Latest vehicle recalls

Some of the abs equipped vehicles were built with an undersized brake return check valve. In incidents where hard brake pedal effort is applied on low friction road surfaces, like rain covered streets, the valves may fail, causing the abs to become...

While operating the engine in reverse gear, engine torque causes the engine to roll, causing the throttle modulator cable assembly to contact the floor and bind the throttle cable holding the throttle in an open position.

Plastic hood insulation clip(s) was(were) inadvertently dropped into the hose between the charge air cooler and the throttle housing which can interfere with the throttle operation.

During the removal and installation of the air filter housing while servicing the vehicle, it is possible to misroute the preformed vacuum hose and damage the check valve in the vacuum hose. If the check valve is damaged, loss of sufficient brake power assist...

The rear shock crossmember of the frame can crack and separate from the frame.

The fuel filler system does not comply with the leakage requirements of fmvss 301, "fuel system integrity".

These vehicles were manufactured with insufficient support structure for the main door entry step. The step can break loose from its attachment to the vehicle.

Keys attached to the key ring of an ignition key while it is in the vehicle ignition can become lodged in the steering lock receiver as the steering wheel is being turned.

The exhaust port in the up position allows water to enter the air brake system, which can block the air brake system in freezing conditions.

The spring brake chambers mounted on tag axles with mounting studs aligned horizontally instead of vertically can result in fracture of the brake chamber housing base which limits the application of service brakes on the affected wheel.

When the fuel tanks were tested in accordance with federal motor carrier safety regulation 363.67, Fuel tank caps and/or filler neck welds leaked.

The rear outside seating position safety belts may lock up at angles other than those required by fmvss 209, "seat belt assemblies". This does not conform to the motor vehicle safety standard.

The windshield wiper system hardware was incorrectly mounted, causing wiper blade overtravel and premature wear, and in extreme cases, the wiper blades may fail to correctly travel over the windshield.

The wire used to power the electronic memory on a radio installed in the rear of the motorhome was incorrectly routed directly to the hot side of the battery disconnect solenoid, and has no fuse protection.

The roll pins securing the ignition lock in the steering column housing can separate or move out of position.

If the plastic coating of the fuel filler and/or breather pipe is damaged, salt water may accumulate between the plastic coating and the steel pipes, and the accumulation could cause corrosion which would eventually rust through the affected pipes, allowing...

Vehicle description: passenger vehicles. The lower pivot pin that joins the liftgate gas strut to the body can separate from the lower strut mounting bracket due to an undersized rivet head.

Passengers clothing can unknowingly become caught in the handrails at bus doors when exiting the bus.

Grease applied to the liftgate latch rubber bumpers to ease component assembly caused the bumper to swell, interfering with the movement of the liftgate latch pawl. This prevents the liftgate latching when closed and difficult to open when latched.

A condition exists that allows oil to leak from the all wheel drive transfer case. Low oil levels in the transfer case can cause bearing damage and failure.