Volkswagen Group of America, Inc. (Audi) is recalling certain 2018-2019 Audi SQ5 and 2018-2020 Audi Q5 vehicles. The rear wheel arch cover trim may loosen and detach from the vehicle.
Body, doors & structure
Audi Q5 Body problems by year
34 complaints filed with NHTSA about the Audi Q5's body, doors & structure. Doors, hoods and latches, frame rust, sunroofs, leaks, trim and structural failures.
Body complaints by model year
Body recalls
Latest Q5 body complaints
The subframe in the Audi Q5 has plastic that is connected to the bottom of the subframe which traps salt, water and dirt which can lead to premature rusting and failure. Because this is where a lot of the suspension and other components are attached to, when this fails during operation of the vehicle, it can lead to loss of control and increase the chance of an accident.
I am reporting a potentially serious safety defect involving the rear subframe/crossmember of my 2009 Audi Q5. I discovered significant corrosion on the vehicle's rear subframe, which is a structural component supporting the rear suspension and rear axle assembly. The corrosion is substantially more than normal superficial surface rust. There is visible rust scaling and loss of material in areas of the rear subframe. The affected area was partially concealed by the factory-installed plastic stone guards/shields....
Read the full complaint
Because these plastic covers obscure the subframe, the extent of the corrosion is difficult to identify during a normal visual inspection unless the covers are removed. I am concerned that continued corrosion could reduce the structural integrity of the rear subframe and potentially compromise the mounting points for the rear suspension or rear axle components. A structural failure of the rear subframe could result in unexpected changes in wheel alignment, suspension movement, loss of vehicle control, or other serious safety consequences. This issue is particularly concerning because the corrosion can develop underneath the plastic protective covers and may not be visible to the vehicle owner during normal operation. Safety Concern The rear subframe is not merely a cosmetic body panel. It is a structural component associated with the rear suspension and axle assembly. If corrosion continues to remove structural material, a suspension mounting point or section of the subframe could potentially weaken or fail under normal driving loads. A failure while the vehicle is being driven, particularly at highway speed, could potentially result in loss of vehicle control. There were no dashboard warning lights or electronic warnings indicating this condition. The problem was discovered through physical inspection of the underside of the vehicle. Possible Design/Corrosion Mechanism The factory-installed plastic stone guards appear to cover portions of the rea
My Q5 has a defective subframe. The system is defective because plastic coverings on the subframes of Audi Q5s and SQ5s trap moisture and other elements, causing the subframe to rust, rot, and corrode undetected, which creates a dangerous safety hazard, the existence and extent of which is concealed by the plastic coverings. This results in a myriad of negative consequences for the Class Vehicles and their safe and reliable operation. The defect, which can only be discovered after removing the plastic covering on the vehicles' steel subframe, leaves an affected Audi vulnerable to "structural instability."
Vehicle failed inspection due to premature rust perforation damage of rear subframe caused by a plastic cover trapping water against the metal. Vehicle otherwise passed inspection.
Severe corrosion of the rear subframe crossmember on a 2014 Audi Q5 Premium Plus, purchased with 65,464 miles. Two independent inspections in South Carolina confirmed structural failure. Audi of Greenville, an authorized Audi dealership, marked the condition as VERY DANGEROUS on the service invoice and quoted $4,711.52 for subframe replacement. They were unable to perform a wheel alignment due to the severity of the corrosion. Yoder's Automotive in Westminster, SC independently confirmed the subframe was rusted...
Read the full complaint
beyond repair on both sides. Fist-sized holes have corroded through the structural metal on both sides of the subframe. The vehicle has plastic stone guard covers bolted over the subframe from the factory. These covers trapped road salt and moisture against unpainted mild steel, accelerating concealed corrosion that was invisible until the covers were removed during inspection. The vehicle is undriveable and has not been driven since the defect was discovered in approximately March 2026. This defect pattern is documented in at least 16 prior NHTSA complaints for Audi Q5 models spanning model years 2010 through 2018. Audi has revised the subframe part number at least five times (8R0505235F through 8R0505235N) but has issued zero recalls and zero consumer notifications.
This vintage 2014 Audi A5 has a well known serious rust perforation issue with the rear subframe. The corrosion / rust through of two major holes, approx 3 inches in diameter, causing structural failure of the sub frame. This is a major saftey concern with these cars from model year 2009 thru 2017. The only remedy is replacement of the sub frame under Audi's 12 year rust perforation warranty or good will.
The contact owns a 2021 Audi Q5. The contact stated that while driving at an undisclosed speed, several unknown warning lights illuminated, and the vehicle stalled. Additionally, the windows independently rolled up and down, and the engine seized. While attempting to start the vehicle, the vehicle failed to start. The contact stated that the failure had occurred three times within five days. The vehicle was towed to the dealer where it was purchased. The failure was diagnosed with a failed gateway control module....
Read the full complaint
The contact was informed that the gateway control module needed to be replaced. The vehicle was being repaired. The contact was informed that the plastic protective bag that covered the gateway control module was filled with water. In addition, the dealer informed the contact that the NHTSA Campaign Number: 21V947000 (Electrical System, Structure); recall repair was performed prior to the contact purchasing the vehicle. The manufacturer was made aware of the failure but provided no assistance. The failure mileage was approximately 37,200.
The contact owns a 2015 Audi Q5. The contact stated that the rear subframe was extremely rusted and could not pass a safety inspection. The vehicle was driven to the dealer, but the vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 82,351.
Vehicle rear subframe comes with plastic covers that trap road salt and cause severe corrosion. Issue only presents itself when plastic covers are removed, revealing rust/corrosion and lost material, and a risk of the subframe to split resulting in lost of vehicle control on the road. This was found as a preventative action due to reports from other car owners and is confirmed by Audi Dealers as a common issue. Labor and parts estimate around $6000 (including $2000 in parts)
Took vehicle in for state safety inspection. Found heavy rust on subframe nearly all the way through. Was told if it gets any worse it will not pass inspection next time. Apparently there are plastic rock shields on subframe that trap water causing it to rust. Took it to dealer and they want to charge close to $4000 to replace. This seems like an engineering defect. The vehicle is kept in a garage and doesn't have any other rust on it.
2014 Audi Q5 TDI with 115000 miles. Rear subframe inspected individually, by independent shop, and by Audi dealership. Found to have severe rust with perforation underneath where plastic debris covers are mounted. It is currently installed on vehicle at time of complaint. The failure of the subframe can disable the vehicle while driving, disconnect the axle and surrounding components, and cause an accident with one or more vehicles on the road. Audi has a 12 year/unlimited mileage warranty but claims it is not covered under warranty. Repair is quoted around ~$6000 including parts and labor.
Incident date: 06/30/25, Lift gate has closed while still trying to retrieve items from the cargo area, it seems if key is on the person and somehow the kick sensor was activated by accident the lift gate will shut down, the vehicle did make a beeping sound yet I was not clear where/what until the lift gate is coming down on me so I had to quickly move, the lift gate was quite close yet no sensor was activated to prevent the lift gate from shutting. This incident occurred prior to this date and I had to manually...
Read the full complaint
push the lift gate up since it was even closer to my body. I did some troubleshooting and read that the key should not be on the person, if so then someone can set off the kick sensor, designed for hands-free operation, can be sensitive and might accidentally trigger the liftgate to close if someone is too close to the rear bumper. Some users report this happening even without intentionally activating the feature. This is a safety issue that a vehicle does not have the sensor to detect an object or body to lift back up. A situation where a 2024 Audi Q5 liftgate closes by itself, potentially causing injury, is concerning. It does appear several factors can contribute to such a malfunction, causing a safety hazard. **Please note I have a video from my from home camera yet unable to upload it. I tried my best to take pictures from the video.
There is severe rust in the rear subframe. It's so bad that the rust has made holes right through the subframe - compromising its integrity. This is a serious safety issue as the subframe holds the suspension and wheels and could break at any point. This is not normal wear and tear. This is a manufacturer's defect and a major safety issue that needs to be addressed immediately.
The rear subframe has plastic "stone guards" to protect the frame from being damaged in off-road conditions. Where these stone guards are attached, the subframe has rotted/rusted large holes. Water and salt from winter seasons can get trapped behind these guards. A subframe on a vehicle at this age should NOT have complete holes rotted through. Let alone a vehicle brand such as Audi, known for quality. The rear subframe connects the rear suspension and AWD drivetrain to the unibody of the vehicle. This is a major...
Read the full complaint
safety concern. It has not been inspected by the manufacturer; my Audi dealer denied this could happen. I am part of a few Audi groups/forums with others facing the same issues, and Audi replacing the subframe under the corrosion warranty. This is a widespread issue amongst the forums. There are no warnings or symptoms as of yet. I noticed the holes 3/17/24. The vehicle has been somewhat sufficient to operate. I just don't want to be traveling down the road with my family in the vehicle if the subframe collapses. I am afraid to fully remove the stone guards as others on the forums claimed that Audi would do nothing for them after removing the guards. Being that they are "protection".
The contact owns a 2015 Audi Q5. The contact stated when the vehicle was driven to the independent mechanic for an inspection for a possible oil leak, the mechanic observed that there was a significant amount of corrosion on the rear sub frame of the vehicle. The contact was advised by the mechanic that the vehicle was unsafe to drive due to the extreme corrosion of the rear sub frame. The vehicle was not taken to a dealer to be diagnosed or repaired. The vehicle was not repaired. The manufacturer was not informed of the failure. The failure mileage was approximately 110,000.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data