Audi Q5 Electrical problems by year

then released the vehicle to me with the instrument cluster inoperative, after assuring me the vehicle was fine to drive. I drove the vehicle on public roads with no speedometer, no gauges, and no warning displays. Within 48 hours, after approximately two miles of driving, the vehicle lost all power again and would not operate. On 11/5/2026, the vehicle would not start. A first tow truck could not jump-start it; a second tow truck succeeded, and when I drove the vehicle out, reverse was not working properly. The vehicle was taken directly to Audi Englewood for independent diagnosis and is not safe to drive. I believe this involves two existing safety recalls. Safety Recall 90VC (NHTSA Recall 25V201) addresses failure of this vehicle's virtual cockpit instrument cluster, where warnings, tell-tales, and gauges that do not display could increase the risk of a crash. Safety Recall 90S9 (NHTSA Recall 21V947) addresses water penetrating the gateway control module on 2021 Q5 vehicles and causing it to shut down. My cluster failed immediately after a car wash and the vehicle then lost all power. The dealership has provided no documentation that the gateway control module was inspected, that any inspection for water intrusion was performed despite my numerous written requests. My concern is twofold: the defect itselfand the fact that an authorized Audi dealership knowingly released a vehicle with an inoperative instrument cluster into service on public roads.

critical central electrical computer completely unshielded in the exact cargo cavity where this water runoff pools. When the Body Control Module shorts out due to this water ingress, it creates an immediate and severe safety hazard. The vehicle experiences sudden, unpredictable electrical malfunctions while in motion, including the risk of uncommanded engine shutdown, a total loss of exterior lighting, failure of the central locking safety systems, and a disabled key transponder system. Audi is fully aware of water ingress vulnerabilities affecting central modules in the floorboards and cargo areas of this platform (as evidenced by NHTSA Recall 90S9 for the Gateway module). However, they have failed to address this identical engineering hazard impacting the BCM in the rear cavity. Leaving an unshielded, critical vehicle operating computer vulnerable to known body leaks exposes occupants to sudden component failures at highway speeds. I am requesting that the NHTSA launch a formal investigation into Audi's BCM placement and sunroof drainage defects to compel a mandatory safety recall.

contacted Audi upon learning of this issue and decided not to move forward with any repairs, but to instead pay out of pocket to have it towed 70 miles to Audi/where we originally purchased the vehicle. This "protective cover" the control module was placed inside was completed as a recall service repair on our vehicle in April of 2022 due to a NHTSA recall announced in December 2021 regarding safety issues in these control modules failing from liquid spills on the backseat. We contacted Audi, explained that liquid had spilled in our backseat and entered the "protective cover" and damaged the control module. They agreed to inspect our vehicle to determine if the "protective cover" had been insufficiently installed. We paid out of pocket to have it towed to the dealership where it took them 6 days to determine the gateway control module is damaged (we had already explained this to them). Although liquid was found in the "protective cover" of this gateway control module, the dealership claims it was installed sufficiently. Upon looking into this matter further, there are numerous complaints of this exact issue (water entering and damaging the gateway control module from a liquid spill on the backseat, even with the "protective cover") on the NHTSA website, as well as a previous class action lawsuit settled out of court in regards to this EXACT issue. THE PRIOR RECALL REPAIR DOES NOT FIX THE SAFETY HAZARD AS STATED IN THE OFFICIAL NHTSA RECALL REPORT.

and the wheel yanked to the left and put me half way into the lane next to me. Thankfully no one was there. I had to yank it back to the right to get off of the highway on to the side of the road. I do not think that the power steering should be associated with that module or at least a water indicator sensor should be added. What happens if someone is on the interstate is driving 75 mph and their power steering goes out. It's in the shop and there is no damage other than now I am scared to drive it

Assistance: The system has experienced unexpected steering pull, which could lead to an unprompted lane departure. Adaptive Cruise Control (ACC): The system consistently fails to detect lead vehicles in 40% to 50% of instances. The most recent failure was documented via timestamped screenshot on May 12, 2026, around 4:07 PM PT. This defect is reproducible and renders the automated safety suite unreliable. 2. Powertrain & Mechanical Defects: Pneumatic Air Leaks: The vehicle exhibits 100% pneumatic air leaks during acceleration. The service center has dismissively characterized a total pneumatic system failure as "normal," which I find technically unacceptable and a sign of neglected mechanical integrity. 3. Electrical & Starting System: Recurring Ignition Failures: The vehicle has experienced multiple failures to start, most recently leaving my child and me stranded for 10 minutes. Safety & Use Impairment: These intermittent failures compromise the vehicle's utility and the safety of my family. Incident History: The first time this occurred, I called Audi Roadside Assistance, but the engine started approximately 30 minutes later; as a result, I do not call roadside assistance now when it happens and instead attempt to restart it repeatedly. Current Status: I am forced to drive the car in a constant dilemma, knowing it might fail at any time and leave me stranded.

The contact was informed that the gateway control module needed to be replaced. The vehicle was being repaired. The contact was informed that the plastic protective bag that covered the gateway control module was filled with water. In addition, the dealer informed the contact that the NHTSA Campaign Number: 21V947000 (Electrical System, Structure); recall repair was performed prior to the contact purchasing the vehicle. The manufacturer was made aware of the failure but provided no assistance. The failure mileage was approximately 37,200.

needed to replace the entire transmission .Which they estimated at another 20 000 $. So the total damage is around 30 000$ .I contacted Audi USA about the whole situation when I received a negative message regarding the solution . I would like to point out that up until the moment mentioned we had no problems with the car .After my personal investigation of the problem ,I found that there was a safety recall # 21V-947 for same problem .It was not issued for my car which meets all the criteria.It looks like it was hidden by the manufacturer. Audi distances itself from the whole problem and refuses to cover the costs of the damage.Thank good this happened on the city road where the speed is low .If this happened on the highway at 60 MPH it would have had tragic consequences .Where it would never have been figured out what caused the accident. From a safety perspective ,I m reporting this dangerous and unfair treatment of customers by AUDI USA regarding the hidden recall and denial of resposability that occurred and I request an investigation .

service center? Yes, Audi dealership service center recommendation buy $22,000 for brand new engine . 4.Has the vehicle or component been inspected by manufacturer, police, insurance representatives or others? Inspected by Audi Dealership Service Center, and State Farm claims representative. 5.Were there any warning lamps, message or other systems of the problem prior to the failure, and when they first appear? When did first appeared a problem EPC light goes off and on January 17, 2023, loss of engine power, oil/coolant leaks, and etc.

the module with a plastic bag. This proved an insufficient repair backed up by a class action lawsuit filed in January 2022 titled Gioffe, et al. v. Volkswagen Group of America, Inc., et al. (Case No. 1:22-cv-00193). I reached out to Audi USA to request a Goodwill repair which was my only available recourse given that the recall had been completed and closed. After 5 days the Regional Manager denied my request even after I emphasized the safety risk associated with this catastrophic failure as well as the recall in 2021 and class action suit filed in 2022. I paid $1485.33 to re-repair the recall. Driving home from repair my vehicle alerted me to the following messages: Vehicle starting system: malfunction! Please contact Service, and Audi pre-sense: currently limited. See owner's manual. An OBD scan alerted 7 more codes: 1. Steering Assistance ID 44 (Terminal 30 Open circuit), 2. Central Electrics ID 09 (Garage door opener transmitter no communication), 3. Gateway ID 19 Control module for emergency call module and communication unit no communication, 4. Ethernet Notrufmodul keine Kommunikation, 5. Ethernet databus branch 1 No communication, 6. Multimedia ID SF Function restriction due to communication interruption, 7. Driver Assistance ID A5 Dynamic calibration Function limitation due to limit value exceedance.I reached out to the dealership that performed the service and was told that those are "ghost codes" and nothing to do with the work performed.

current recall for other Audi models, I contacted Audi and after inspection they diagnosed it as a failing instrument cluster. Since it's not in the current recall, I'm having to replace it. I've had computer issues in the past which the current Audi dealership has checked and told me there was nothing wrong, but after speaking to the Audi service tech many of the recalled issues were solved by a software update. The loss of the instrument panel is a major safety issue and Audi refuses to resolve the issue.

identical. This refusal raises significant concerns, as it leaves a known safety issue unaddressed solely due to recall limitations that may not yet reflect the full scope of the problem. In order to receive any resolution, the dealership is asking to cover diagnostic and service costs for the safety issue.

dealer for service. Audi Naples was able to detect fault, replicate problem and replaced the assembly on 4/10/2025 for $3,391.96. The dealer kept the part and told me to keep my receipt in case there is a recall. My car currently has 31,489 miles and had a total inspection and was last serviced on 1/22/2025 with 31,487 miles. I find it outrageous that a part like that would fail in such a short period of time. I was lucky I wasn't on a long trip away from home when it occurred.

told me that the computer is under the front seat. And water in this area may be causing the failure of the power steering and the door locks. So he said I should report it to you and you could possibly help.