Latest vehicle recalls

Vehicle description: passenger vehicles equipped with the sas sensor unit. These vehicles can experience air bag deployments in minor undercarriage impacts.

Vehicle description: navistar models 4700 and 4900 street sweepers equipped with dualized steering and vehicle cruise control. Improper wiring near the vehicle steering wheels will cause the cruise control to stay engaged after depressing the foot brake...

Vehicle description: heavy duty trucks equipped with haldex manifold dash valves (mdv) used in tractor and trailer parking brakes. These valves do not meet the requirements of fmvss no. 121, "Air brake systems." A loss of the isolation of the two brake...

Vehicle description: school buses equipped with mechanical b5.9 Front diesel engine school buses manufactured from june 26, 1995 through march 18, 1998. Due to the accelerator cable engine mount bracket having an incorrect bend angle, the accelerator cable...

Vehicle description: passenger vehicles. The brake reservoir label was omitted. This does not comply with the requirements of fmvss no. 135, "Passenger car brake systems."

Vehicle description: passenger vehicles. An incorrect label was installed on the driver side rear door. This label contains instructions for the activation of the childproof safety locks.

Vehicle description: heavy duty trucks. The tie rod ends can fracture due to low stress, high cycle, reversed bending fatigue resulting from a system resonance.

Vehicle description: motorcycles equipped with a rear wheel hub spindle. Internal cracks may be present on the rear wheel spindle.

Vehicle description: minivans and light duty trucks. The tail light socket may have been improperly molded, resulting in the locking tab having insufficient force to retain the bulb.

Vehicle description: passenger vehicles. The headlight wire that runs through the turn signal lever can fail at the point where it is soldered to the headlight switch.

Vehicle description: passenger vehicles. The right front brake hose is incorrectly routed behind the brake pipe bracket restricting brake hose movement that could cause the hose to either be cut by the bracket or separated at the caliper.

Vehicle description: passenger vehicles. These vehicles do not conform to the requirements of fmvss no. 108, "Lamps, reflective devices, and associated equipment." The vertical head lamp adjusting device may not be calibrated properly.

Vehicle description: passenger vehicles. These vehicles do not conform to the requirements of fmvss no. 108, "Lamps, reflective devices, and associated equipment." The head lamp adjustment device horizontal adjuster may not move the head lamp reflector...

Vehicle description: passenger vehicles. The windshield wipers may stop working due to a separation between the drive pin and crescent in the crank arm assembly.

Vehicle description: minivans. The front body/frame is missing spot welds.

Vehicle description: heavy duty trucks. The brake pedal pivot pin retainers may not have been properly installed.

Vehicle description: heavy duty trucks. There is interference between the air brake s-cam and the end of one of the knuckle studs. As the brake shoe lining wears, the s-cam rotation may be limited by the interfering knuckle stud. If the s-cam can not...

Vehicle description: heavy duty trucks. The check valves in the air brake system on these vehicles do not meet the requirements of fmvss no. 121, "Air brake systems."

Vehicle description: passenger and multi-purpose vehicles originally sold or currently registered in the states of connecticut, illinois, indiana, maine, maryland, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode...

Vehicle description: minivans. The tail light socket may have been improperly molded, resulting in the locking tab having insufficient force to retain the bulb.