Latest vehicle recalls

As the brake pads wear, the brake caliper travel may be limited by interference with the main support member (z-bar spring) of the suspension.

Interference between the pitman arm and the steering gear housing due to insufficient clearance.

An engine compartment electrical wiring harness may have been routed too close to a sheet metal edge. The wiring can become damaged during normal vehicle operation due to chafing, resulting in an electrical short.

The fuel filler hose or fuel filler vent hose was damaged by a drill bit used to install the dso package attaching hardware onto the floor pan.

The lower bracket of the rear suspension airbag may be mislocated, and may be rubbing against the brake line.

Proper operation of the throttle linkage can be restricted by interference with the air compressor breather tube.

The 15 inch wheels have malformed lug nut seat configuration which causes poor nut-to-wheel contact and centering of the wheel during installation.

The fuel filters were produced with an incorrect threaded fitting. The incorrect fitting is similiar enough in size that the fuel filter may appear to be correctly threaded onto the fuel line.

Due to heat effects, the throttle bushing located on the accelerator control cable, can fatigue and break, causing the throttle linkage to separate.

The positive battery cable terminal at the starter solenoid may be formed incorrectly. Incorrectly formed terminals can contact the starter solenoid housing and cause an electric short circuit.

The pressure relief valve was omitted in the air tank. The air tank is the reservoir for the air suspension and is not brake related. Without the pressure relief valve, there is no back-up system to limit air pressure in the air suspension system.

The safety belt buckle assembly can get caught in the seat suspension mechanism. The movement of the air suspension seat could cause the safety belt buckle tether cable to fray .

The transfer cases have been built with the wrong electric shift motor. The transfer cases can slip out of the 4 x 4 high gear position during coasting in forward gears or with power applied in reverse gear.

The fuel feed and return lines to the engine fuel injection system were not fully assembled and locked. The lines can work loose, causing a fuel leak in the engine compartment.

Vehicle description: diesel powered, rubber tire street cars, 24,ooo lbs. Gross vehicle weight equipped with a mobile-tech, model 3213, wheel chair step lift. The passive step lift's barrier which keeps a wheel chair and its occupant from rolling off the...

The front brake air lines are incorrectly routed through the pressure protection valve at the auxiliary wet tank. This results in lack of air pressure to the front brakes when the air pressure in the auxiliary wet tank drops below 65 p.S.I., Resulting in...

A weld in the door lock assembly used on rear and/or side emergency doors can be overstressed and break. When this occurs, a closed door cannot be opened, or if open it cannot be latched.

The power window and sunroof latch switches remain in an operational mode when the pressure is removed, causing the window or sunroof to continue to close or open.

The mounting bracket for the rear trailer hitch may break because it does not have sufficient strength to withstand the loads of an attached trailer.

Salt corrosion products between the starter solenoid wire and the adjacent battery feed in the bulkhead connector may short these connections, causing the circuit to bypass the ignition key control of the starter motor solenoid. The car can start without the...