Latest vehicle recalls

Vehicle description: buses equipped with isringhausen seats in the driver position. Two welds located on the back rest adjustment side of the seat frame did not meet the manufacturer's specifications.

The u-joint bearing strap bolts were not properly tightened during assembly.

The fasteners securing the compressed natural gas (cng) roof-mounted fuel tank lids were not properly installed and/or maintained.

The rear axle track bar bracket can separate from the frame due to missing welds or inadequate weld penetration.

Vehicles originally sold or currently registered in the following states: alaska, montana, north dakota, minnesota, wisconsin, michigan (upper peninsula), new york, maine, vermont, and new hampshire. Operation at highway speeds during extreme cold...

The front and/or rear hazard warning lamps (four-way flashers) do not flash when the hazard switch is activated. This fails to comply with fmvss no. 108, "Lamps, reflective devices, and associated equipment."

The steering column lower pinch bolt was not properly tightened during assembly.

The "o" rings of the regulator assembly in the onan emerald and marquis brand generator sets can weaken and break when exposed to high ambient temperatures.

Certain vehicles were manufactured with an incorrect rear center seat belt assembly buckle. The misbuild involved fitting a buckle for another market with the correct u.S. Specification seat belt.

Certain vehicles were manufactured with an incorrect rear center seat belt assembly buckle. The misbuild involved fitting a buckle for another market with the correct u.S. Specification seat belt.

The right front door can fail to latch fully when closing, causing the door to "bounce" back off the door seals.

These vehicles are equipped with a detroit diesel optimized idle system. If the ignition is turned on and the fuse for the electronic control module (ecm) power feed line is removed or burned out, unintentional cranking of the engine will occur..

The wheel lug nuts were not tightened to the proper specification during assembly.

The parking brake cylinder rod can separate from the socket that it is threaded into due to defective threads.

Air bag and seat belt system warning labels are missing from the sun visor. This does not comply with fmvss no. 108, "Occupant crash protection."

Vehicle description: class 8 heavy duty vehicles equipped with eaton drive axles and axilok spindle nuts. The drive axle housings consist of a plate steel center section and two forged spindles, one of which is welded to each end of the center section...

The awnings for the slide-out room can unfurl or unroll during transit causing the bracket to rip free of the sidewall of the vehicle.

The front seat belt warning chime does not sound with the seat belt unbuckled.

The low brake fluid level warning lamp does not illuminate during the ignition on, bulb test period.

Vehicle description: school buses and heavy duty trucks equipped with rear axle assemblies produced by dana spicer. Certain rear axle assemblies were improperly heat treated which could allow pinion breakage at the pinion threads.