Latest vehicle recalls

Steering centerlinks may break at a bend location.

Accelerator control cable may contain water which could freeze while vehicle is parked causing travel of accelerator control cable to become restricted when throttle is initially opened.

Crossmember can be overstressed and can fail, allowing the broken crossmember to protude above the top of the frame and interfere with chassis components.

Air pressure indicator line may be improperly secured to the frame and could interfere with the shift linkage causing a small leak.

Trucks failed to comply with requirements of fmvss 301, fuel system integrity, during a 30 mph frontal barrier test.

Neutral safety switch may become permanently closed, allowing vehicle to be started in any gear.

The idle stabilizer may experience excessive wear, causing engine idle fluctuations, usually described as engine surge, which increase with usage of the car.

Sudden acceleration from a stationary position may occur, when shifting from park to reverse or drive.

Heater hose may chafe primary and/or secondary hydraulic brake lines at the master cylinder.

Console front compartment door may not remain closed during load forces that may be experienced in a crash as required by fmvss 201.

Deformed brake rod covers may interfere with return of accelerator pedal from open throttle position. Consequence of defect: engine would not...

Rubber that encases ball stud and socket joint (connects steering drag link and pitman arm) may deteriorate and cause metal to metal contact...

Incorrect lock washers may have been installed on the tilt steering column pivot bushing bolts and the column housing pivot may be misaligned...

Under certain vehicle load or road conditions, part of the front structure, where it is attached to the front suspension panhard rod, may break...

Cracks can develop in the hub in the inner wheel bearing area. Consequence of defect: oil leaks could...

Secondary hood latch may not properly engage due to contact with support bracket and/or the primary latch return spring. Consequence of defect: if this occurs...

Part of pushbutton attachment of headlight switch may fracture. Consequence of defect: push button...

A stud may have been installed on top of the intake manifold of engine that could contact the fuel supply hose. Consequence of defect: chafing of the...

Steering linkage couplers remained in acid etching bath too long. Consequence of defect: couplers could...

The circuit breakers may fail and allow the circuit to overheat. Consequence of defect: a fire could...