The inner arms of the rear suspension are subject to corrosion in areas where road salt is used heavily in winter.
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
The fuel inlet needle does not seal properly against the fuel inlet seat.
The link lever trunion on the safety belt retractor may have been damaged during installation.
Covers1993 Lincoln Mark Viii
The power steering gear inlet hose on these vehicles can fracture, causing power steering fluid to spray from hose into the engine compartment.
There is fuel leakage at the fuel tank fill and/or vent pipe extension solder joints.
Covers1992 Chevrolet Lumina
A hardtop hoist accessory kit was sold to customers who have the miata with a hardtop. The plastic buckles used to adjust strap tension can break after the hardtop has been suspended by the hoist.
The saginaw gear does not relieve pressure when the wheels have been turned fully against the axle stops. The resulting continued pressure on the steering system can result in the development of cracks in the splines of the pitman shaft, which can develop...
The automatic transmission shift control cable can separate.
The increased weight of the stretch conversion limousines requires larger diameter rear wheel brake cylinders than those installed in the factory.
Safety belt retractor locks up with the belt in the stowed position.
Front fuel feed hose assembly could crack or separate at the coupling on the engine end of the hose assembly, allowing fuel to leak into the engine compartment.
On 1987 through early 1990 models, both front brake hoses can wear due to direct contact with the wheel opening splash shields. On the late 1990 through 1992 models, periodic rubbing contact of the left front brake hose can occur due to movement of the splash...
Fuel tank flanges were not bent as required to allow the specified clearance for the fuel tank mounting straps and fuel lines at the tank.
The a.I.R./ Exhaust check valves at the engine may malfunction allowing hot exhaust gases to pass into the rubber hoses which normally carry unheated air.
The wrong safety belt latch tongue plate was installed in some safety belt assemblies.
Covers1993 Toyota Toyota Truck
Premature failure of the aluminum clutch release lever can occur from stress corrosion due to continuous loading of the lever and exposure to road salt spray.
The heat shield, between the muffler and the plywood storage compartment, contains oversize holes which allow heat from a ruptured muffler to penetrate through to the plywood storage compartment.
The ball sockets on the cruise control linkage can break, allowing the cruise control linkage to become detached on one end and jam on nearby components, which could impair throttle plate operation.
The steel spoked wheel assemblies installed as standard equipment or offered as an option on these vehicles were improperly welded during assembly of the wheel rim to disk, which can cause cracks in the wheel.