Skf is recalling 2,805 hub units, part no. Br930361, sold as a service part for 1997-2004 dodge dakota vehicles and 1999-2003 dodge durango vehicles equipped with 2-wheel drive & rear axle abs. Due to a specification error, the rotor pilot for the hub unit...
Suspension
Dodge Dakota Suspension problems by year
1,752 complaints filed with NHTSA about the Dodge Dakota's suspension. Broken springs, struts, control arms, ball joints, noises and alignment that won't hold.
Suspension complaints by model year
Suspension recalls
On certain sport utility vehicles and pickup trucks equipped with four-wheel drive (4x4), if moisture leaks into the front suspension upper ball joint, evacuation of the lubricant and corrosion of the joint may cause the joint to wear over an extended period...
Some upper control arm attaching bolts can fail due to improper heat treatment. The bolts are too soft to withstand the stresses in the steering system and can break.
Latest Dakota suspension complaints
The front end got a hard vibrate i replace the shocks two times and its not fix the problem seem like something going too brake off like a wheel or something dont feel safe driving it
*Incomplete Recall Status* ***Defect in transfer case*** Complaint of Manufacturer Defect in 2005 Dodge Dakota Quad Cab 4x4 3.7l v6. While driving at a speed of 30mph on a smooth paved highway and selector switch turned to 2 wheel drive mode; out of nowhere, the transfer case tried to engage 4 High which resulted in SVC 4X4 warning lamp illumination and a loud grinding/stuttering sound from under carriage as well as halting me to 10 mph without any help from me. after pulling over on the roadside and putting truck...
Read the full complaint
in park and turning the engine off, i waited a couple of minutes and SVC 4X4 indicator and 4High dash light had gone. I restarted the truck only to find that the SVC 4X4 Warning lamp immediately returned and now the 4lo illuminated dash light is constantly showing and truck is still showing in 2 wheel drive with selector switch but 4x4 will not engage at all now. Took to a mechanic shop 1/2 mile down the road and had it read for any DTCs and inspected. Code came back as C1404. Transfer case still tries to engage as soon as truck door is opened and dome light comes on. SVC 4X4 warning indicator stays on the dash lit up and 4lo warning light flashes non stop. Manufacturers communication letter has been sent to dealerships for the proper installation steps of the transfer case on the model of my truck due to improper positioning. I have noticed no Recall but have found a Campaign ID listed for this issue. I've owned this truck for only DAYS now with the intention of presenting it to daughter for her 16th birthday next month and now there's a BIG concern here for safety and the fact that a recall hasn't been issued is crazy! ....it's completely absurd and should be escalated immediately until a consumer resolution is made. This truck is NOT safe at all with this defect by manufacturer transfer case! I am demanding that this faulty part be investigated and taken considerable responsibility for just for the amount of time allowed to pass!!
The contact owns a 2001 Dodge Dakota. The contact stated while driving approximately 70 MPH, there was a wobble coming from the front passenger's side tire. The contact was able to pull over and had the vehicle towed to a local mechanic to be diagnosed. The contact was informed that the ball joints needed to be replaced however, the vehicle was not repaired. There was no warning light illuminated. The manufacturer was not informed of the failure. The failure mileage was approximately 300,000.
Tl* the contact owns a 2006 dodge dakota. The contact stated while driving 40 mph, the vehicle started vibrating abnormally. The contact stated that the check engine warning light was illuminated. The vehicle was not taken to the local dealer. The vehicle was not diagnosed nor repaired. The manufacturer was informed of the failure. The contact was informed that the vin was not under recall. The failure mileage was approximately 169,000.
Tl* the contact owns 2000 dodge dakota equipped with cooper tires, tire line: futura, tire size: 275/75/r15. The contact stated that the tires were very loud while driving. The contact stated he took the tires to pepboys (7725 w newberry rd, gainesville, fl 32606, (352)332-6003) to be inspected. The contact was informed that the wheel bearings were faulty and needed to be replaced. The tires were not replaced. The manufacturer was notified of the issue. The approximate failure mileage was 235,100.
Axel snapped in half front left damaged , I was backing out of my driveway at a very low speed
Front driver side tire and hub assembly completely broke free from the vehicle this is a follow up from my first intial report to chrysler and also nhtsa phone conversation in which I did a report to both and paid 2500.00 Which I still have receipt of paying to have fixed...Father had a 2000 dodge durango which had the same recall that my didn't have as chrysler stated...
I took my 2005 dakota to repair shop because of clunking noise on front drivers side. Noise was heard when driving or rocking the truck when it was parked. Repair shop said lower ball joint completely failed and was riding on lower control arm instead of supported by ball joint. Upper ball joint was also bad. Passenger side upper ball joint worn out and lower ball joint boot was cracked. All tie rod ends also needed to be replaced.
Hello, I recently purchased a one owner 2005 dodge dakota, which has less than 35,000 miles and has been very well maintained. The car fax came back clean for accidents etc, but I have found, that both the front and rear sections of the chassis had to be replaced on driver and passenger sides and most of the front suspension had to be replaced too. Due to excessive deep rust. To the point of the nut holding the left outer tie rod end disintegrated. The straight side rails of the chassis are excessively deep...
Read the full complaint
rusted. As well as the oil pan and rear axle housing (which are original). The dealership had to cut off the front suspension components and replace all bushings and most of the front suspension components. Due to excessive rust and wear. My truck has barely been on the road for its year and has had minimal exposure to road chemicals such as salt etc. These components rotting away to this extent with such low mileage regardless of age indicates the use of poor quality materials being used during assembly and posing a potential safety issue to consumers. I opened a case# 57271603 with chrysler and the agent told, that even if the case was moved up for review . It would be sent back due to the age of the truck . Which I disagree with, as the front suspension components should not have rotted and disintegrated so badly and the chassis should not have had to have extensive repairs in less than 35,000 miles. I would think, that this poses a potential safety issue for anyone buying trucks using the same chassis and components from the same vendor, if they are not manufactured at a dodge plant. Ultimately it should be the car manufacturer's responsibility, that the parts they are using are quality and will not pose potential safety risk to consumers . Please let me know, if further information etc. Is needed. Thank you
Bad rust issue to areas including front and rear bumber, the entire bed including mounting points, fenders, cab corners and frame. Lost fender flare twice due to rust and almost caused an accident the entire bed slid back and almost fell off and fenders and bumbers are basically rust and need replaced, wheel wells on bed are falling apart causing a safety issue if I haul anything
This car has been a safety nightmare. From steel brake lines rusting through (and the vehicle losing it brakes), to upper ball joints almost separating to steering wheel drive shafts where the u-joints almost separated. These are not items that should fail like this. I spent part of my career looking after global product liability for cummins engine and I am stunned at the poor quality chrysler has used in critical components.
Brakes came apart when applied, no brake. Rattle on rotors, pad damage. Bolts that go through caliper stripped threads from spindle freeing caliper to bounce on rotor I have replaced with used part once hoping for recall, bad news dude!!!
Around 50,000 miles upper and lower ball joints making popping sounds. Took to local repair shop . Replaced all 4 , then popping stopped. Way to early for ball joint replacement. Occured while moving 5 mph and turning either direction.
This truck is a bad problem since I have been done along with the the years I'm tired of drivetrain wheel hubs and front suspension replaces every month.
Numerous front end repairs to no avail. Still having steering issues and loud banging when turning. Wipers coming on at random, battery light on in spite of new battery and alternator. We have spent over $4000 in repairs on from end and 2 wiper motors. The wipers still will not work properly.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data