Latest vehicle recalls

The cruise control vacuum solenoid valves may malfunction at any time the engine is running and the cruise control is engaged and cause unexpected engine acceleration...

The tire placard label on the left front door may have been printed with an error which specifies a higher maximum loading than is allowed...

The steel wheel rims may crack and break. Consequence of defect: broken wheel rims could cause the driver to lose control of the vehicle and result in an...

Brake master cylinders may have improperly anodized internal surfaces causing accelerated wear of a piston seal. Consequence of defect: one portion of...

One of the three steering gear to frame bolts may not have been tightened to the required specification. Consequence of defect: the steering...

Metal bushings for the cruise control linkage are subject to corrosion due to weather conditions. Also, there is not enough clearance between the bushings and the shaft; and the linkage points were not lubricated. Thus, cruise control...

Impure lubricating grease used in the headlight switches could contaminate one or more contact points. Operation of the headlights could be delayed or not light when the switch is turned on or when the dimmer switch is operated...

Certain trucks do not comply with fmvss 108, "lamps, reflective devices and associated equipment." The trucks were assembled without the roof marker lamps...

The rack and gear type latch assembly of the emergency doors can be overstressed by misuse of the inside door handle, making the gears subject to failure...

The hub area of the wheels may not be structurally sound and thus subject to fracture. Consequence of defect: the wheels could...

Seam leaks may develop in the 70 gallon aluminum fuel tank, allowing gasoline to spill on the ground. This is due to poor seam welding...

The throttle shaft of the carburetor may crack and eventually break at the threaded hole for the throttle plate connection due to excessive vibration of the throttle shaft...

The saginaw tilt steering column assembly has two pivot bushings and two mating retaining bolts. These retaining bolts can loosen, which could allow the pivot bushings to move into the turning arc of the column shaft universal joint...

The lp gas distribution system where the lp line passes over the rear suspension leaf spring does not have enough clearance and could allow contact between the lp line and the leaf spring. This could lead to failure of the copper tubing. Owners...

The wood anchor screws holding the inboard end of the furnace may not have been installed. Thus, the furnace may shift position or bounce while traveling...

An engine compartment fuel hose routed to the fuel system pressure regulator may have an inadequately tightened hose clamp. Consequence of defect: the fuel hose...

Wire in battery charging circuit cannot tolerate the maximum current drawn by the alternator. Under repeated high electrical load, heat will build up at connector terminal area, melting the plastic wire harness, possibly discharging battery.

Metal burrs and sharp edges on fuel rails may have damaged adjacent o-ring seals during assembly. The defect could cause fuel leakage when engine is operating.

Required front center seat belt assembly was omitted. Vehicles are not in compliance with the requirements of federal motor vehicle safety standard 209, seat belt assemblies.

The weld between the grabhandle and mounting plate may fail, causing grabhandle to come off unexpectedly.