Thomas MVP Problems by year

Certain my 2000-2003 freightliner, thomas mvp school bus and western stars trucks manufactured between november 19, 2000, and march 30, 2005, and equipped with webasto coolant heaters, model dbw 2010, assembled with webasto burner tubes, p/n 303046/26533a...

Certain school buses with weldon technologies' 5050-1400 surface mount marker lights have an option to replace each of the twelve clearance/marker/identification lights with four-candlepower lights, twice the candlepower normally used. The higher current...

Vehicle description: school buses equipped with neway ad 200 rear air suspensions. There is interference between the suspension u-bolt and the rear axle which can cause the u-bolt to crack and fall off.

Vehicle description: transit and school buses equipped with cummins isb or caterpillar 3126 engines. A decal that warns of the danger of using ether or other starting fluids in the engine air intake system was omitted. The label should be located on the...

Vehicle description: transit and school buses equipped with electronic engines. The bottom edge of the accelerator pedal can catch on the floor mat when the pedal is fully depressed. This does not meet the requirements of fmvss no. 124, "Accelerator...

Vehicle description: school and transit buses. The mounting bolt for the upper front shock absorber bracket can loosen in service due to the omission of a frame reinforcement from the upper shock absorber mount. The loosened bolt could then work in the...

Vehicle description: school and transit buses equipped with national seating series 93b-sb driver seat. A bracket attaching to the height adjusting shock absorber on the driver's seat can deform and break.

Vehicle description: school and transit buses equipped with non-electronic cummins b5.9L engines. The sliding action of the accelerator linkage lever over the hand throttle cable can cause the hand throttle wire to wear a notch in the accelerator linkage...

Vehicle description: school buses. The flip seats installed on these buses do not meet the rearward push requirements of fmvss no. 222, "School bus passenger seating and crash protection."

Vehicle description: school and transit buses. If debris becomes trapped between the plastic cup, which seals the opening where the steering column comes through the bus floor and the steering knuckle, the steering linkage can bind.

Vehicle description: school and transit buses equipped with in-line six engine,"s" type frame rails and side mounted battery box. The battery cable routing allows the positive cable to chafe resulting in a possible short circuit of the cable.

Vehicle description: school and transit buses equipped with cummins 6b engines and delco alternators. The battery cable routing allows the cable to contact the exhaust manifold.