believe the manufacture knows this is an issue, but is not fixing it due to emissions related programming on the vehicle. There are aftermarket solutions to this problem, however they void the manufacture warranty, and im not willing to lose my warranty on a new vehicle. I will be submitting another one of these for my 2015 as well, since they both have the same issue. Thank you. *Tr

Filed Incident Electrical system · Vehicle speed control · Fuel / propulsion systemNHTSA 10806538
SteeringAcceleration & cruise controlBrakes

Serpentine belt broke from supposed "wear" at 37k miles with such force that it broke the fan and radiator on a 2013 3500 ram hd truck, rendering the truck's steering, brakes, etc., Useless, if on mountain/curvy road extremely dangerous; this vehicle was on interstate highway and difficult to get from left lane to right median. Would have been impossible to correct if in curve. Truck is still in for repairs at dealership 12 days later. No invoice received; amount due $1500+

Filed Incident Steering · Vehicle speed control · Service brakesNHTSA 10779149
Acceleration & cruise control

2013 Dodge ram 3500. Attorney representing consumer writes in regards to vehicle throttle issues. *Smd while driving, the throttle became stuck and caused the vehicle to increase in speed. An inspection was performed by the dealer, where the onboard computer showed the throttle usage was 80& and the brake was 79% at the time of the incident. The dealer informed the consumer there was nothing they could do, since the issue was not on the bulletin board as an issue to be addressed. *Jb

Filed Incident Vehicle speed controlNHTSA 10679166
Transmission & drivetrainAcceleration & cruise controlFuel system

Randomly, while attempting to avoid hazards and/or collisions and while merging onto motorway, gas pedal becomes unresponsive for up to 5 seconds. This usually happens from a dead stop; however, has occurred while traveling at highway speeds also. *Tr

Filed Incident Power train · Vehicle speed control · Fuel / propulsion systemNHTSA 10638287
Acceleration & cruise control

There is an extreme hesitation between the time the throttle pedal is applied to when the vehicle begins moving. This issues seems to be most noticeable when the throttle petal is pressed slowly and also when the throttle pedal is pressed hard, released, and pressed again. I have had many close calls when merging into traffic or when turning at intersections. *Tr

Filed Incident Vehicle speed controlNHTSA 10638034
Acceleration & cruise controlFuel system

My truck has been plagued with a terrible delay in throttle response. When trying to merge into traffic there is a severe delay between imputing throttle and the truck actually accelerating. It's almost like the truck takes 3-6 seconds to realize throttle input. This has become very dangerous when attempting to merge or turn across traffic. I have taken my truck into the dealership but there is nothing available to rectify this. I am clearly not alone on this, many of us having been having lengthy discussions on the forums in hopes of a fix. *Tr

Filed Incident Vehicle speed control · Fuel / propulsion systemNHTSA 10627800
Acceleration & cruise controlEngine & cooling

Stepped on accelerator pedal, backed off and stepped back down on pedal. Truck did not respond. Very dangerous when pulling out in front of oncoming cars. This is an ongoing condition, happens all the time if I push on the pedal too hard, the truck takes several seconds to respond. *Tr

Filed Incident Vehicle speed control · EngineNHTSA 10627675
Electrical systemAcceleration & cruise controlEngine & coolingFuel system

When letting off the gas pedal and then pressing again, (like merging or a rolling stop) there is a lag of 1-2 seconds. Very dangerous when pulling out in traffic. Ram says that is normal. This need to be investigated. Thanks *tr

Filed Incident Electrical system · Vehicle speed control · Engine · Fuel / propulsion systemNHTSA 10610607
Transmission & drivetrainAcceleration & cruise controlFuel system

Tl* the contact owns a 2013 dodge ram 3500. The contact stated that the odor of diesel fuel was present inside the vehicle. The contact indicated that the odor was present when the weather temperature was below 50 degrees. The vehicle was taken to the dealer, who could not diagnose the defect. The contact also indicated that while driving and releasing the throttle, the vehicle would continue to accelerate. The vehicle was not diagnosed or repaired. Additionally, the transmission became stuck in 4th gear and the...

Read the full complaint

vehicle would not accelerate over 5 mph. The vehicle was taken to the dealer but he was unable to diagnose the failure. The manufacturer was made aware of all failures. The failure mileage was 6000.

Filed Incident Power train · Vehicle speed control · Fuel / propulsion systemNHTSA 10585366
Acceleration & cruise control

Tl* the contact owns a 2013 dodge ram 350. The contact stated that while driving approximately 34 mph, the vehicle accelerated independently with the throttle warning light illuminated. The vehicle was taken to the dealer, who indicated that the throttle modules were out of sync. The vehicle was not repaired. The manufacturer was notified of the problem. The approximate failure mileage was 9,000.

Filed Incident Vehicle speed controlNHTSA 10575229

Ram 3500 acceleration complaints by year

3500 acceleration problems, every year

Had a acceleration problem with your 2013 3500? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience