Latest vehicle recalls

Vehicle description: heavy duty trucks. The air hoses from the relay valves were connected directly to the service brake chambers, rather than beting connected through the anti-lock braking system (abs) modulator. This does not comply with fmvss no. 121...

Vehicle description: truck chassis. The intermediate steering shaft-to-steering bolt was not tightened properly during assembly. This can cause steering noise, loose steering, and an uncentered steering wheel.

Vehicle description: transit and school buses. Movement of the hand throttle cable in the accelerator bracket rubs a groove in the bracket. The hand throttle cable can become wedged in this groove preventing the accelerator from returning to the idle...

Vehicle description: sport utility vehicles, 2 and 4-wheel drive. Solder joints near the wiring harness connector can crack causing the windshield wipers to work intermittently.

Vehicle description: light duty pickup trucks and sport utility vehicles, 2 and 4-wheel drive. Solder joints near the wiring harness connector can crack causing the windshield wipers to work intermittently.

Vehicle description: sport utility vehicles. Certain underhood hose and tubing components can fail allowing fluid to leak, such as engine coolant, windshield wiper fluid, and automatic transmission fluid.

Vehicle description: passenger vehicles. Because of certain calibrations in the air bag's sensing and diagnostic module, an inadvertent air bag deployment could occur in a low speed crash or when an object strikes the floor pan.

Vehicle description: motor homes. The driver's and passenger's side windows do not meet the requirements of fmvss no. 205, "Glazing materials," for an acceptable level of tint.

Vehicle description: passenger mini vans equipped with bucket seats or a split bench seat in the second (middle) or third (back) row. The seat latch mechanisms on bucket seats and on the 40% portion of the split bench seat in the second and third rows do...

Vehicle description: passenger vehicles. The windshield wiper motor 'low' speed function can become inoperative when the motor is switched from 'high' to 'low' speed.

Vehicle description: motorcycles. The gasket between the fuel tank and the fuel pump mounting plate can lose its ability to provide a tight seal, allowing fuel to drip from the gasket.

This is not a safety recall in accordance with federal regulation 573. However, it is deemed a safety improvement campaign by the agency. Vehicle description: passenger vehicles originally sold or currently registered in the states of new york, michigan...

Vehicle description: transit buses equipped with an auxiliary diesel powered heater (proheat bravo model 80). An improperly assembled fuel regulator can allow an excess amount of fuel into the combustion chamber.

Vehicle description: mini motor homes. The routing of the wire loom in the engine is too close to the engine block.

Vehicle description: passenger vehicles. The air bag alert label on the driver side visor was omitted. This does not conform to the requirements of fmvss no. 208, "Occupant crash protection."

Vehicle description: transit buses. A tether strap on the driver's seat was omitted. This does not comply with the strength requirements of fmvss no. 207, Seating systems."

Vehicle description: passenger vehicles. The sealing material of the switch can develop leaks and allow water entry.

Vehicle description: passenger vehicles. The differential pinion shaft within the differential case assembly was produced without the appropriate surface hardening. This can result in the shaft experiencing premature wear.

Vehicle description: class 'b' motor homes built on dodge 1500, 2500 and 3500 van chassis. The fuelvent hose from the fuel tank to the fuel fill entry may not be vapor tight due to over tightening of the gear clamp at the connection of the plastic vent tank...

Vehicle description: passenger vehicles. Certain wheels were not properly heat treated for hardness. The rear wheels could crack and break.