On certain trucks, the removable tow hitch ,when used to tow or lift a vehicle, can fail due to defective material in the tow hitch.
Updated daily from NHTSA
Latest vehicle recalls
38 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
Certain fifth wheel trailers built with 16" steel wheels may leak at the valve stem during inflation or when checking the air pressure due to improper seating of the valve stem. Some models have aluminum wheels with a steel spare and only the spare is...
Certain vehicles fail to conform to the requirements of federal motor vehicle safety standard no. 138, "Tire pressure monitoring systems." The owner's manual is missing the tire pressure monitoring system (tpms) written instructions.
Certain vehicles equipped with 2.5L gasoline engines may have a small plastic tab located on the windshield washer fluid reservoir that may chafe against the underhood fuel supply line.
Certain blue bird my 2004 through 2007 vision school and transit buses manufactured between october 9, 2003, and september 21, 2006, equipped with parker single check vavles (scv) provided by bendix. The defect exists in the parker scv that connects with the...
Certain dura side body egress windows, side body lavatory egress windows, and non-egress side body windows manufactured between november 1, 2005, and july 19, 2006, installed as original equipment on certain my 2006 and 2007 motor coach industries (mci) d...
On certain vehicles, if a sufficiently hot object enters the air filter housing through the engine fresh air intake system and contacts the engine air filter, the flammability characteristics of the air filter material are such that the filter may ignite.
Certain motor homes fail to comply with the requirements of federal motor vehicle safety standard no. 108, "Lamps, reflective devices, and associated equipment." The side marker lights in the combination headlight and tail light assemblies do not meet the...
Certain recreational vehicles equipped with a two-door refrigerator, manufactured by the dometic corporation, may have a defect in the boiler tube. Pressurized coolant solution could be released into an area where an ignition source (gas flame) is present.
Certain travel and fifth wheel trailers were built with incorrectly sized wheels. The incorrect wider rim does not allow proper clearance between the shock absorber, shock brackets, and the tire.
On certain trucks, grease was applied to the front wheel bearings, but may not have enough in the cap or cavity in the hubs.
Certain my 2005-2007 thomas built saf-t-liner c2 school buses manufactured between december 1, 2003, and october 10, 2006. Fasteners used to secure the fuel tube mounting bracket to the bus floor may be missing or improperly installed. Vehicles with missing...
Certain pickup trucks equipped with 34 gallon fuel tanks fail to comply with the requirements of federal motor vehicle safety standard no. 301, "Fuel system integrity." The fuel tank may become damaged during certain crash conditions, which could allow fuel...
Certain vehicles fail to conform to the requirements of federal motor vehicle safety standard no. 212, "Windshield mounting." An incorrect primer may have been used when installing the windshield. The same primer may have also been applied to the liftgate...
On certain passenger vehicles, the front seat track position sensors utilized for the air bag system may not function properly.
On certain motor homes built with cummins isl cm850 diesel engines, the connecting rod contains a machining defect in the wrist pin bushing of the rod that could cause a seizure of the piston pin.
On certain vehicles, corrosion may occur in the inner steel portions of the active body control's (abc) high pressure distribution hose due to extensive exposure to humidity causing deterioration of the hose.
On certain transit buses, the u-joint assemblies have inadequate spline engagement on one of the two end yokes.
On certain motorcycles, the top mount for the single rear shock is spot welded in position during frame manufacture, then is supposed to be completely welded to the frame in a subsequent operation. In a small number of frames, it appears this subsequent...
On certain transit buses built with cummins ism c876 engines, the electronic control module fails to recognize inputs of the vehicle electronic control unit or from a driver actuated dash switch thereby increasing the risk of unintended (or unexpected)...