Latest vehicle recalls

Vehicle description: passenger vehicles equipped with 4t65e automatic transmissions. These vehicles fail to conform to the requirements of fmvss no. 102, "Transmission shift lever sequence." A retaining clip, which secures the manual valve to the linkage...

Vehicle description: motorcycles. Chassis wiring harness can come into contact with the rear shock absorber, causing damage to the harness.

Vehicle description: motorcycles. The front isolator mount system can lose clamp load and possibly break.

Vehicle description: heavy duty trucks equipped with alcoa 984650 24.5 X 8.25 Wheels. The affected wheels were improperly heat treated.

Vehicle description: trucks equipped with a driveline parking brake. The fasteners that connect the end of transmission companion flange to the park drum and driveline may loosen.

Vehicle description: motorcycles. Oil can leak from between the crankcase halves.

Vehicle description: passenger vehicles. These vehicles may have been built with incorrect front brake rotor, brake caliper assembly, brake pads, and caliper mounting bracket on either the left or right side of the vehicle.

Vehicle description: bus shells. The height control valve lever attached to the radius rod of the independent front suspension may have been fastened without using lock washers.

Vehicle description: class 8 heavy duty trucks assembled by either volvo gm heavy truck corporation or volvo trucks north america, inc., And with a 2,100 rpm detroit series 60 engine, and a 32 inch, 8 blade kysor engine cooling fan. The blades may separate...

Vehicle description: transit buses. The rear brake release time can exceed the requirements of fmvss no. 121.

Vehicle description: motor homes with basement converters and basement freezers. A grommet may be missing allowing the 110-volt wire to rub against a metal edge.

Vehicle description: school and transit buses. The mounting bolt for the upper front shock absorber bracket can loosen in service due to the omission of a frame reinforcement from the upper shock absorber mount. The loosened bolt could then work in the...

Vehicle description: heavy duty vehicles equipped with meritor rs-17145 rear axles. The weld attaching the spindles to the housing may not have been welded properly.

Vehicle description: passenger vehicles equipped with chrome plated aluminum wheels. Some of these wheels have a mounting surface that was not machined correctly, causing the wheel studs to break.

Vehicle description: passenger mini vans. The left and/or right front lower insulator to cradle center metal sleeve is collapsed, which can result in loss of clamp load in the joint. If the clamp load is reduced or lost, the bolt can be lost or broken and...

Vehicle description: passenger vehicles. An electrical short can develop in the generator, even when the engine is off.

Vehicle description: step vans equipped with spicer 6,000 or 8,000 lb. Front steer axles. The tie rod end can pull outboard and separate from the tie rod tube due to improper thread engagement between the male tie rod end and the female tube.

Vehicle description: motorcycles (vn1500-j1/l) equipped with a digital fuel injection system and a vehicle-down sensor. This feature is designed to prevent the fuel injection system from continuing to pump fuel if the motorcycle falls down, by shutting off...

Vehicle description: heavy duty trucks equipped with meritor air brake automatic slack adjusters. Some of the automatic slack adjusters had insufficient torque applied to the guide pawl cap screw.

Vehicle description: passenger vehicles. If the rubber boots on the lower lateral arm ball joints of the front suspension were damaged during assembly, dirt and water can intrude.