Chrysler is recalling certain model year 2010 left hand drive jeep liberty, dodge nitro and ram 1500 truck; right and left hand drive jeep wrangler vehicles. These vehicles may have been built with an improperly formed master cylinder to hydraulic control...
Brakes
Dodge Ram Brake problems by year
353 complaints filed with NHTSA about the Dodge Ram's brakes. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
Brake complaints by model year
Brake recalls
Chrysler is recalling certain model year 2010 chrysler sebring; dodge avenger and nitro; jeep liberty, commander and grand cherokee; and model year 2009-2010 dodge ram truck. These vehicles may have been built with an improperly formed or missing brake...
On certain van and wagon vehicles equipped with 4-wheel antilock brake systems (abs), aftermarket batteries may leak electrolyte onto the abs control module connector, which can compromise sealing integrity of the connector.
Vehicle description: pickup trucks equipped with an anti-lock braking system (abs). Some vehicles may have inadequate clearance between the front tire/wheel and the brake hose/abs sensor wire assembly. During full lock turns, it is possible for the tire...
Vehicle description: light duty pickup trucks. The brake rotor material strength is not sufficient causing a hub fatigue fracture.
Vehicle description: pickup trucks equipped with diesel engines. The engine driven vacuum pump can allow engine oil into the vacuum hoses due to the absence of an internal check valve. The oil can cause the hose to deteriorate and partially collapse...
Latest Ram brake complaints
The contact owns a 2004 Dodge Ram 1500. The contact stated that the vehicle had experienced transmission failure, and the brake lines were rusted. The contact was trapped in the desert for hours with his dog. The contact stated that two independent mechanics had determined that the idler pulley needed to be replaced. The vehicle was repaired. The vehicle was taken to the local dealer, where it was diagnosed, and determined that six injectors and the ECM needed to be rebuilt. While driving, the vehicle went into the...
Read the full complaint
death wobble, and several linkages were damaged. Additionally, the front seat belts were inoperable with the seat belt warning light illuminated. The vehicle became inoperable. The vehicle was repaired under warranty previously, but the failure recurred. The manufacturer was contacted, but no additional assistance was provided. The failure mileage was approximately 228,510.
The contact owned a 2001 Dodge Ram 1500. The contact stated that while exiting a parking lot and attempting to depress the brake pedal, the brake pedal floored, causing the contact to roll to a stop on the side of the road. The ABS and Brake Warning lights illuminated. The contact was able to drive at 2 MPH to their home. The vehicle was towed to the dealer, who diagnosed that the brake line had blown and replaced it where it had failed. Approximately 6 months later, the ABS and brake warning lights illuminated...
Read the full complaint
again. The contact inspected the vehicle and noticed no leaks. When restarting the vehicle, the warning lights were no longer illuminated. While driving at an unknown speed, the ABS and brake lights illuminated again. The vehicle was taken to Meineke Car Care Center to a certified mechanic. The following morning, the lights were not illuminated. The vehicle was returned to Meineke Car Care Center, who stated that it may have been a computer glitch causing the lights to illuminate, then turn off when the vehicle was restarted. The contact had the brakes replaced as routine maintenance; however, after doing so, while driving in the rain at approximately 25 mph and attempting to apply the brakes, the brakes failed, causing the vehicle to rear-end the vehicle in front. The air bags did not deploy. The contact did not sustain injuries or require medical attention. The contact assumed the other driver had injuries, but could not confirm. A police report was filed. The contact was able to drive at a slow speed to their home. The ABS and Brake lights were illuminated. The vehicle was towed back to Meineke Car Care Center, where it was diagnosed that the other brake line had blown. The front end and brake line, which had blown was repaired. After the vehicle had been repaired, when coming to a stoplight, the failure occurred again, causing the vehicle to crash a second time. There were no injuries, air bags did not deploy. A police report was filed. The contact drove the vehicle to Meineke Car Care Center, who was not able to duplicate the failure. The damage was repaired; however, no failure was found with the brakes. After the second incident, while coming to a red light and applying the brakes, the vehicle continued to roll forward. The contact had to apply excessive pressure to the brakes, and the engine began to rev up. The contact had to immediately turn off the vehicle to come to a stop. The vehicle was returned to Meineke Car Care Center; however, the failure could not be duplicated. After the incident, the contact had the rotors' brake pads for the front brakes; however, while driving 60 MPH, the ABS and Brake lights illuminated. The contact pulled over at the next exit and inspected the vehicle, and found no issues, after restarting the lights were no longer illuminated. A certified mechanic inspected and informed the contact that there may have been an issue with the computer, causing the lights to illuminate. The contact noticed that when applying the brakes, the back wheel would sound as if it were locking, and when driving, during the winter, at approximately 10-15 MPH, the failure occurred again, causing them to rear-end another vehicle. The air bags did not deploy. The contact stated that a previous back injury had been irritated, but no medical attention was needed. The vehicle was totaled. The contact learned of NHTSA Campaign Number: 04V185000 (Service Brakes, Hydraulic), which made mention of the experienced failure however, they were unsure if their VIN had previously been included. and filed. The manufacturer was not made aware of the failure mileage was unknown.
Dodge Ram 2002 ABS brake module failure. No recourse for repairs. Dodge has rendered this part obsolete and although they have the technology to repair or replace it they neglect to help thousands of vehicle owners.
Mechanic said TIPM went bad. All gages guit working, check engine light stays on wind shield whipers turn on & off, engine stalls,all lights randomly turn on and off head lights turn signals exc. Transmission and 4 wheel drive say repair. Anti lock breaks acting up. Mechanic said this is happening alot for 2004 Dodge Ram trucks.
The contact owns a 2002 Dodge Ram 1500. The contact stated that while her husband was driving at various speeds, the ABS warning light illuminated and the vehicle seized. The contact managed to coast the vehicle to the shoulder of the road and place the vehicle in park. The contact exit the vehicle to inspect the engine and without warning when the front hood was open 4-foot flames shoot out from the hood. The contact sustained burns to the right hand. No medical attention was sought. The contact ran to the rear of...
Read the full complaint
the vehicle open the trunk and poured water that he had in a bucket on the flames. No police report was made. The fire department was not contacted. The vehicle was not repaired or diagnosed. No dealer was contacted nor the manufacturer was notified of the failure. Damages were to the wire harness, ABS module, and connecting rod. The failure mileage was approximate 220,000.
The brakes failed due to corrosion of the brake line from the master cyl. to the LH front brake flex hose. The brake fluid simply came out of the line. There was insifficient fluid pressure to do any wheel braking. Luckily, I had just moved off from a stop and was applying the brakes to slow down on a bend. The corrosion occured under a plastic clip that is there to keep adjacent brake lines from vibrating against each other. The corrosion occured in an area that is not inspectable unless the front wheel and wheel arch cover is first removed.
Tl* the contact owns a 2001 dodge ram 1500. While driving 50 mph, the brake pedal was depressed, but failed to respond. The vehicle was taken to an independent mechanic. The local dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was 200,000.
Brake line running front to back rusted out and corroded behind fuel tank stopped quickly from car pulling out and it ruptured also fuel lines going from master cylinder corroded and leaking
The brake line leading to the driver rear tire is severely corroded. The entire line from the master cylinder to the wheel will have to be replaced. My 16 year old daughter was driving the truck when the brakes fell to the floor. It leaked the entire contents of the brake fluid out. The breaks did still function but barely. Enough to get it home.She was on a busy street in traffic when the brake petal went to the floor.
Tl* the contact owns a 2001 dodge ram 1500. The contact stated that the brake system failed. While driving approximately 30 mph and attempting to slow down, the brake pedal stuck to the floor board. The contact was able to coast the vehicle over to the shoulder, inspected the vehicle, and found that the rear brake lines fractured due to corrosion. The vehicle was not diagnosed or repaired. The manufacturer was not notified. The approximate failure mileage was 62,800.
Tl* takata recall. The contact owns a 2004 dodge ram 1500. The contact stated that while driving at an unknown speed, the brake, the check engine, the abs and the front passenger's side air bag warning lights illuminated . The vehicle was taken to an independent mechanic who was unable to diagnose or repair the vehicle. The vin was included in nhtsa campaign numbers: 15v313000 (air bags) and 16v352000 (air bags). However, the parts needed to repair the vehicle were unavailable. The contact stated that the...
Read the full complaint
manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was not notified of the failure. The failure mileage was 157,000. Parts distribution disconnect and vin tool confirms parts unavailable.
2003 Dodge ram 1500. Consumer writes in regards to light switch still not working after repairs. *Smd the brakes and rotors were replaced. Also, the left front axle seal was starting to leak. *Jb
Tl* the contact owns a 2003 dodge ram 1500. While driving at an unknown speed, black smoke emitted from the rear of the vehicle without warning. In addition, when the brake pedal was depressed, an abnormal sound emitted from the vehicle. The vehicle was taken to the dealer where it was diagnosed that the brakes, calipers, and rotors needed to be replaced. The vehicle was repaired, but the failure recurred. The vehicle was taken to an independent mechanic where it was diagnosed that the hub bearing, wheel hub, axle...
Read the full complaint
shaft assembly, and driveshaft needed to be replaced. The vehicle was repaired. Lastly, the front driver side headlight failed to operate. The head lamp was replaced. The manufacturer was not notified of the failure. The failure mileage was 201,281. Updated 06/29/16*lj *tr
Rear brake line heavily corroded and ruptured in between the fuel tank and the frame (very little corrosion to the surrounding parts/frame). Fortunately the vehicle was parked when the line broke and I noticed I had lost virtually all braking ability while attempting to put it in gear. I had driven it 10 minutes prior to the line failing, and had noticed no degradation whatsoever.
While applying urgent braking at full pedal force due to another vehicle changing lanes in front of the vehicle at a much lower speed, the abs system failed to function, causing the vehicle to skid for two to three seconds over an unknown distance. After approximately two to three seconds applying full force to the brake pedal and skidding, the pedal suddenly released all resistance against the driver's foot and was able to become fully-depressed against the floorboard/firewall of the vehicle. At the moment of the...
Read the full complaint
event, the vehicle gave a violent shudder and all braking power was lost. The vehicle continued forward without brakes until striking another vehicle and coming to a full stop, resulting in multiple injuries and a total loss of the vehicle. Post-collision, the vehicle's brake pedal was able to be pressed completely to the floorboard/firewall of the vehicle with very little resistance. The approximate speed when braking was initiated was between 45 and 50 miles per hour. Police responding to the collision estimated that the vehicle was traveling at approximately 15 miles per hour at the final point of collision with the second vehicle involved according to the police report. *Js
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data