Certain commercial chassis built with gasoline fuel tanks fail to conform to the requirements of federal motor vehicle safety standard no. 301, "Fuel system integrity." Fuel spillage during a rollover test exceeded 142g, which does not comply with the...
Updated daily from NHTSA
Latest vehicle recalls
38 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
Certain motor homes fail to conform to the requirements of federal motor vehicle safety standard no. 108, "Lamps, reflective devices, and associated equipment." The side marker lights in the combination headlight and tail light assemblies do not meet the...
On certain transit buses, the hydraulic hose located in the engine compartment was manufactured incorrectly which could cause a hydraulic fluid leak.
On certain trucks built with dana rear axles, the housings may contain thinner material than what is necessary for normal vehicle operation.
On certain motorcycles, the lower fork yoke could fail. A crack can form around the lower fork bearing.
On certain motorcycles, a fuel pump hose may swell and change dimensions, thereby loosening its fit around the fitting at the fuel pump. The fuel pressure could drop.
On certain fifth wheel trailers and motor homes equipped with atwood sealed burner ranges, the range and slide-in burner tubes leading from the gas manifold to the burner heads had a depression or 'kink' in the exterior bend restricting proper airflow and gas...
On certain fifth wheel trailers equipped with hickory springs "big easy triple steps," an improper engagement of the bottom step pivot arm with the formed stop edge of the middle step support bracket can result in the bottom step rotating to an unsafe...
During production, a select number of vehicles underwent an offline inspection at the assembly plant where a bolt in the front suspension assembly was removed. On some of these vehicles, it is possible that this bolt may not have been tightened to...
On certain trucks, the side window air bag module diffuser material may contain hairline cracks.
Certain travel and fifth wheel trailers have incorrect information on the federal identification tag and the tire and loading information label.
On certain motorcycles, the spring retaining pin on the frame may not have been completely welded in place and could fall out, allowing the sidestand to drop into the "parking" position.
Certain my 2006 and 2007 freightliner fs-65 school and shuttle bus chassis equipped with caterpillar c7 engines and hydraulic brake line p/no a12-21572-000. The front brake lines may have been improperly secured allowing the brake line to contact the engine...
Certain my 1996 thru 2004 re commercial and school buses equipped with international t444e v-8 diesel engines manufactured between january 3, 1996, and march 22, 2004. Hose assemblies that supply high pressure oil to the engine's cylinder heads may...
On certain motorcycles, during use the chain slider guard mounting bolts may become loose and possibly fall out. This could result in the possibility of the chain slider guard to become detached.
On certain trucks, the diesel engine/generator unit can be started remotely by a person in the truck cab while its protective cover is removed; and under certain conditions the engine may re-start after the emergency fuel cutoff is used to shut down the unit.
On certain passenger vehicles, the fuel pressure sensor located on the left end of the fuel rail may, at times, transmit incorrect signal regarding the fuel pressure to the engine control module. If the signal is outside of the pre-programmed allowable...
Certain motor homes fail to comply with the requirements of federal motor vehicle safety standard (fmvss) no. 108, "Lamps, reflective devices, and associated equipment." These motor homes were equipped with more than three amber identification lamps located...
Certain motor homes equipped with a two-door refrigerator, manufactured by the dometic corporation, may have a defect in the boiler tube. Pressurized coolant solution could be released into an area where an ignition source (gas flame) is present.
On certain medium duty trucks, the brake vacuum hose may have been manufactured with insufficient wall thickness allowing the hose to collapse during normal vehicle operation.