Latest vehicle recalls

Certification labels contain errors in the vin code. On some 1984 and 1985 buses the check digit contains a "dash (-)" rather than the required number (8). Also on some 1984 buses the code for the year of manufacturer is incorrect. The tenth...

Fitting of the ball joint between the cruise control lever and the connecting rod may be tight causing binding which affects the throttle return action...

Clutch cable is not properly secured causing the cable to contact the master cylinder brake pipe. Consequence of defect: over a period of...

The unexpected open throttle causes an increase in engine speed which could result in loss of control of the car and a potential crash...

Excessive tolerance variation may have created a gap between the bumper bracket rail and the right front frame of the rear side member. This could result in insufficient spot welding adhesion at this location. Under rear impact conditions...

Nylon fuel lines on the fuel return side of the fuel pressure regulator assembly may crack. Consequence of defect: fuel line could...

The fan blade, when subjected to high stress levels, can fatigue and break apart at the hub while the engine is running. Consequence of defect: if breakage...

Motorhomes exceed the load carrying capacity of the s10 chassis due to inadequate sized rear axles and axle bearings. Consequence of defect: failure of rear...

The rear brake release time may be greater than the time specified in fmvss 121, "air brake system". In addition, some tractors may have warped parking brake apply springs which also effect the rear brake release time...

Incorrect bolts were used in the transmission linkage adjustment mechanism. Consequence of defect: the transmission...

The generator "bat" terminal located on the rectifier end frame may contact the carburetor fuel inlet pipe. Consequence of defect: the "bat" stud...

The ln-2 passenger seat may not comply with fmvss 207 requiring that the seatback remain in its set position when subjected to a 3300 inch pound rearward force...

Cars may lose the wire snap rings that hold the differential cross shaft in position in the rear axle differential case assembly, allowing the shaft to move...

The electronic engine control wiring harness insulation may be damaged due to copper spikes produced during the welding of its wires. This creates a potential for a short circuit between the wires which energize the fuel pump, causing some fuel...

An aluminum casting flash on the face of the throttle body may break off and become trapped between the throttle plate and the bore in the throttle body...

The certification label located on the left front door did not include a required federal certification statement. Consequence of defect: vehicles do not...

The clearance between the brake line at the rear axle and fuel tank retaining band is not wide enough and allows the line to contact the band during severe operating conditions. Continued contact may cause the damaged brake line to restrict the flow...

The dual double check valve may not release the proper air volume to the brake system, causing a slight timing delay between the tractor and the trailer brake system...

In certain high salt areas, the idler arm is exposed to road salt which causes the dust seal to deteriorate resulting in idler arm pin corrosion. This causes the pin to freeze and break...

Main fuel tank filler cap may disengage suddenly when removing the cap for refueling. The sudden cap disengagement permits expulsion of vapor and under some circumstances, sprays gasoline around the surrounding area or persons...