Latest vehicle recalls

The screw that secures the wiper switch at one location and which also provides a ground for the wiper circuit, loosens as the switch is operated over a long period of time. As the screw continues to loosen the ground for the wiper circuit is intermittently...

The electronic control unit (ecu) for the power door lock system can fail, causing the contacts to "weld", and resulting in door lock solenoid damage, with failure of the door to lock or unlock, even under manual operation.

The motorhomes have poor handling characteristics and are subject to instability due to improper weight distribution. Also, the chassis was not certified by a chassis manufacturer.

One or both of the bolts securing the automatic seat belt restraint system tracks to the b-pillars were not adequately tightened.

One or both of the bolts securing the automatic seat belt restraint system tracks to the b-pillars were not adequately tightened.

The service brake master cylinder was not properly assembled or could have been damaged by the evacuation and filling of the brake system at the assembly plant.

The service brake master cylinder was not properly assembled or could have been damaged by the evacuation and filling of the brake system at the assembly plant.

The venturi tube located in the throttle valve housing can become loose and fall against the throttle plate.

The front suspension lower control arm tension strut washers can crack and fall off due to hydrogen embrittlement.

The jam-nuts for the right and left hand tie rods in the drag link were not properly torqued after installation.

The 19.5 X 6 front steel wheel disc cracks outside the mounting bolt circle and ends at the hub's diameter.

Incorrect screws were used to attach the plywood seat back to the seat frame.

The positive battery cables installed as part of harley- davidson's previous recall 077 (nhtsa recall 92v011000) can fail in service.

The brake pedal assembly has a pushrod pin that is too small and it is installed in the wrong position, causing an increased brake pedal ratio and a decreased master cylinder stroke.

The power seat or recliner wiring harness can be pinched or can chafe on the seat frame or spring support rod, wearing through the wire insulation and causing an electrical short.

The tire certification labels incorrectly identify the vehicle tire requirements as p235/75r15 sl (standard load), rather than as p235/75r15 xl (extra load).

The driveshaft used with some engine/transmission combinations had insufficient welds joining some of the components.

Fatigue cracks can develop in the solder joint between the fuel return tube and the fuel pump sending unit located at the top of the fuel tank.

The rigid mounted safety belt buckles are defective in three ways. First, a fastened safety belt buckle will not unlatch when the release button is depressed. This results from interference between the buckle ejector finger and the buckle tongue window. The...

A leak of either gasoline or propane can occur in components of the dual fuel system. This condition is primarily the result of the configuration and location of components in areas where high temperatures are being generated by the engine and exhaust systems.