Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Electrical system

2011 Winnebago Journey Electrical problems

Owners have filed 2 complaints about the 2011 Winnebago Journey's electrical system with NHTSA - 100% of all its complaints, most recently on January 27, 2021. Dead batteries, warning lights, wiring, alternators, infotainment and electronic module failures.

Complaints
2
Recalls
1
Crashes
0
Fires
0
Injuries
0
Deaths
0

Electrical recalls for the 2011 Winnebago Journey

Electrical system

12V5660001,521 vehicles affected

The problem
Winnebago Industries is recalling certain model year 2010-2013 Winnebago Journey and Tour motorhomes, and certain model year 2010-2013 Itasca Meridian and Ellipse motorhomes, manufactured June 18, 2010, through November 17, 2011. The chassis are equipped with connectors for diode jumpers that may come loose, resulting in an open circuit. Two circuits are affected: The one that disengages the cruise control with brake pedal use, and the one that illuminates the brake lights with brake pedal use.
The risk
Failure of the cruise control to disengage when the brakes are applied may increase the risk of a vehicle crash. Without the brake lights illuminating when the brakes are applied, the driver's intent is not communicated, increasing the risk of a crash.
The fix
Daimler Trucks North America will be conducting the recall on behalf of Winnebago Industries. Daimler will notify owners, and dealers will inspect the the diode jumpers to make sure they are fully locked in place and will correct the vehicles as needed. The recall began December 26, 2012. Owners should contact Winnebago at 1-641-585-3535 or Daimler Trucks at 1-503-745-6910.

Electrical complaints

Electrical systemSeats & seat beltsBody, doors & structure

Rv slideouts often have passenger seating. On certain models of power gear slide systems, there is a lock system to ensure that the slideout can't move while driving. These locking mechanisms circa 2010 - 2012? Were defective and often jam in the unlocked position. The operator has no way of knowing that the lock is inoperative and not holding the slideout closed. This presents a danger to the integrity of the coach as a vehicle in motion, and a danger to passengers who are seat-belted into the slideout. In 2012...

Read the full complaint

powergear and kwikee (both divisions of lippert ( lci industries) & winnebago offered an "upgrade" kit to fix this slideout locks problem. This should have been a safety recall! Attached is the powergear bulletin regarding the kit supplied to 'upgrade' the locks so they would not fail in the open position. I have tried to get lci to acknowledge this problem, and they refuse. This problem exists on many brands of rv's that use the powergear arm and pinion slideout mechanisms. A web search of the rv forums will yield stories of rv owners who have had various standings and major problems because of the failure of these locks. My personal experience is only that I discovered these locks on my coach were not working and am deeply concerned for my safety because of the risk posed by two of my slides not being locked. Lci has declined to do more than offer a 25% discount on the entire slide mechanism (much more than needed to repair this issue).

Filed Incident Electrical system · Seat belts · StructureNHTSA 11390312
Electrical system

While operating the driver front slide, the harness that encases electrical wires in a plastic chain, did not flow back into the box designed for it. The plastic chain failed and the harness backed up and got wedged between the area it slides into and the exterior of the slide outside the motor home squashed the harness and electrical wires. And of course, because you are inside the rv closing the slide, you don't see the damages until its too late. That harness also is attached to a metal bracket which is in...

Read the full complaint

return attached to the moving slide. With 50 amp service plugged into the rv, I believe this could be a severe electrical hazard. The plastic chain harness also became detached from the rear of the "box" it slides into which is supposed to be permanently attached to the rv. I have pictures of the damages when this happened to my coach. I have also reviewed internet forums. There seems to be a consistent problem with this design. It's my opinion that electrical hazards like this could cause bodily injury or start fires. I am surprised that I have not seen, nor gotten, any recalls for this issue. I have heard others say that this was a bad design, and yet winnebago industries knows this, will not elaborate on their technical fix, or a put out a recall on this problem so that it doesn't happen again to us or others. Without recall, and this happening to someone else, they might not be so luck to rectify this on the road because the damages could be more severe updated 11/14/13*cn

Filed Incident Electrical systemNHTSA 10550407

Winnebago Journey electrical complaints by year

Journey electrical problems, every year

Had a electrical problem with your 2011 Journey? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience