- The problem
- Certain honeywell fram racing brand hp4 and hp8 oil filters that were manufactured from may 25, 2006, through september 14, 2007, and sold for use as replacement equipment for vehicles list above. The affected filters are marked with a date code a61451 through a72571 sequentially. The date code and part number appear on the filter housing. Fram racing hp4 and hp8 oil filters not bearing a date code in this range are not affected by this recall. The gasket of the oil filter becomes more pliable under high temperatures and pressures.
- The risk
- This condition may cause inadequate sealing and loss of engine oil, possibly resulting in a fire.
- The fix
- Honeywell will replace the affected oil filters free of charge. The recall began during november 2007. Owners can contact fram customer service toll-free at 1-800-890-2075.
Vehicle safety record
1979 Oldsmobile Cutlass Problems, complaints & recalls
Owners have filed 2 complaints about the 1979 Oldsmobile Cutlass with NHTSA, most often about the transmission & drivetrain (1) and the engine & cooling (1). It is covered by 8 recalls, the latest in October 2007 for the equipment. For comparison, the 1978 has 0 and the 1980 has 3.
NHTSA data checked
DMore problems than a typical Cutlass year, for its age
#6 most complained-about 1979 vehicle
- Complaints
- 2
- Recalls
- 8
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Most common 1979 Oldsmobile Cutlass problems
Share of all 2 complaints. One complaint can name more than one area. Tap an area for its complaints and recalls.
1979 Oldsmobile Cutlass recalls 8
Recall repairs are free. Your dealer fixes them whether or not you bought the car there - check your VIN at nhtsa.gov/recalls to see if yours is done. What to do
- The problem
- Excessive enlargement of the wheel cylinder pilot hole in the rear brake backing plate could allow the wheel cylinder to rotate and cause loss of brake fluid. Consequence of defect: a loss of brake fluid leads to loss of rear brake action, creating the potential for an accident. Front brakes would remain operational.
- The fix
- Add a part to prevent wheel cylinder from rotating.
- The problem
- Rear axle assembly may have axles that were improperly manufactured. This condition may result in separation of the axle shaft and wheel assembly from the vehicle.
- The fix
- The dealer will inspect the rear axle to determine whether it was manufactured at the buffalo plant. If so, they will make axle measurements and if necessary replace or modify affected axle components without charge.
- The problem
- The bolts that attach the lower rear control arm to the frame may fracture. The rear control arm supports and positions the rear axle. Fracture of the bolts would allow the control arm to drop free.
- The fix
- Both rear control arm attachment bolts will be replaced without charge.
- The problem
- The electro-clear rear window defoggers contain a defect which causes the glass to shatter without impact during or some time after use of the defogger. Vertical electrical strips may deteriorate and cause hot spots that can result in breakage of the rear glass.
- The fix
- Vehicles will be inspected for presence of a particular weatherstrip. If present, a layer of a special conductive epoxy will be added to the vertical bar on the rear window glass. This epoxy is a new conductive material which will not react with the weatherstrip.
- The problem
- The invovled vehicles fail to conform to federal motor vehicle safety standard no. 201, "Occupant protection in interior impacts". Incorrect head restraints may have been installed.
- The fix
- Dealer will inspect and, if necessary, install new head restraints at no cost to owner.
- The problem
- On the involved vehicles the brake stoplight and cruise control switch which is operated by the brake pedal may have been assembled with an incorrect lubricant on the actuating plunger. This can cause the rear brake stoplights to become inoperative and the cruise control, if activated, to stay electrically engaged.
- The fix
- Dealer will inspect and, if necessary, replace the brake stoplight and cruise control switch at no cost to owner.
- The problem
- An incorrect fluid was used as an assembly aid (lubrication) during installation of the piston seal in front brake calipers which were installed in 10.5" X 1" disc brake assemblies used on "a" series cars. The incorrect fluid attacks the piston seal and causes them to swell and deteriorate.
- The fix
- Dealer will replace the brake caliper piston seals.
What owners say
Problems or none - your experience is exactly what the next buyer is looking for. Write it now
2 complaints about the 1979 Oldsmobile Cutlass
Newest first, as filed with NHTSA by owners.
While driving 65-70 mph, and without any indication, vehicle stalled. Technician stated engine needed to be replaced. Please provide further information.*Ak
TRANSMISSION FAILURE. *TW
Oldsmobile Cutlass: every year compared
All Cutlass years1979 Oldsmobile Cutlass vs rivals
| Vehicle | Complaints | Recalls | Grade | |
|---|---|---|---|---|
| 1979 Oldsmobile Cutlass | 2 | 8 | D | |
| 1979 Oldsmobile 88 | 2 | 3 | C | Compare |
More sales usually means more complaints, so compare similar vehicles of the same year. The grade compares each vehicle with its own model's other years.
Questions about the 1979 Oldsmobile Cutlass
Does the 1979 Oldsmobile Cutlass have any recalls?
Yes - NHTSA lists 8 recalls for the 1979 Oldsmobile Cutlass: equipment (October 2007); wheel cylinders (April 1985); axle shaft (November 1984); rear (February 1981) and more. Recall repairs are free at any authorized dealer. Enter your VIN at nhtsa.gov/recalls to see whether yours has been fixed.
What are the most common problems with the 1979 Oldsmobile Cutlass?
By the complaints owners filed with NHTSA, the most common problem areas are the transmission & drivetrain (1), engine & cooling (1).
How many complaints has the 1979 Oldsmobile Cutlass had?
2 complaints have been filed with NHTSA, the first on April 25, 1995 and the latest on January 29, 2002. Of these, 0 describe a crash and 0 a fire, and together they report 0 injuries and 0 deaths.
Is the 1979 Oldsmobile Cutlass a reliable vehicle?
Its Safety Index is 37 out of 100 (grade D: more problems than a typical Oldsmobile Cutlass year, for its age). The index weighs complaints, crashes, fires, injuries, deaths and recalls against how long the vehicle has been on the road, compared with the same model's other years. It is not a measure of every repair - read the complaints and owner experiences, and have any used vehicle inspected before you buy.
Which Oldsmobile Cutlass years have the most complaints?
1998 (163), 1997 (140), 1989 (113). See every Oldsmobile Cutlass year compared.
What should I do if my 1979 Oldsmobile Cutlass has a problem?
If it is a safety problem, stop driving it if it is unsafe and contact your dealer. Report it to NHTSA at nhtsa.gov/report-a-safety-problem - enough reports start investigations and recalls - and share your experience here so other owners know what to look for.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data