- The problem
- On certain van and wagon vehicles equipped with 4-wheel antilock brake systems (abs), aftermarket batteries may leak electrolyte onto the abs control module connector, which can compromise sealing integrity of the connector.
- The risk
- This may allow development of a short circuit in the connector, which could eventually lead to a fire.
- The fix
- Dealers will inspect the abs control module connector for electrolyte damage and replace the connector as necessary. The recall will begin on september 27, 2004. Owners should contact daimlerchrysler at 1-800-853-1403.
Brakes
2000 Dodge Ram Brake problems
Owners have filed 53 complaints about the 2000 Dodge Ram's brakes with NHTSA - 8% of all its complaints, most recently on May 26, 2015. They describe 4 crashes, 3 fires and 4 injuries. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
- Complaints
- 53
- Recalls
- 2
- Crashes
- 4
- Fires
- 3
- Injuries
- 4
- Deaths
- 0
Brake recalls for the 2000 Dodge Ram
- The problem
- Vehicle description: pickup trucks equipped with an anti-lock braking system (abs). Some vehicles may have inadequate clearance between the front tire/wheel and the brake hose/abs sensor wire assembly. During full lock turns, it is possible for the tire or wheel to contact the brake hose/abs sensor wire assembly.
- The risk
- This could ultimately result in wire damage and/or a hole in the brake line, affecting brake effectiveness, increasing the risk of a crash.
- The fix
- Dealers will replace the front brake hose assemblies, and the abs sensor wire will be inspected and replaced if necessary. Owner notification began march 8, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact daimlerchrysler at 1-800-853-1403.
Brake complaints
Tl* the contact owns a 2000 dodge ram 1500. While reversing at a low speed, the brake pedal was depressed but the vehicle failed to stop. The contact had to engage the emergency brake in order to stop the vehicle. In addition, the contact noticed that there was brake fluid leaking from underneath the vehicle. In addition, the contact stated that the dashboard fractured. The vehicle was taken to an independent mechanic who diagnosed that the brake lines needed to be replaced. The vehicle was repaired; however, the...
Read the full complaint
failure recurred. The vehicle was taken back to the mechanic who diagnosed that the brake lines needed to be replaced. The vehicle was repaired. The manufacturer was notified of the failure. The failure mileage was 89,000.
Tl* the contact owns a 2000 dodge ram 1500. The contact stated that while driving at approximately 35 mph and attempting to make a right turn, the front passenger wheel seized without warning. The vehicle was taken to the dealer where it was diagnosed that the anti lock braking system failed due to the aftermarket batteries installed in the vehicle leaking onto the abs control module connector. Additionally, there was corrosion present from battery acid. The vehicle was not repaired. The manufacturer was notified...
Read the full complaint
of the failure and stated that the vin was not included in nhtsa campaign: 04v185000 (service brakes, hydraulic). The approximate failure mileage was 100,000. The vin was not available.
2000 Dodge ram 1500 extended cab 2 wheel anti-lock right caliper keeps stickin everything is new I've miss 2wks work cause of it and have been fired because of it I cant go 5 miles with out it stickin I keep takin the caliper back to 3 different part store and they getting pissed I have new shoes,rubber hose,brake booster rwal valve anti lock valve crystal clear fluid its been to a brake shop and they r lost also im always on the side of road takin it apart to depress the caliper not sure if its a c body or not. *Tr
Driving in the parking lot at work. Went to slow down to pull into a space and pedal dropped to the floor. I hit the office building as a result. The rear brake line by the gas tank blew. *Tr
I went to change my front pads (for the 3rd time in 15 months) and noticed that yet again, one of my calipers was stuck and one of the piston diaphrams was torn. I replaced the caliper, put in my new pads, bled the system, and my brake pedal goes all the way to the floor, the vehicle is driveable, but my stopping distance has greatly reduced. I have to pump the pedal 2-3 times for the brakes to grab. If I stab on them, them pedal will travel all the way to the floor and then the rear wheels will lock up and the...
Read the full complaint
front brakes dont work at all. I replaced the master cylinder and the problem still persists. Dealership has absolutely no idea what the problem could be, and niether do any of the local shops. *Tr
2000 Dodge ram 1500 -dec 2009 - 47000 mile. No indication of brake issues until hitting them hard to avoid car that ran a red light. Brake line from master cylinder to rwal unit failed (pinhole leak), but managed to avoid collision. Drove home (slowly) and fabricated/installed replacement section (about 16" long). After bleeding brakes - drove truck normally until june 2010. Then, with no warning, the brakes again failed in a parking lot stop. Found the leak in the rear section of the line running from front to...
Read the full complaint
rear.Dealer estimate to replace all hard lines is $1000. Who can afford that ?? So, I will be spending many hours of my own time to fix the problem caused by cheap imported chinese steel. Thanks bill clinton !! I have other "good american cars" that are 40+ years old and 100k+ miles with the oem lines still good. These new vehicles suck !!! *Tr
The brake line on drivers side behind the gas tank burst due to corrosion I lost brakes while driving not able to stop well. Could cause injury. *Tr
Brake line behind the gas tank on drivers side burst due to corrosion on my 2000 dodge ram 1500 4x4. *Tr
Tl*the contact owns a 2000 dodge 1500. While driving 40 mph, the air idle valve did not open and caused the vehicle to stall when the brakes were applied. The contact believes that there is a defect in the design of the vehicle. The air idle valve was installed backwards and should remain in the open position to allow air to enter and for the vehicle to properly close. The failure occurred on two occasions. The contact took the vehicle to the dealer and they replaced the valve, which was installed in the same manner. The repair lasted for a year, but the failure has recently resurfaced. The vin was unknown. The failure mileage was 100,000 and current mileage was 112,000.
Tl*the contact owns a 2000 dodge ram 1500. While pulling out of the driveway, the contact noticed that the brakes felt low. He also noticed that the brake hose assembly was leaking brake fluid from the front brakes. The vin was not included in nhtsa campaign id number 01v038000 (service brakes, hydraulic foundation components: hoses, lines piping, and fittings); therefore, they would not assist with the repair. The vehicle is currently parked at the contact's residence. The failure and current mileages were 70,089. Updated 04-17-09 updated 04/20/09.*Jb
First is the dash. I bought the truck in feb 04 with 74,000 miles on it and shortly after I noticed a crack in the dashboard, since then the dash is falling apart and is more brittle than a sporting clay. If you snap off a piece and look at it you can see that about 1/5th of the way down from the top is brown since it has cooked in the sun. So that proves that dodge uses very cheap plastic for the dashboards. I looked into replacing it about 6 months ago and the top piece of the dash cost about 200$ and now that I...
Read the full complaint
have gotten my tax returns back I was going to get a new one but the price is now 375$. I guess dodge finally realized the problem with these dashboards and decided to cash in on them. The torque converter went out on the drive home from the dealership also, but 50 bucks from me and 2100$ from the warranty people fixed that. Second is the asd relay which means automatic shutdown relay and it isn't kidding with the name. A couple years ago when I started my truck it would shut off right away and wouldn't run right until I feathered the gas for a little bit, after replacing the throttle body control solenoid, the idle air control motor and mass air flow sensor I did a little more research and found it to be a 10 dollar relay from napa. The third problem is a whooping noise coming from the engine that I still can't figure out what it is. The truck makes the noise when its sitting still so I know its nothing in the suspension, although its louder when idling over small bumps. The fourth was the speed sensor in the rear differential, abs and brake light came on but didn't affect performance at all, replaced the sensor and didn't have any more trouble from it. Fifth problem is the back window leaks but I'm going to fix that with a generous blob of welder glue inside when I finally get around to pulling the headliner down. *Tr
While driving my 2000 dodge truck the main brake line ruptured without warning. I could not stop the vehicle and successfully attempted to do so with my emergency brakes. *Jb
Purchased a 2000 1500 quadcab dodge ram for 15,000. Three weeks later had to repair front brakes front rotors and front ball joints. Cost $700. Dealer refused to do anything about it. *Nm
While applying the brakes,the pedal went to the floor the consumer was able to stop the vehicle by applying the emergency brake and drove the vehicle to a mechanic. The mechanic informed the driver the right side rotor exploded. The mechanic recommended that the brake pads,and the left and right side rear rotor needed to be replaced. Please provide additional information. *Jb
The consumer took the vehicle to the dealer for because the abs light appeared on the dashboard. The mechanic informed the consumer that the sensor needed to be replaced. Please fill in additional information. *Jb
Consumer stated while attempting to apply the brakes they grabbed and then released. As a result, the consumer's vehicle rear ended another vehicle. No injuries reported. *Ak *jb
While making a right turn steering wheel failed. A loud squeaking noise was heard coming from the rear. Consumer applied the brakes and pedal went to the floor. Consumer was able to maintain control of the vehicle, and drove it to the dealer. Mechanic informed consumer that the problem could not be duplicated. *Ak
While braking pedal went to the floor, causing extended stopping distance. Dealership was notified, but did not resolve the problem. *Ak
Brake pedal got hard as a rock, consumer would have to stand on the pedal with both feet. *Ph *mr
1.Body jumps at different speeds unable to steere.2.Odometer reading didn't move for approx- 1st 200 miles.3.Engine knocks. 4. Shifting linkage and gears grind. 5. Transmission slips and front axle grinds. 6.Salesman said I was approved and did qualify for any vehicle in the lot with $10,000.00 Down.Called finance company after purchase and was approved for the vehicle I originally wanted.7.Brakes need to be replaced all the way around. Thank you, [[redacted]] information redacted pursuant to the freedom of information act (foia), 5 u.S.C. 552(B)(6). *Tr
I own a 2000 dodge ram 1500 quad cab. In the 72,000 miles that have been placed on the truck I have had to replace the brake rotors two times due to warping. The first was at 45,000 miles then at a little over 50,000. I'm at 72,000 miles now and the rotors have been worped for about the last 10,000 miles. It appears that when stopping I am using almost entirely the front brakes. The rotors are not substantial enough to stop a vehicle of this size. *Ak
1998-2001 B-van (dodge full size). Abs control module is protected with a 40 amp fuse. A 10 ga. Wire comes out of the control module, then this wire "y's" out to two 14 ga. Wires. It appears as though the abs pump or the relay sticks on these vehicles. Then one of the 14 ga. Wires over heats and catches the wiring harness on fire. The 40 amp fuse does not blow. The fire then continues until the van is engulfed in flames. This van is located at the verizon repair garage 6720 ammendale rd., Beltsville, maryland. *Ak
1998-2001 B-van (dodge full size). The abs control module is protected with a 40 amp fuse. A 10 ga. Wire comes out of the control module, then this wire "y's" out to two 14 ga. Wires. It appears as though the abs pump or relay sticks on these vehicles. Then one of the 14 ga. Wires over heats and catches the wiring harness on fire. The 40 amp fuse does not blow. The fire then continues until the entire van is fully engulfed in flames. This van is at burlington dodge. 90 Middlesex turnpick burlington, mass 01803. *Ak
Consumer states he has abs brakes and this am he attempted to brake and his system locked up on him causing him to run stop signs because his brakes did not work. He also states that his front brakes worked but his back one that did not work. Mr
Consumer states that the brake rotors are wearing and when applying the brakes the vehicle will have a heavy vibration and extended stopping distance. Dealer notified. Mr
Dodge Ram brake complaints by year
Ram brake problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data