Latest vehicle recalls

The bolt in the upper steering column u-joint clamp may have been over torqued and may break. Consequence of defect: a broken u-joint...

The push-pull headlight switch may have electrical contacts which allow an intermittent headlight circuit causing headlight to flicker or suddenly go out...

The brass fitting on one end of the low pressure lp gas hose could be inadequately crimped to the hose allowing gas to leak. Consequence of defect: a leak could...

Battery cap vents may be partially or completely blocked with plastic flashing. Consequence of defect: a build up of...

Front axle springs may crack in the spring eye area. Consequence of defect: spring could become detached severely limiting vehicle control which may lead to an accident.

Trucks were built with headlamps wiring harnesses which may have the "upper beam"/"lower beam" wires reversed. This causes the trucks not to be in compliance with fmvss 108...

The six position fuse junction block may have a bus bar installed on the secondary side of the fuse box. Consequence of defect: the circuits...

The outside rear view mirrors do not meet the 50 square inch minimum requirement of fmvss 111-rearview mirrors. Consequence of defect: the standard...

Left side drive shaft could develop cracks near the outer joint.

A cotter pin in the brake pedal to brake master cylinder linkage assembly may be missing. This pin acts as a retainer for the brake master cylinder pushrod clevis pin...

The throttle angle sensor on the carburetor may contain a nylon rotor which has not been heat treated. Rotors that have not been heat treated contract in the presence of heat causing the throttle mechanism to stick...

Transmission magnetic drain plugs may have been broken during assembly. Consequence of defect: the broken...

Front steering knuckle thrust bearing may shatter into pieces due to improper heat treatment. Consequence of defect: failure of the...

The right quarter windows may contain glass which was improperly tempered. This glass may yield pieces larger than the maximum allowed by fmvss 205, glazing material...

The lower control arms, which support the rear wheels, are subject to corrosion if operated in areas where a large amount of road salt is used to aid in snow and ice removal...

A wiring harness located under the instrument panel may not have been properly secured in its retainer and could interfere with the accelerator lever...

Motor homes were built with clear plastic lenses and bulbs in the front turn signals instead of amber colored, which is in noncompliance with fmvss 108-lamps, reflective devices and associated equipment...

Improper adjustment of entrance door causes latch to fail in the secondary latched position. Such failure places the motorhome in noncompliance with fmvss 206, door locks and door retention...

Gross weight ratings and tire pressures information on the certification label are incorrect, these do not comply to federal regulation part 567...

The throttle return spring assembly may fail preventing the throttle from returning to the closed (idle) position when the accelerator pedal is released...