- The problem
- Navistar is recalling certain model year 2012-2013 ic bus ce-c, hc, and international 9400 and certain model year 2011 through 2013 international durastar, paystar, workstar, transtar, lonestar, prostar, 9200, and 9800, and certain model year 2013 international 9900, vehicles, manufactured from december 2, 2010, through january 26, 2012, and equipped with bendix atr-6 traction relay valves. In extremely cold conditions, these bendix relay valves may potentially develop internal leakage. Internal leakage can lead to air pressure being delivered to affected primary or secondary brakes causing continuous brake application.
- The risk
- Unexpected continuous brake application can cause the brakes to overheat and lead to a fire. Unexpected continuous brake application can cause the driver to lose control of the vehicle, increasing the risk of a crash. Also, the brakes may be applied without illuminating the brake lights, failing to give proper warning to other drivers.
- The fix
- Navistar will notify owners, and dealers will provide a temporary repair until bendix develops a permanent remedy. This service will be performed free of charge. The safety recall began on april 10, 2012. Owners may contact navistar at 1-800-448-7825.
Brakes
2011 International Workstar Brake problems
No owner has filed a complaint about the 2011 International Workstar's brakes with NHTSA. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
- Complaints
- 0
- Recalls
- 3
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Brake recalls for the 2011 International Workstar
- The problem
- Navistar is recall certain model year 2011 and 2012 international durastar, paystar, workstar, transtar, lonestar and prostar commercial trucks manufactured from november 5, 2010, through march 10, 2011, for failing to comply with federal motor vehicle safety standard no. 121, "Air brake systems (abs)." The trailer abs fault indicator lamp in the instrument cluster will not illuminate due to a programming or hardware issue with the brake system electronic control unit.
- The risk
- An inoperable trailer abs fault indicator may prevent the driver from being aware of a trailer abs fault condition Thereby possibly increasing the risk of a crash potentially Resulting in property damage, personal injury, or death.
- The fix
- Navistar will notify owners. Dealers will reprogram or replace the brake system electronic control unit free of charge. The safety recall began on may 12, 2011. Owners may contact navistar at 1-800-448-7825.
- The problem
- Navistar is recall certain model year 2011 and 2012 international durastar and workstar commercial trucks manufactured from october 19, 2010, and february 3, 2011, equipped with gunite automatic slack adjusters. Due to an incomplete "knitting" of the iron at the time of casting, inadequate structural integrity of the slack adjuster housing can occur, which could cause the housing to break at the handle under normal operating loads.
- The risk
- If the slack adjuster housing were to break, the wheel brake to which the slack adjuster is attached would no longer function, reducing braking capacity and, in some cases, causing the vehicle to pull to one side. Reduced braking performance and/or loss of steering control increases the risk of a crash.
- The fix
- Navistar will notify owners and dealers will replace the subject slack adjusters free of charge. The safety recall is expected to begin on or about april 1, 2011. Owners may contact navistar at 1-800-448-7825.
Brake complaints
No complaints about this area yet.
International Workstar brake complaints by year
Workstar brake problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data