Latest vehicle recalls

Rear brake relay valve control line was connected to the secondary double check valve, rather than the primary one. Consequence of defect: these trucks...

A part of the steering gear housing which attaches to the frame may break. Consequence of defect: steering...

Certain vehicles are equipped with water pump pulleys which may contain a manufacturing defect, reducing the durability of the pulley...

The right hand frame rail lower flange could develop cracks due to poor grinding methods at stress points. Consequence of defect: frame failure...

The splined steering shaft may not be sufficiently engaged as designed due to inaccurate drilling of the holes in the frame to which the cab front mount member is bolted. Under certain conditions the steering shaft may disengage...

The wheel may develop cracks between the disc and rim. Consequence of defect: if this occurs and is not noticed, the crack could increase around the rim, resulting in...

The lp gas lines for the refrigerator and furnace may contact the top of the rear suspension system causing damage or rupture of the propane line...

The body is subject to shift forward during an impact and the fuel filler hose and/or fuel vent line hose may separate from either the fuel filler neck or the gas tank. This does not comply with fmvss 301...

The positive battery cable may contact the upper control arm or exhaust manifold shield and eventually wear through the insulation and ground the cable...

The latch of the passenger side sliding door may become damaged if excessive force is used to close the door. The damaged door lock mechanism will not properly engage and the door could open if vehicle is driven over bumpy roads...

The fuel feed and fuel return pipe assemblies includes a hose which may contact the pointed end of the radiator shroud attaching screw. This could cause a gasoline leak...

Incorrect tail lamp lens were installed, lens do not conform to fmvss 108, lamp reflective device and associated equipment. Consequence of defect: in times of...

The steering column is connected to the steering gear by means of splined shaft couplings. These couplings are secured with a transverse bolt and lockwasher. It was found that the bolt was not tightened and torqued to specifications...

Rear supension control arm-to-spindle attachment bolts may be subject to fracture causing the rear spindle to separate during use of car...

Sanders were installed without reinforcement plates at point where mounting angle brackets are attached to the bus body floor channel. Floor channel may crack, possibly allowing the sander to become detached from the bus body floor channel...

The compliance label installed incorrectly lists the gross vehicle weight rating. Consequence of defect: trucks do not...

The fuel shut-off valve in the generator compartment may contact a battery cable terminal or the starter solenoid of the 7000 kohler generator. This contact causes an electrical short circuit and possible fuel line leakage...

Certain of these vehicles may have been built with contaminated brake fluid. Consequence of defect: this can...

Jeeps may have an improperly connected fuel line fitting which could become disconnected and cause gasoline to be spilled. Consequence of defect: if the fuel line...

Generator tailpipe can become damaged so that it terminates under the motorhome body allowing exhaust gases to leak under the motorhome and seep into the motor home...