Latest vehicle recalls

The flexible fuel hose may have been turned out of its normal position and have a sharp bend or twist near one of its fittings. Consequence of defect: this could lead...

Widespread lack of understanding about the operation of webbing sensitive and dual sensitive seat belts has lead to non-use of belts by a number of owners. Some belts retractors may jam, bind or lock. This may discourage the use of the safety belts...

The idle control valve which controls idle speed by varying the amount of intake air that bypasses the throttle plate is subject to backfire into the intake manifold. Such backfire can damage the valve and cause the idle valve plate to remain open...

The drag links may have been installed incorrectly allowing drag link clamp bolt to axle beam interference. Consequence of defect: during a turning...

Trailer hitches can crack at the mounting flanges and separate from the motorhome while being used in trailer or car towing service. Consequence of defect: if complete...

The emergency brake cable may become frayed or bound up on the heat shield of the propane tank mounting brackets. Consequence of defect: emergency brakes...

The throttle lever may not return to idle position due to misalignment of the air conditioner shut off switch to the throttle lever pin...

Roadway stones may become lodged in the height sensing brake proportioning valve. This may cause the proportioning valve to fail. Consequence of defect: proportioning...

Rim information may have been omitted on certification label installed on the left front door. Consequence of defect: these trucks do...

The flip out step clevis on the bumper may fail and break under the weight of the person standing on the step to service the front area of the vehicle...

The rear bumper may fracture during a rear end collision, puncture the fuel tank, and cause a fuel leak. Consequence of defect: a fuel leak...

Excessive enlargement of the wheel cylinder pilot hole in the rear brake backing plate could allow the wheel cylinder to rotate and cause loss of brake fluid...

A loss of bonding adhesion between the paint and the windshield opening area could allow the windshield to separate during a 30 mile per hour frontal barrier test required by fmvss 212, windshield retention...

The nylon fuel supply and return lines are improperly routed along the frame side rail and could contact the universal joint on the front driveshaft...

The engine air cleaner plastic trim cover could detach from the air cleaner assembly and fall forward on the exhaust manifold. Consequence of defect: if the car is...

A malfunction may occur in the air suspension electrical circuitry.

Fuel hose may be damaged due to too much pressure in crimping the hose end fitting. Consequence of defect: a fuel leak...

The electrical cable between the starter and the alternator can rub against the brake fluid pipe attached to the left inner wheelhouse in the engine compartment...

The fuel system may leak at the throttle body injection fuel feed pipe connection. Consequence of defect: this leakage...

Front seat belt retractors may not properly lock during sudden heavy brake application or impact due to the interference of two positioning tabs...