Vehicle description: school buses equipped with the international i6 electronic engine and an extra thick bus body floor. The accelerator pedal to floor clearance is approximately 1.2 Inches with a standard bus body floor. However, some customers ordered...
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
The front impact beam installed on these motor homes can fall to the ground forward of the front axle.
THE ECO-CRUISE ACTUATOR CAN BIND THE THROTTLE.
The e-z slide-out room can operate unexpectedly. Water can cause an electrical short in the slide-out room control relay.
The drive axle housings consist of a plate steel center section and two forged spindles, one of which is welded to each end of the center section. Each spindle contains a keyway slot in which the locking tab for the wheel bearing nut locking mechanism is...
Vehicle description: all vehicles equipped with eaton drive axles and axilok spindle nuts. The drive axle housings consist of a plate steel center section and two forged spindles, one of which is welded to each end of the center section. Each spindle...
If the plastic pins and metal clip that retain the lower steering shaft in the upper shaft break, the lower steering shaft can separate from the upper shaft.
The steering wheel armature stamping can crack and separate from the center hub attachment to the steering column.
The fuel and rear brake tubes can experience accelerated corrosion between the tubes and a rubber isolator.
Vehicle description: 4-door, 4-wheel drive and all-wheel drive multi-purpose passenger vehicles. During development testing, the prop shaft contacted the inboard side of the fuel tank allowing fuel leakage. This leakage was in excess of the amount...
Vehicle description: heavy duty trucks equipped with horton fan drives. The fan drive control system was reconfigured which resulted in a significant increase in the demand for fan activation and associated stress to electrical and mechanical components...
Two bolts that attach the driver air bag to the steering wheel were not installed during vehicle assembly.
Covers1997 Lincoln Town Car
These buses have a turn signal lever that will not operate consistently in the lane change mode if the lever is not moved to the position where resistance to movement is felt.
The seat belt retractor located next to the driver and passenger seats will not allow the belt to be extended so that it can be used.
The recliner mechanism and the seat frame may have foam and/or vinyl vetween them, creating a "soft" joint. This "soft" joint results in lower than specified bolt torque which leads to joint looseness, causing bolt fatigue and eventual bolt failure.
THE MAIN POWER CABLE CAN WEAR DUE TO FRICTION.
The ground studs in the engine and battery compartments do not offer adequate electrical conductivity.
The air/spring actuated parking brake chambers manufactured by midland (date code 145b6k) were filled with the wrong lubrication. The improper lubricant causes the seals within the chamber to fail and results in loss of air. If air pressure drops to 55 psi...
These vehicles were manufactured with seat belt retractors out of design position which can cause the retractor to lock-up on slopes less severe than the fmvss requirement. This does not comply with fmvss no. 209, "Seat belt assemblies."
Miswiring of the low beam headlamp receptacle for the replaceable halogen lamp causes a noncompliance to fmvss no. 108, "Lamps, reflective devices, and associated equipment."