Latest vehicle recalls

Vehicle description: heavy duty trucks equipped with 15" (widths: 4" and 5") air-actuated q-plus cam brake equipped with federal mogul friction products 3030-197 brake lining (meritor r201) brake linings and actuated with type 20 air chambers x 5.5" Slack...

Vehicle description: passenger vehicles equipped with speed control. The speed control cable end fitting can allow water to enter the speed control servo assembly. If this occurs, corrosion in the servo assembly could develop and cause intermittent speed...

Vehicle description: motorcycles. The back torque limiter in the clutch could malfunction and allow the clutch to slip excessively, or not re-engage after a shift.

Vehicle description: passenger vehicles equipped with alloy wheels and sold in puerto rico. These wheels were manufactured without the steel bushing inserts around the wheel bolt openings, allowing friction between the wheel bolt seats and the wheel bolts...

Vehicle description: passenger vehicles. Fuel tank assemblies in these vehicles have an over pressure relief (opr) valve that can become stuck open in a frontal collision. If the vehicle rolls over, fuel spillage could occur.

Vehicle description: passenger and sport utility vehicles. The passenger air bag inflator assembly contains an incorrect inflator charge amount.

Vehicle description: sport utility vehicles. The fuel tank strap can separate due to fatigue during operation. If this occurs, the tank will be unsupported, increasing the risk of a fuel leak.

Vehicle description: sport utility vehicles. The rear brake tube can contact an underbody crossmember eventually wearing a hole in the tube.

Vehicle description: passenger vehicles equipped with alloy wheels. These wheels were manufactured without the steel bushing inserts around the wheel bolt openings, allowing friction between the wheel bolt seats and the wheel bolts. This can result in the...

Vehicle description: heavy duty trucks equipped with 15" (widths: 4" and 5") air-actuated q-plus cam brake equipped with federal mogul friction products 3030-197 brake lining (meritor r201) brake linings and actuated with type 20 air chambers x 5.5" Slack...

Vehicle description: class b motor homes built on dodge 3500 or 2500 van chassis. The generator fuel pickup fitting was self tapped into a drilled hole beside the fuel sending unit on top of the plastic fuel tank. Sealant was used on the thread before the...

Vehicle description: passenger vehicles. Mitsubishi caribbean had replaced the original factory installed mounting bracket bolts of both driver and passenger air bags with aluminum rivets. After air bag deployment, the rivets can loosen or break, causing...

Vehicle description: on certain sport utility vehicles, the hydraulic lift cylinder bracket welds could fracture.

Vehicle description: passenger vehicles equipped with v6 engines and federal emission equipment. The battery cable harness can become heat damaged by the front exhaust manifold which could cause grounded circuits.

Vehicle description: passenger vehicles equipped with v6 engines and federal emission equipment. The battery cable harness can become heat damaged by the front exhaust manifold which could cause grounded circuits.

Vehicle description: school buses. There is a shimmy in the front end of the bus.

Vehicle description: school bus. An air brake line controlling the rear brakes may be too close to the exhaust pipe and could rupture at any time without warning.

Vehicle description: transit buses. The fasteners used to attach parcel racks to body structure may become dislodged allowing the racks to fall without warning.

Vehicle description: motor homes. The electrical conduit was not wrapped with a heat shield allowing the conduit to get too hot and sag.

Vehicle description: passenger vehicles. Corrosion of the electrical ignition filament of the air bag gas generator module can occur if the vehicle is operated in areas of frequently high humidity.