Chrysler (FCA US, LLC) is recalling certain 2022 Ram 1500, Jeep Gladiator, and 2021 Jeep Wrangler vehicles. The front seat belt retractors may have an improperly welded micro gas generator, which can result in seat belt pretensioner failure.
Seats & seat belts
Jeep Gladiator Seat Belt problems by year
9 complaints filed with NHTSA about the Jeep Gladiator's seats & seat belts. Seat belts that won't latch or retract, seat frames, seat heaters, recliners and child seat anchors.
Seat Belt complaints by model year
Seat Belt recalls
Chrysler (FCA US LLC) is recalling certain 2019 Jeep Wrangler and Ram 2500, 2019-2020 Ram 1500 and 2020 Jeep Gladiator vehicles. In the event of a crash, a front seat belt retractor may not properly slow the occupant's forward movement after locking.
Latest Gladiator seat belt complaints
I was rear ended while stopped and the seat belts didnt lock causing injury to my face from hitting the steering wheel.
Description of the Safety Issue I am submitting this complaint to report a serious seat belt safety incident involving entrapment and inability to self-release, which required emergency intervention. While parked, my daughter as a passenger in my Jeep Gladiator, became tangled in the seat belt in such a way that she was physically unable to release herself or exit the vehicle. Despite multiple attempts, the seat belt could not be disengaged, and the situation escalated to the point where I had to cut the seat belt...
Read the full complaint
to free her. This was not caused by a crash, sudden stop, or misuse. The seat belt's configuration, retraction behavior, or release mechanism appeared to contribute to the entrapment and prevented normal occupant egress. Why This Is a Safety Concern Seat belts are intended to protect occupants and allow safe release when needed. In this incident, the seat belt instead: -Entrapped a child occupant -Prevented self-release -Created a situation where cutting the belt was the only way to avoid further harm Had this occurred during an emergency (fire, water submersion, post-collision scenario), the inability to quickly exit the vehicle could have resulted in serious injury or worse. Outcome of the Incident -No collision occurred. -No vehicle warning lights or alerts were present. -The seat belt was rendered unusable only because it had to be cut as an emergency safety measure. -The incident caused significant distress and created an immediate safety hazard. Request for Review I am requesting that NHTSA: -Review this incident as a potential seat belt design or functional defect -Consider whether similar incidents may be occurring but underreported -Evaluate whether this issue warrants further investigation, service bulletin, or recall activity Seat belts should never place occupants - especially children - into situations where escape is difficult or impossible.
The contact owns a 2020 Jeep Gladiator. The contact stated while driving 50 MPH, the instrument panel became inoperable. The contact was able to continue driving the vehicle. The contact stated that the failure was permanent. The contact related the failure to NHTSA Campaign Number: 24V652000 (Electrical System); however, the VIN was not included. Additionally, the contact stated that the front driver's side seat belt had failed to retract as needed and remained loose. The contact related the failure to NHTSA...
Read the full complaint
Campaign Number: 20V580000 (Seat Belts); however, the VIN was not included. The dealer was contacted, and an appointment was scheduled for a diagnostic test. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 74,000.
The contact owns a 2022 Jeep Gladiator. The contact stated that the front passenger's side seat bolster had fractured, and the occupant was no longer secured in the seat. Also, while driving over bumps in the road, the vehicle was swaying side to side causing the vehicle to become unstable and difficult to steer. The cause of the failure was not yet determined. The local dealer and manufacturer were notified of the failure. The failure mileage was 15,000.
After only 19,000 miles driven the left and right side rear seat belts ripped. This is a 3rd car and not driven often. Both belts ripped from inside the recoil device. It is possible they broke previously and I only discovered it recently when putting my kids in the car.
The contact owns a 2021 Jeep Gladiator. The contact stated that the rear middle seat belt failed to retract or operate as needed. The contact stated that the seat belt had to be manually tightened to function as needed. The contact initially took the vehicle to the dealer where a diagnostic test found no defect with the seat belt. As the failure persisted, the contact took the vehicle back to the dealer where the failure was confirmed and the contact was provided an estimate for the repair. The manufacturer was notified of the failure and the contact was informed that the vehicle was out of warranty. The vehicle was not repaired. The failure mileage was approximately 17,000.
The subject Jeep Gladiator was involved in a side impact collision on June 18th, 2022. During the collision, the rear seat belts did not lock resulting in two children colliding with the rear of the two front seats. The side impact airbags did not deploy despite the impact being quite severe. The front airbags did deploy despite there being no impact to the front of the vehicle. Both the seat belts failing and the lack of side impact airbag deployment presents a safety hazard to the rear occupants of the...
Read the full complaint
vehicle in the event of a crash. The front airbags deploying without the requisite impact presents a safety hazard to front occupants of the vehicle. The seat belts still will not lock with any amount of pressure. The dealer will not discuss the issue and the insurance company, through a repair shop, currently has possession of the Jeep. There was no warning of any kind that the seat belts would not lock and the airbags would not deploy/deploy.
The vehicle auto stops when the driver's seat is not occupied, in direct conflict with owner's manual. The owner's manual specifically states that if the "Driver's seat is not occupied" that the "engine will not stop." Note that this system safety check is separate and distinct from the "Driver's seat belt is not buckled" check. Furthermore, the instrument cluster never presents a "STOP/START READY" message which is the first necessary condition for an auto stop. The vehicle fails to properly check for the empty...
Read the full complaint
driver's seat safety condition before auto stop. This auto stop violates Jeep's published safety check condition and poses a serious safety hazard. This issue poses additionally serious safety hazards as the vehicle will shut off with the driver outside the vehicle, leaving the driver with an incorrect understanding that the vehicle is properly locked out from an auto start condition. Therefore, if the driver is operating on or under the vehicle with it auto stopped, the passenger can unintendedly auto start the vehicle resulting in a serious injury or the loss of a finger. Additionally, in thinking that the vehicle is off the driver may leave the vehicle unattended in their garage and after 5 minutes the vehicle will auto start filling the garage / house with toxic fumes and presenting a serious life-threatening fire hazard. The malfunction was reproduced and confirmed by multiple service personnel, who expressed safety concerns. The malfunction was also recreated by 4 independent mechanic shops and documented as a safety concern. However, an FCA Technical Advisor (TA) claimed that the vehicle is "operating as designed". This portion of the vehicle's Auto Start / Stop System is NOT operating as designed and documented in the owner's manual. I feel unsafe driving the vehicle, as this is one of numerous hardware / software malfunctions plaguing the vehicle. The vehicle is available for inspection upon request.
The vehicle auto stops when putting on the driver's seat belt, in direct conflict with owner's manual. The owner's manual specifies that if the "Driver's seat belt is not buckled" it will prevent an auto stop, but preventing the auto stop is the opposite of the act of buckling the seat belt initiating the auto stop. Furthermore, the instrument cluster does not present a "STOP/START READY" message which is the first necessary condition for an auto stop. This issue creates a serious safety hazard, as the vehicle...
Read the full complaint
presents factually incorrect information to the driver and the vehicle unexpectedly stops creating driver confusion and distraction. Additionally, this creates a serious safety hazard as the issue inhibits the driver from attempting to flee an emergency situation, wherein the driver hops into an idling vehicle, plugs in their seat belt, and the vehicle turns itself off. The malfunction was reproduced and confirmed by multiple service personnel at 2 different dealerships, who expressed safety concerns. The malfunction was also recreated by 4 independent mechanic shops and documented as a safety concern. However, an FCA Technical Advisor (TA) claimed that the vehicle is "operating as designed". This portion of the vehicle's Auto Start / Stop System is NOT operating as designed and documented in the owner's manual. I feel unsafe driving the vehicle, as this is one of numerous hardware / software malfunctions plaguing the vehicle. The vehicle is available for inspection upon request.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data