Latest vehicle recalls

Vehicle description: motorcycles. The fuel level sending unit was incorrectly manufactured and could leak.

Vehicle description: passenger vehicles. When the stop lamp switch was assembled, grease was inadvertently applied to the contact point. This can cause the contact point to heat up causing internal operation elements to melt allowing the swtich to become...

Vehicle description: class a motor homes. The intermediate drive shaft installed on these motor homes can fall to the ground.

Vehicle description: light duty pickup trucks equipped with 5.9L - 24 valve diesel engine. An intermittent high engine idle condition can occur due to a malfunction of the vehicle speed sensor.

Vehicle description: light duty pickup trucks. These vehicles may have been built with bolts that were not properly hardened. The bolts were used to attach the cab and the core support to the frame.

Vehicle description: light duty pickup trucks equipped with 5.9L - 24 valve diesel engine. The low pressure diesel fuel supply tube located in the engine compartment between the filter and the high pressure pump can fracture.

Vehicle description: passenger vehicles. An external spring in the timing belt tensioner can break and get caught in the timing belt.

Vehicle description: class a and c motor homes. The hardware used to secure the liquid propane (lp) tank was not tightened properly.

Vehicle description: passenger vehicles equipped with accessory cargo mats in the third-seat and cargo area. This cargo mat interferes with the latching integrity of the folding third seats.

Vehicle description: passenger vehicles. A dash insulator retainer clip was not fully assembled to the accelerator cable dash fitting. The clip can disengage from the accelerator cable and fall into the accelerator pedal arm pivot area.

Vehicle description: steel, aluminum and valuelite horse trailers. Tire sizes were improperly entered on the certification label. This does not meet the requirements of fmvss no. 120, "Tire selection and rims for motor vehicles other than passenger cars,"...

Vehicle description: light duty pickup trucks with 3.0L engine. An 'o'-ring seal in the fuel injection pulse damper to fuel rail joint could be damaged allowing fuel leakage.

Vehicle description: motor homes equipped with aqua-hot heating systems, model 431-3 zone with engine loop. Fiberglass insulating material located under the burner head on the floor of the heater enclosure, can become soaked with fluids (ethylene glycol...

Vehicle description: trailers equipped with maxibrake I actuators, type 20, type 24, type 30, and type 36. These brake actuators do not have an overstroke indicator. This does not comply with the requirements of fmvss no. 121, "Air brake systems."

Vehicle description: school buses built with code g47aodm outward opening service door and code g47acdc or g47a5dc manual door control. Certain clothing articles such as draw strings can become lodged between the control rod clevis and the attachment at the...

Vehicle description: motorcycles. The swing arm on these motorcycles was improperly manufactured.

Vehicle description: passenger vehicles equipped with manual seat tracks. The front seat belt buckle attaching stud may have been improperly heat treated. This heat treatment may have resulted in cracks developing in the stud.

Vehicle description: travel trailers. The fan-light appliance can fail (most commonly involving a failure of the fan motor) which can result in an overload in the coiled power supply wires, which could melt the wires.

Vehicle description: light duty pickup trucks. A speed control cable may not have fully seated into the accelerator bracket at time of installation. If the cable is not fully seated into this bracket, the cable could separate from the bracket.

Vehicle description: light duty pickup trucks. The fuel pressure regulator o-ring may have been damaged when the fuel pressure regulator was installed in the engine fuel rail. If the o-ring is damaged, fuel vapor or leakage could occur.