The push pull headlight switch may have electrical contacts which allow an intermittent headlight circuit causing headlight to flicker or suddenly go out...
Updated daily from NHTSA
Latest vehicle recalls
45 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
In the event of a low speed frontal impact, engine movement could cause the throttle cable sleeve to be pulled out of the adjusting fitting and not return to its original position or idle position...
Parking brake lever mechanisms may not properly engage when applied as required by fmvss 105. Consequence of defect: vehicle could...
The circuit wire for the trailer stop light may not be connected to the output terminal of either the tractor spring brake stop light switch or the service brake stop light switch...
Covers1986 Peterbilt Peterbilt
A required weld joining a walking beam bushing spacer to the axle hanger bracket may have been omitted. Consequence of defect: rear axle could...
Inadequate fastening of the brackets to the frame rail for holding the hydraulic brake and gas return lines may allow flexing and possible chafing of the line...
Fuel tanks may have been scored or penetrated when floor pan mounting holes for the partitions were drilled. Consequence of defect: fuel leakage may...
Covers1986 Ford Aerostar
The left and right rear lower control arm ball joint stud to knuckle attachment may have been inadequately tightened. Consequence of defect: this could allow...
Covers1986 Oldsmobile 88
The secondary hood latch may be incorrectly aligned, or may exhibit a binding condition of the latch pivot. Consequence of defect: this condition...
Severe and unusual braking conditions may cause damage to the brake master cylinder center valve. Consequence of defect: if sufficient...
Covers1986 Chevrolet Corvette
The handhold mounting system, which consists of a tubular handle held in three places by cast aluminum brackets and attached to the engine exhaust muffler heat shield. Vibration from this system causes the handhold parts to wear...
Three bolts which attach the sill that supports the base of the seat were omitted; therefore vehicles do not comply with fmvss 210 and fmvss 207...
During a combined cornering and braking maneuver, the tie rod end could contact the tire wall. Consequence of defect: this contact can...
Rear or front right seat belt locks may not properly engage. Consequence of defect: seat belts could...
Trucks fail to meet requirement of fmvss no. 301, Fuel system integrity, in a 30 mph front angular barrier test impact because of the omission of the nose shield on midship fuel tank...
Under certain conditions, contacts in brake system relay could remain closed, causing the brake pump motor to run continuously, causing it to overheat and eventually fail...
The ignition lock cylinder may hang up and not fully return to the "on" position from the "start" position after starting the engine. If this occurs, the engine will remain running, but the battery current to the brake system supply...
Steering column mounting bolts may be absent, leaving only the knee pad to hold the steering wheel and column in place. Consequence of defect: under certain...
Misadjustment of fuel distributor allows fuel to escape and be absorbed by the air filter. Consequence of defect: with the fuel...
If a certain type of rear end collision occurs, the edge of a welded bracket on the floor panel subframe may pierce the fuel filler pipe...
Covers1986 Nissan Stanza