Latest vehicle recalls

There may be insufficient thickness of adhesive in the contact area between the bottom of the front windshield glass and the body. Consequence of defect: this lack of...

The rubber that encases ball stud and socket joint (connects steering drag link and pitman arm) may deteriorate, causing metal to metal contact, and may eventually result in complete separation...

Left handed driver's side shoulder belt anchor plate may be upside down in lock pillar so that the unthreaded slot of the plate aligned with the hole in the lock pillar. This resulted in the anchor bolt being driven into the slot instead of the...

Composite graphite driveshafts are subject to overheating while idling, which may result in the driveshaft twisting and shortening causing the slip yoke to disconnect from the transmission...

The bumper mounted cab entry step may fail due to improper welding or to nuts which attach the step pulling through the bumper lining...

Bolts in pivot shaft that attaches the swing arm to the frame may not be torqued to specifications. Consequence of defect: bolts could lose...

The aluminum wheel hubs develop cracks near the inner wheel bearing, allowing loss of bearing lubricant. Consequence of defect: the hub failure...

The tailgate child lock can be opened from inside when the child lock is engaged. The feature to prevent the tailgate from being operated from the inside of the station wagon may not function properly...

The forward bolt that provides part of the attachment between the driver's seat back assembly and the seat cushion frame may be subject to fatigue fracture...

Two throttle return spring defects are involved in this recall. (1) Buses equipped with caterpillar engines may have a throttle return spring that breaks and prevents the throttle from returning to idle position when the driver's foot is removed from...

The protective sleeve covering of the return fuel hose between the pressure regulator and fuel return pipe was shortened leaving part of the hose exposed. In some instances this part of the hose becomes kinked due to the engine compartment heat...

An interference with the fit of the wheel to the front hub lugs could result in loosening of the lug nuts while driving. Consequence of defect: loosened wheel...

The engine air cleaner plastic trim cover could fall off the air cleaner assembly and land on the exhaust manifold creating a fire hazard...

An incorrect steering shaft retaining nut is installed on the shaft and can loosen causing steering play. Consequence of defects: if nut is not...

Headlamp covers were installed on vehicles in error. Causing the cars not to comply with fmvss 108, lamps, reflective devices and associated equipment...

The right rear tail lamp assembly may be incorrectly assembled. The misassembled units will result in reduced illumination which will cause the lamp assembly to be in non-compliance with fmvss 108 lamps, reflective devices, and associated...

An incorrectly indexed wiring harness may cause the center high mounted stop lamp to remain illuminated when the headlights or parking lamps are on. Fmvss 108 lamps, reflective devices and associated equipment requires that this stop lamp...

The center control arm of the steering linkage system may develop a crack if the steering wheel is repeatedly operated while vehicle is in parked position. The steering center arm may eventually break...

The rear wheel brake lines are subject to damage from road debris which would cause brake fluid leakage. Consequence of defect: brake fluid loss...

The wheel lug nuts may have been improperly tightened. Also, the steering shaft clamp bolts may not be properly tightened. Consequence of defect: improperly...