Latest vehicle recalls

Vehicle description: passenger vehicles. The rear brake line on the passenger side was routed too close to the corner of the fuel tank. The line could be damaged by chafing against the fuel tank.

The rear lamp socket may not illuminate because the metal can in the lamp socket moves or separates from the plastic socket housing.

The rear lamp socket may not illuminate because the metal can in the lamp socket moves or separates from the plastic socket housing.

Vehicle description: travel trailers (only models 26a and 24b are affected, and further identified by the characters "7a26" or "7b24" in the fourth through seventh positions of the vehicle identification number. The main wiring harness and generator...

Vehicle description: mini vans originally sold or currently registered in the following states: alabama, arizona, arkansas, california (10 southern counties of los angeles, orange, san bernadino, san diego, riverside, ventura, santa barbara, san luis...

Vehicle description: transit buses equipped with challenger 2000 model 170 series alternators. The positive power stud may not be properly seated in place causing a loose connection. This loose connection causes an over-heat condition when the alternator...

Vehicle description: crew cab pickup trucks. The front, inner corner of the fuel tank can contact the body sill either intermittently or constantly. This movement can cause a discernible noise and, over time, can wear a hole in or crack the fuel tank at...

Vehicle description: type I modular ambulances, rescue trucks, and speciality vehicles. The bolts used to secure lateral supports to a type I chassis rail have partially, or completely, pulled through the mounting slot. This results in the lateral support...

Vehicle description: trailers equipped with aftermarket aluminum dual wheels, 22.5X8.25, One-piece, tubeless, supplied by accuride/akw. Certain design revisions combined with process conditions caused fatigue cracks in these wheels.

Vehicle description: passenger vehicles. The statement required in the owner's manual that "...The on-off switch should only ben used when a member of a passenger risk group identified in the request form in appendix b......Is occupying the right front...

Vehicle description: mini vans equipped with integrated child seats. The shoulder harness restraint on the integrated child seat can become difficult to extract when the safety belt latch plate becomes contaminated.

Vehicle description: passenger vehicles built with 3.5L engines. The fuel injection delivery system can leak fuel from some of the sealing o-rings or from hair line cracks in the thermoset fuel injection rail.

Vehicle description: passenger vehicles equipped with automatic transmissions. The adjustment of the cable connecting the console shifter mechanism to the ignition key can cause a trapped key condition which can result in a low force required to depress the...

Vehicle description: light duty trucks equipped with either a 8.0L v-10 engine or a 5.9L v-8 heavy duty gasoline engine. An exhaust system heat shield attaching screw is too close to the underbody fuel line. The line can rub against the screw, possibly...

Vehicle description: passenger vehicles. A malfunction or failure of a coolant system component, such as a thermostat, water pump, or fan belt, can result in significantly increased coolant temperature and system pressure. If the indications of a critical...

Vehicle description: light duty pickup trucks equipped with electric drive. Rapid fogging of the interior glass can occur within two minutes after the heat is turned on if (1) the outside temperature is between 35 and 76 degrees fahrenheit and (2) water has...

Vehicle description: sport utility vehicles. The transfer gearbox flange nuts were not properly installed, causing the nuts to loosen.

Vehicle description: school and transit buses. The bolts retaining the fuel tank straps can loosen allowing the fuel tank to dislodge.

Vehicle description: transit buses equipped with sunsource/fauver tandem hydraulic pumps. The hydraulic piston pump is driven by the engine and a shaft out of the back of the pump providing power to the power steering pump. The shafts are connected...

Vehicle description: motor homes. The fuel fill vent was not long enough when installed into the fuel tank to allow air to pass through the vent holes, creating a back splash of fuel.