Latest vehicle recalls

Vehicle description: motorcycles. These motorcycles were built with a rear shock absorber front eye that could break.

Vehicle description: motorcycles. These motorcycles were built with a swingarm that could break.

Vehicle description: motorcycles. These motorcycles were built with a fuel tank vent valve assembly that could become plugged.

Vehicle description: motorcycles. These motorcycles were built with a fuel tank mount system that could, in the event of a crash, allow the fuel tank to separate from the motorcycle.

This is not a safety recall in accordance with the safety act. However, it is deemed a safety improvement campaign by the agency. Vehicle description: passenger vehicles. If the convertible top cover is not installed correctly, it can separate...

Vehicle description: passenger vehicles. The terminals at the headlight switch and wiring harness connector can experience heat damage as a result of overheating.

Vehicle description: heavy duty trucks equipped with dana/sprague windshield wiper assemblies. The knurled pivot shaft (which operates the windshield wiper arm) is welded to a lever, which connects to linkage from the wiper motor. The weld at the pivot...

Vehicle description: folding trailers. Improper tire clearance (less than 5/8") between the wheel and front frame cross member can result in the tire rubbing the metal frame.

Vehicle description: passenger vehicles. It is possible that the retaining clip that secures the brake booster pushrod to the brake pedal arm was not properly installed during production. It is possible for the clip to detach from the pin on the brake...

Vehicle description: sport utility vehicles equipped with four-wheel-drive (4x4), 17" chrome steel wheels. The clamp load can be lost on the wheel lugs due to insufficient wheel contact area with the hub. In some cases, the contact area can deform...

Vehicle description: bumper-pull horse trailers. The safety cables, used to maintain a connection between the trailer and tow vehicle, are not equipped with thimbles and thus do not conform to sae j684.

Vehicle description: motorcycles. These motorcycles were built with a sidestand switch that could become inoperative

Vehicle description: motorcycles. The rear brake line can chafe, resulting in loss of brake fluid.

Vehicle description: motorcycles. Motion of the battery cable can lead to breakage of its terminal.

Vehicle description: all wheel drive passenger minivans. (This includes all 1992 awd aerostars not previously included in safety recall 97v-204/97s83). These vehicles can develop powertrain bending resonance or transfer case output shaft bushing...

Vehicle description: sport utility vehicles equipped with 4-wheel drive and automatic transmissions. Automatic transmission fluid could be vented onto the hot exhaust system as a result of unanticipated heat generation in the transmission.

Vehicle description: pickup trucks equipped with 6" beds manufactured from january 5, 1998 through june 4, 1999, do not not fully satisfy the post crash test static rollover requirements of fmvss no. 301, "Fuel system integrity." Contact between the...

Vehicle description: gasoline and diesel engine pickup trucks equipped with 6" and 8" beds manufactured from january 5, 1998 through march 21, 1999, do not not fully satisfy the post crash test static rollover requirements of fmvss no. 301, "Fuel system...

Vehicle description: transit buses and bus shells. Some brake line hoses may have been manufactured using heater hose material instead of brake line hose material. Heater hoses are not appropriate for use as brake lines because the operating pressure of...

Vehicle description: passenger vehicles. These vehicles do not comply with the requirements of fmvss no. 214, "Side door strength." Incorrect position of the side impact pad to the rear, instead of the middle, of the door assembly.