Latest vehicle recalls

More fuel than permitted by fmvss 301 may escape from the fuel tank assembly under the test conditions described in the standard. Consequence of defect: if the car is...

A resistor in the electronic panel cluster may be subjected to an electrical current overload due to failure of a switching transistor...

Wiring connections in an electrical connector to the master cylinder reservoir fluid level sensors were reversed and fail to indicate low fluid levels as specified by fmvss 105, hydraulic brake systems...

A battery cable routing change may cause the positive cable to rub against the right front spring rear hanger, possibly causing a short circuit in the cable at the point of chafing...

Large size particles in the steering hydraulic system fluid causes a solenoid valve orifice to plug and malfunction. Consequence of defect: this could...

The center bracket, one of the three used to hold the grab handle in place, contains a rivet which may not be properly align. This allows a small gap to exist between the rivet head and the bracket...

First rear seats were installed with an incorrect left side seat riser which causes failure to comply with the seat and seat belt loading requirements of fmvss 207, seating systems...

The spring eye bolt was not torqued properly and could fail due to the loose fit within the spring eye bushing/hanger bracket. Consequence of defect: the spring could...

There may be inadequate welding in some underbody structural areas, including those at the rear suspension attachments, which may cause it to separate...

Left or right cab step may crack in its welded area due to flexing of the step during entering and exiting. Consequence of defect: as the cracks...

The accelerator rod hole clearance is not adequate and can cause the accelerator linkage to bind. Consequence of defect: if binding...

Incorrect inner wheel bearings were installed in the rear axles which wears a groove in the spindle due to a poor fit. Consequence of defect: a deep groove...

Certain brake master cylinders may have been overstressed and cracked during manufacture. Consequence of defect: a cracked...

Retaining bolts used throughout the car which ground certain electrical systems and components were improperly heat treated, making the bolts brittle and subject to breakage...

The central tube part of the drag link, which is set in a rotational position, does not have enough clearance between the nut or bolt head and the axle beam...

Fmvss 121 requires that the air operated oil line to the wet air pressure tank contain an automatic high pressure valve to protect the brake air lines. This pressure valve was omitted...

Dislocation of a spring cover will not allow the shoulder belt to retract after being extended. Consequence of defect: although...

The hydraulic parking brake control valve may inadvertently activate due to momentary pressure disruptions within the system and cause the parking brake to be applied, stopping or slowing the truck unexpectedly...

Vans equipped with the optional sunscreen rear glass which has less than 70 percent luminous transmittance and does not have a passenger side outside rearview mirror are not in compliance with fmvss 111, rear view mirrors...