Latest vehicle recalls

Vehicle description: buses equipped with isringhausen seats in the driver position. Two welds located on the back rest adjustment side of the seat frame did not meet the manufacturer's specifications.

Certain clothing articles such as draw strings can become lodged in the forward handrails at the bus doors when a person is exiting the bus.

The electric motor which drives the anti-lock brake system (abs) hydraulic pump does not function after a period of operation.

The spare tire carrier hoist components can become loose while traveling and allow the spare tire to move from its stored position to the road surface.

These fire trucks do not at least two sources of return energy as required by federal motor vehicle safety standard no. 124, "Accelerator control systems."

The top coat paint severely peels due to overbaking of the powder primer prior to the top coat application. Since the windshield primer and adhesive adhere to the top coat paint onthe windshield opening flange, the windshield does not comply with federal...

Corrosion can occur in the foot brake valve adapter bore and plunger due to water and road salt intrusion.

The top coat paint severely peels due to overbaking of the powder primer prior to the top coat application. Since the windshield primer and adhesive adhere to the top coat paint onthe windshield opening flange, the windshield does not comply with federal...

Due to undersized rivets and oversized holes, the b-pillar anchorage will not meet the requirements of federal motor vehicle safety standard (fmvss) no. 210, "Seat belt assembly anchorages."

These motorcycles were produced with incorrect certification labels. Incorrect tire rim data is printed on these labels. A tire size of 120/70 zr mt 3.5X17 rim at 32.7 Psi cold, and 170/c0 zr mt 5.50X17 rim at 36.9 Psi cold. The proper rim size is mt...

Pressure on the battery ground lead (the crimped and soldered termination of the battery cable) from the base of the operator's seat can cause the battery terminal to short out inside the battery.

Vehicle description: transit buses equipped with isringhausen seats in the driver position. Two welds located on the back rest adjustment side of the seat frame did not meet the manufacturer's specifications.

The rear bumper mounting brackets have been improperly installed. The mounting holes were cut oversized and can allow the mounting bolts to pull through the brackets on the chassis.

The subject vehicles have their wheelchair barriers attached to the floor structure with a bolt threaded into the floor structure. In the case of a frontal crash, at more than 20 miles per hour, with the wheelchair position occupied, there is a possibly that...

An integrated circuit within the voltage regulator can contain manufacturing errors.

Vehicle description: vehicles equipped with antilock brake system (abs). The antilock brake system (abs) hydraulic control unit can experience excessive brake actuator piston seal wear which could cause pump-motor deterioration.

Vehicle description: motor homes built on a chevrolet chassis. The frame rail extension will not support a full liquid propane (lp) gas tank. Vibration of the tank can cause the mounting hardware to become loose and eventualy could cause the tank to fall...

The tail light used on these vehicles was not certified for the united states.

The seat elt anchorage attachments are missing or misinstalled on these vehicles.

The "o" rings of the regulator assembly in the onan emerald and marquis brand generator sets can weaken and break when exposed to high ambient temperatures.