Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Body, doors & structure

2003 Toyota 4RUNNER Body problems

Owners have filed 291 complaints about the 2003 Toyota 4RUNNER's body, doors & structure with NHTSA - 41% of all its complaints, most recently on January 16, 2026. They describe 3 crashes, 0 fires and 0 injuries. Doors, hoods and latches, frame rust, sunroofs, leaks, trim and structural failures.

Complaints
291
Recalls
0
Crashes
3
Fires
0
Injuries
0
Deaths
0

Body complaints

Body, doors & structure

Severe frame rust. 2 large holes on the inside of the frame just back from the front wheels and 2 large holes at the ends of the rear crossmember.

Filed Incident StructureNHTSA 11711459
Body, doors & structure

My vehicle: 2003 4Runner SR5 2WD VIN: [[redacted]] Issue: Front driver's side door will not open. Electronic locks are operating, but the door release is not functioning. Safety Concern: What if I was in a situation where I did need to get out of the vehicle immediately? Such as a high-water incident, fire, etc. Especially for a person [[redacted]], as myself, this would be a big issue. When attempting to exit the car after pulling into the driveway, I could not open the driver's door. The locks would release,...

Read the full complaint

but the door latch would not. I had to crawl over the console to get out through the passenger side. This was not easy as I had back fusion surgery and 8 disc replaced, fused. I had to open the sunroof to help with get over and out. After I did get out, I tried the key in the driver's door, it would actuate the door locks on all doors, but the driver's side door latch would still not release. I even disconnected the battery and reconnected. No help. And after knowing more, it was not an electrical issue, but mechanical failure. I now have it at the repair shop after talking with Toyota Service manage who admitted it was a poor design as the repair for this is to destroy the door panel to get to the actuator to attempt to release the door latch. The estimate for this work is 1,150.00. I am beyond frustration, and especially when I see there is no recall for this issue. There are penty of conversations on this same issue on 4Runner forums as well as all over YouTube. Thank you for looking into this. You can reach me at: [[redacted]] [[redacted]] [[redacted]] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Incident Latches / locks / linkagesNHTSA 11662305
Body, doors & structure

Toyota has had issues with their frames rusting out and the 4th generation 4Runner is not exempt from this issue. My 2003 is requiring extensive work to keep it on the road safely due to frame rust. A recall to replace frames should be in place.

Filed Incident StructureNHTSA 11619222
Body, doors & structure

There is major corrosion on the chassis, brake-power steering-transmission lines, and all metal brackets on the frame and engine. The corrosion is so bad there is holes on the chassis. Known issue, many complaints, Toyota Corp. says to keep calling back maybe something will be done in the future. Unable to upload photos!

Filed Incident StructureNHTSA 11561325
Body, doors & structure

Severe frame rust, there was a recall for tacomas but 4Runners have the issue just as bad

Filed Incident StructureNHTSA 11551123
Body, doors & structure

The contact owns a 2003 Toyota 4Runner. The contact stated that upon taking the vehicle to several independent mechanics for servicing, he was informed that the subframe was significantly corroded and needed to be replaced. The vehicle was not repaired. The dealer was not notified of the failure. The manufacturer was notified of the failure and informed the contact the vehicle was not covered under recall. The failure mileage was approximately 115,000.

Filed Incident StructureNHTSA 11537118
Body, doors & structure

The contact owns a 2003 Toyota 4Runner. The contact stated that while the vehicle was at the tire retailer for tire replacement, the technician informed him that the subframe was corroded. The vehicle was then taken to an independent mechanic, who diagnosed that the passenger's side front and rear subframes were severely corroded, as well as the cross member. The mechanic advised the contact to stop driving the vehicle. The dealer was made aware of the failure and informed the contact that there was no recall associated with the VIN. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 165,000.

Filed Incident StructureNHTSA 11503828
Body, doors & structure

Extensive rust through out frame, resulting in holes in structural members. Leaving frame in a weak and vulnerable state.

Filed Incident StructureNHTSA 11501555
SuspensionBody, doors & structure

I purchased this 2003 Toyota 4Runner in 2018 under what I assumed was prime condition, for a vehicle that spent the majority of its life in Nebraska/Kansas before I moved to Texas in 2021. At 87,400 miles at the time of purchase, the vehicle had no visible damage to the exterior besides a few paint chips, some minor hail damage and scratches, and some easily fixed surface rust in the paint on the tailgate. The previous owner had driven it leisurely and had kept the miles low after 15 years. The car has had some...

Read the full complaint

mechanical issues, but nothing out of the ordinary outside of some regular maintenance over the first few years. Being close to 100,000 miles, the timing belt and pump was replaced around 98,000 miles. Other issues have been fixed periodically, please reference the attached files. After joining a Toyota 4Runner 4th Generation Facebook group and seeing a post about another's issues with rust damage in October 2020, I decided to take a look at my own frame. I then inspected my own vehicle, and found significant frame rot damage. It is extensive, with significant rust to the frame, with large holes and soft patches that question the integrity of the frame and the safety of the vehicle on the road. Every time I hit a small bump or pothole, I fear the frame will crack and I will lose control as others have. I have not sought out professional repairs due to the extensive cost, and am awaiting the outcome of a current class action lawsuit by the Bell Legal Group. The 4th Generation Toyota 4Runner (2003-2009) is built on the exact same frame as the Toyota Tacoma of that era, yet while the Tacoma was recalled for frame rot, the 4Runner was not included, which I believe to be a gross oversight in previous legal proceedings. The 2003-2009 Toyota 4Runner is a reliable vehicle, but poses significant frame rot issues much earlier than should be expected.

Filed Incident Suspension · Structure · Unknown or otherNHTSA 11500005
Body, doors & structure

Vehicle frame has rusted through and has holes affecting structural condition.

Filed Incident StructureNHTSA 11495953
Body, doors & structure

Excessive frame rust causing difficulty to keep vehicle on the road. No warning lamps, I noticed the rust starting years ago, now the rust is so bad that the frame is rusted through causing difficulty steering and loud crunch noises. I contacted Toyota Consumer Affairs explaining the rust concern and asked if I needed to take the vehicle to a dealership for inspection, they said it wasn't necessary (sounds like they don't want to admit the existence of a possible manufacturing defect). The vehicle is available...

Read the full complaint

for inspection. I feel like I would be doing a disservice to society if I continue to drive this vehicle on public roads due to the danger of injuring a pedestrian or another motorist.

Filed Incident StructureNHTSA 11479718
Body, doors & structure

So much rust has developed the frame is literally giving out. Toyota admitted to a rust issue- it's now a safety issue with this generation of 4Runner. They did a recall on the same frame for Tacoma but not 4Runner.

Filed Incident StructureNHTSA 11470783
Transmission & drivetrainBody, doors & structureEngine & cooling

The frame of the car has been rusting at a significant rate in the last 4 years. Mechanic identified major rust issues that would make the vehicle not safe in case of an accident.

Filed Incident Power train · Structure · EngineNHTSA 11463988
Body, doors & structure

I have two 2003 Toyotas, a tundra and 4runner. The 4Runners frame is rusting out everywhere including the welds. My mechanic said it was getting to the point that it's dangerous to drive and if it was in a wreck the frame would likely fail under the stress. My tundra frame from the same year is immaculate. I believe the are similar frames. This is obviously a defect in the production based on my readings and is very common. The investigation was opened in 2018 and its now 2022, when will this get addressed!

Filed Incident StructureNHTSA 11459345
Body, doors & structure

Frame has major rust holes towards the front inside next to the catalytic converters. Hoping to get them repaired before frame failure. The frame design is similar to the 2005 to 2015 Tacomas, which experienced similar issues with rust damage causing frame integrity issues. Toyota had a program to replaced those frames, but not for the 4Runners. The issue seems to be caused by certain factory openings in the frame that allow road salt to enter into the frame cavity, and cause the inside to rust. Being next to the...

Read the full complaint

catalytic converter, the heat accelerates the rust. On my 4Runner, the issue has gotten worse in the last 2 years. I cannot understand why Toyota covered all other trucks/suvs that use this similar frame but ignored the 4Runner.

Filed Incident StructureNHTSA 11458884
Body, doors & structure

The frame on my 4Runner is rusting through in multiple locations. The rear of the frame has already failed and a trailer I was pulling dragged on the road heavily as it failed. Definitely at risk of caving in long before the engine or transmitoo fails.

Filed Incident StructureNHTSA 11458230
Body, doors & structureCrash

The frame on my vehicle is rusting prematurely. It's doing this on many other 4Runners and other Toyota trucks.

Filed Incident Structure · Unknown or otherNHTSA 11448877
Body, doors & structure

The frame of the vehicle is rusted to the point my fist can fit through a hole in the frame.

Filed Incident StructureNHTSA 11439132
Body, doors & structure

The frame on the vehicle is rusting out. If not repaired, serious injury could occur if the frame breaks. A compromised frame could cause serious injury if an accident occurs. The driver side main frame has a gaping hole on the inside and another hole forming underneath that is in close proximity to the larger hole. The entire back cross bar member supporting the bumper is rusting out as well as the front cross bar member. The vehicle was inspected in July 2020 and the dealership said the frame was OK and had...

Read the full complaint

plenty of life left in it. After getting a muffler installed at a local independent shop in October 2021, the hole grabbed the attention of the technician. After inspecting, rusty flakes kept falling away.

Filed Incident StructureNHTSA 11437422
Body, doors & structure

Extreme frame rust. The vehicle has extreme frame rust and Toyota should be held accountable for poor quality frame material. I have heard tons of stories of other peoples steering components snapping due to rust and frame damage.

Filed Incident StructureNHTSA 11435309
SuspensionBody, doors & structure

I own a 2003 Toyota 4Runner with very low mileage for its age. It has been garage kept for most of its life. I was experiencing difficulty steering, and when I took the car to a mechanic, it was determined that the frame was prematurely rusted and rotted to a dangerous level putting my life at risk while driving it.

Filed Incident Suspension · StructureNHTSA 11434215
Body, doors & structure

The frame is rusted very bad and it's a major safety issue for this type of vehicle I don't know when it's going to fall apart. I am sure I am not the only one to have this problem.

Filed Incident StructureNHTSA 11434037
SteeringBody, doors & structure

Vehicle frame and suspension components are completely rusting out. Having issues with the corroded steering column lower shaft not allowing the vehicle to turn properly.

Filed Incident Steering · StructureNHTSA 11433481
SuspensionBody, doors & structure

The contact owns a 2003 Toyota 4Runner. The contact stated that while driving at limited speeds of 45 mph, the vehicle would wobble and swerve and was very unstable. The vehicle was taken to a Certified Auto Mechanic Shop and an independent mechanic who diagnosed that the failure was caused by severe rusting, perforation and corrosion of the rear subframe and suspension system. The vehicle was also driven to Muffler Shops in Bladensburg, MD on 8-20-2021, and on 10 -22-2021 to Hyattsville Toyota's Certified Toyota...

Read the full complaint

Collision Center for Repair Estimates of $4,000.00 and $7,268.00. The vehicle frame manufactured by Dana Holding Corporation which really requires fixing or replacing was not yet repaired. The Toyota manufacturer and local dealer Global Auto Outlet were notified of the failure. The approximate failure mileage was 1 85,000. The used vehicle was purchased from Global Auto Outlet in Temple Hills, MD for $9,552.24 on 8 -1-2019 with 175,000 miles on the odometer. The windshield had a crack in it, the air conditioning & emergency brake didn't work. The Complainant hadn't noticed the perforated excessive rust corrosion on the undercarriage of the vehicle until numerous months afterwards. Moreover, at the time of the purchase the Owner also didn't notice that the spare tire carrier was rusted, as well as undiscovered that the wrong size 265/65/17 spare tire it was held in was perforated and flat. After the purchase of the vehicle shortly later, the exhaust tailpipe rusted broke first and the muffler had to be replaced which costed $258.79. The Owner was nervously forced to operate a more than unsafe motor vehicle for up to 6 months.

Filed Incident Suspension · StructureNHTSA 11432719
SteeringSuspensionBody, doors & structure

At the end of June 2021, while driving I experienced a loud clunk and grinding noise, with reduced control of steering and brakes on my 4Runner. I took the 4Runner to a Goodyear Automotive Service Center on Woodward Avenue in Royal Oak, Michigan, who told me that the vehicle was not driveable due to severe rust damage of the frame that resulted in a broken sway bar. I thought I should take it to the closest Toyota dealership in Troy, Michigan for advice and they responded that the vehicle was beyond repair and that a new frame would cost around $20,000. I could not leave my car there, and risked driving it home, where it has been parked ever since.

Filed Incident Steering · Suspension · StructureNHTSA 11431046

Toyota 4RUNNER body complaints by year

4RUNNER body problems, every year

Had a body problem with your 2003 4RUNNER? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience