Latest vehicle recalls

Vehicle description: heavy duty trucks equipped with dual steering. Interference between the cab floor and the brake pedal can occur on the right hand side of the dual steer vehicle.

Vehicle description: heavy duty trucks equipped with brake valves manufactured by honeywell bendix. The orientation and location of the brake valve is such that water can get into the valve through a vent in the valve. The water will contaminate the air...

Vehicle description: certain heavy duty trucks fail to comply with requirements of fmvss no. 108, "Lamps, reflective devices, and associated equipment." The headlamp assemblies have the bulb identification for the low and high beam reversed on the front...

Vehicle description: mini vans. These vehicles may have been built with incorrect urethane, resulting in an adhesive bond rather than the intended molecular bond for the front windshield and rear liftgate glass.

Vehicle description: semi-trailers. These semi-trailers are equipped with suspension bogies that can slide forward and aft to change the axle positions. The bogies slide along a pair of body rails that are welded directly to the bottom flange of the...

Vehicle description: heavy duty class 8 trucks equipped with fontaine fifth wheel assemblies. The fifth wheel mounting plates can crack.

Vehicle description: limousines. During normal engine roll, the plastic end fitting of the cruise control cable could contact the brake master cylinder and fracture. This does not meet the requirements of fmvss no. 124, "Accelerator control systems."

Vehicle description: heavy duty trucks. The antilock traction relay valves were incorrectly assembled by the supplier. An extra check valve was installed which will not allow the traction control system to function properly.

Vehicle description: heavy duty class 8 trucks equipped with fontaine fifth wheel assemblies, models sl5wms6125, sl5wms7125, sl5wms8125, sl5wms9125, sl5wms10125, sl5apm6125, sl5apm7125, slapm8125, sl5apm9125, sl5apm10125, sl5wms-d, sl5apm-d, and sl5bps-d...

Vehicle description: sport utility vehicles. Insufficient strength of the mounting base on the upper end of the front struts can lead to breakage of the mounting bolts that attach the upper end of the front struts to the vehicle body.

Vehicle description: heavy duty trucks. There is an interference between the throttle pedal and the brake pedal.

Vehicle description: light duty trucks. The tail light socket may have been improperly molded, resulting in the locking tab having insufficient force to retain the bulb.

Vehicle description: rv chassis. If the front wheels are turned when the air suspension is exhausted, the brake chamber mounting bracket could be damaged due to an interference.

Vehicle description: heavy duty trucks. A heat shield between an abs (anti lock brake system) modulating valve and a muffler was omitted.

Vehicle description: heavy duty trucks equipped with a steel fuel tank. The closure only fuel tank cap, installed on the steel fuel tank, failed when the tank was dropped from a 10' height as required by fmvss no. 393, "Liquid fuel tanks."

Vehicle description: passenger vehicles. The welds securing the front damper lower mounting bracket could be inadequate resulting in separation of the bracket.

Vehicle description: sport utility vehicles. The lower steering shaft coupling includes a plastic collar which fits over the lower steering rack input shaft. This collar is pushed down onto the steering rack and tightened during assembly. On some of the...

Vehicle description: passenger vehicles. The motorcycle crankcase design allows the creation of air pockets near the oil pump inlet due to sloshing of the oil in the crankcase. If the oil pump draws air, inadequate lubrication to the engine occurs, causing...

Vehicle description: light duty pickup trucks. The welds at the right side lower control arm bracket to axle tube attachment may have inadequate fatigue life due to poor weld quality. This can lead to separation of the control arm bracket from the axle...

Vehicle description: a potential chafing condition occurs between the flexible brake lines which connect the master cylinder to the abs modulator. This condition can lead to one or both of the brake lines developing a brake fluid leak.