Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Vehicle safety record

1980 Oldsmobile Cutlass Problems, complaints & recalls

Owners have filed 3 complaints about the 1980 Oldsmobile Cutlass with NHTSA, most often about the brakes (1) and the wheels & tires (1). Those complaints describe 1 crash. It is covered by 5 recalls, the latest in October 2007 for the equipment. For comparison, the 1979 has 2 and the 1981 has 3.

NHTSA data checked

CAbout as many problems as a typical Cutlass year, for its age

#2 most complained-about 1980 vehicle

Complaints
3
Recalls
5
Crashes
1
Fires
0
Injuries
0
Deaths
0

Most common 1980 Oldsmobile Cutlass problems

Share of all 3 complaints. One complaint can name more than one area. Tap an area for its complaints and recalls.

1980 Oldsmobile Cutlass recalls 5

Recall repairs are free. Your dealer fixes them whether or not you bought the car there - check your VIN at nhtsa.gov/recalls to see if yours is done. What to do

Equipment

07E088000121,680 vehicles affected

The problem
Certain honeywell fram racing brand hp4 and hp8 oil filters that were manufactured from may 25, 2006, through september 14, 2007, and sold for use as replacement equipment for vehicles list above. The affected filters are marked with a date code a61451 through a72571 sequentially. The date code and part number appear on the filter housing. Fram racing hp4 and hp8 oil filters not bearing a date code in this range are not affected by this recall. The gasket of the oil filter becomes more pliable under high temperatures and pressures.
The risk
This condition may cause inadequate sealing and loss of engine oil, possibly resulting in a fire.
The fix
Honeywell will replace the affected oil filters free of charge. The recall began during november 2007. Owners can contact fram customer service toll-free at 1-800-890-2075.

Service brakes: wheel cylinders

85V0480001,810,000 vehicles affected

The problem
Excessive enlargement of the wheel cylinder pilot hole in the rear brake backing plate could allow the wheel cylinder to rotate and cause loss of brake fluid. Consequence of defect: a loss of brake fluid leads to loss of rear brake action, creating the potential for an accident. Front brakes would remain operational.
The fix
Add a part to prevent wheel cylinder from rotating.

Power train: axle shaft

84V1490003,100,000 vehicles affected

The problem
Rear axle assembly may have axles that were improperly manufactured. This condition may result in separation of the axle shaft and wheel assembly from the vehicle.
The fix
The dealer will inspect the rear axle to determine whether it was manufactured at the buffalo plant. If so, they will make axle measurements and if necessary replace or modify affected axle components without charge.

Suspension: rear

81V0250005,821,160 vehicles affected

The problem
The bolts that attach the lower rear control arm to the frame may fracture. The rear control arm supports and positions the rear axle. Fracture of the bolts would allow the control arm to drop free.
The fix
Both rear control arm attachment bolts will be replaced without charge.

Visibility: glass, side / rear

81V02200067,350 vehicles affected

The problem
The electro-clear rear window defoggers contain a defect which causes the glass to shatter without impact during or some time after use of the defogger. Vertical electrical strips may deteriorate and cause hot spots that can result in breakage of the rear glass.
The fix
Vehicles will be inspected for presence of a particular weatherstrip. If present, a layer of a special conductive epoxy will be added to the vertical bar on the rear window glass. This epoxy is a new conductive material which will not react with the weatherstrip.

What owners say

Be the first Cutlass owner to share.

Problems or none - your experience is exactly what the next buyer is looking for. Write it now

3 complaints about the 1980 Oldsmobile Cutlass

Newest first, as filed with NHTSA by owners.

Wheels & tires

About a 1.5 To 2 years ago I purchase a firestone 721 passenger car tire. I almost immediately began having problems with my car riding ruff. I took the car back to the firestone dealer where I bought the tire and told them that my tire were out of balance and that they needed rebalancing. They said that my rims were bent, they replaced them and it still didn't stop the vibration. Next, they said my rear axle was bent and that was the cause of the vibration. I didn't have the funds at the time to replace my...

Read the full complaint

rear alxe I would have to put up with the rough ride. Shortly there after, on a trip tn the vibration got alot worse, until I heard what sounded someone hitting the side of my car with a baseball bat I pulled off the highway and found that the new 721 that I bought threads came off and hit the side of my car knocking the trim off of it. I drove the rest of the way to memphis on the donut, also, I notice as soon as I put the spare on and was on the highway the vibration I had put up with for the last year completely disappeared. In memphis they gave me another 721 firestone tire that I currently have now, that was over a year ago. In the last week, I have noticed another vibration cropping up in my car. I have 3 new michelins and the 721 that I got in memphis on my car. When I get up to about 55miles/hr the vibration gets alot worse. I afraid the 721's belts are about to split again. Altough the 721 has over 60 to 70 percent of it's thread left. What would you recommend in my case?( Dot number: tire size: 195r14 )

Filed TiresNHTSA 731764
Fuel system

This is to bob young: after reading the wall st journal article I wanted you to know that I learned first hand another cause of runaway vehicles: electronic carburetor didnt like fuel richness so accelerated everytime I tried to stop at a sign. La vegas dealer adjusted it to ignore problem. Took 2 times to fix. More info if bob young wants to email me... Alex

Filed Incident Fuel system, gasolineNHTSA 715961
BrakesCrash

Consumer was traveling about 10 to 15 mph when there was a malfunction in the master cylinder which caused the brakes to lock up, causing the consumer to have an accident. Consumer has contacted the dealer, parts have been replaced. *Ak

Filed Incident Service brakes, hydraulicNHTSA 815069

Oldsmobile Cutlass: every year compared

YearComplaintsRecallsCrashesFiresTop problemGrade
198416213Engine & coolingF
19835222Engine & coolingC
19821200Seats & seat beltsB
19813201Engine & coolingB
19803510BrakesC
19792800Engine & coolingD
19780600-C
19773210SteeringB
19763200Fuel systemB
All Cutlass years

1980 Oldsmobile Cutlass vs rivals

VehicleComplaintsRecallsCrashesGrade
1980 Oldsmobile Cutlass351C
1980 Oldsmobile Toronado220CCompare
1980 Oldsmobile 98120BCompare
1980 Oldsmobile Omega180FCompare

More sales usually means more complaints, so compare similar vehicles of the same year. The grade compares each vehicle with its own model's other years.

Own a 1980 Oldsmobile Cutlass? Share your experience.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Questions about the 1980 Oldsmobile Cutlass

Does the 1980 Oldsmobile Cutlass have any recalls?

Yes - NHTSA lists 5 recalls for the 1980 Oldsmobile Cutlass: equipment (October 2007); wheel cylinders (April 1985); axle shaft (November 1984); rear (February 1981) and more. Recall repairs are free at any authorized dealer. Enter your VIN at nhtsa.gov/recalls to see whether yours has been fixed.

What are the most common problems with the 1980 Oldsmobile Cutlass?

By the complaints owners filed with NHTSA, the most common problem areas are the brakes (1), wheels & tires (1), fuel system (1).

How many complaints has the 1980 Oldsmobile Cutlass had?

3 complaints have been filed with NHTSA, the first on August 5, 1997 and the latest on September 18, 2000. Of these, 1 describe a crash and 0 a fire, and together they report 0 injuries and 0 deaths.

Is the 1980 Oldsmobile Cutlass a reliable vehicle?

Its Safety Index is 46 out of 100 (grade C: about as many problems as a typical Oldsmobile Cutlass year, for its age). The index weighs complaints, crashes, fires, injuries, deaths and recalls against how long the vehicle has been on the road, compared with the same model's other years. It is not a measure of every repair - read the complaints and owner experiences, and have any used vehicle inspected before you buy.

Which Oldsmobile Cutlass years have the most complaints?
What should I do if my 1980 Oldsmobile Cutlass has a problem?

If it is a safety problem, stop driving it if it is unsafe and contact your dealer. Report it to NHTSA at nhtsa.gov/report-a-safety-problem - enough reports start investigations and recalls - and share your experience here so other owners know what to look for.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience