- The problem
- Kenworth is recalling 3,423 my 2004-2009 t2000, t800,t600, w900 and t660 vehicles. Increased brake excitation in a certain vehicle configuration which includes bendix drum brakes, wide base low profile single tires, and an ag400 or ag460 rear suspension, due to its unique brake clocking and cam tube length, can cause fatigue and cracking to brake assembly components.
- The risk
- Cracking can cause a complete fracture of the cam tube, which could increase stopping distance and decrease parking brake hold capability.
- The fix
- Dealers will inspect the rear axle brakes assembly, replace cracked rear axle brakes assembly components where required, and install cam tube support brackets on all rear axle wheel ends free of charge. The recall is expected to begin or before july 25, 2009. Owner may contact kenworth at 1-425-828-5440.
Vehicle safety record
2006 Kenworth T600 Problems, complaints & recalls
Owners have filed 1 complaint about the 2006 Kenworth T600 with NHTSA, most often about the suspension (1) and the wheels & tires (1). It is covered by 8 recalls, the latest in June 2009 for the service brakes, air. For comparison, the 2005 has 4 and the 2007 has 1.
NHTSA data checked
DMore problems than a typical T600 year, for its age
#433 most complained-about 2006 vehicle
- Complaints
- 1
- Recalls
- 8
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Most common 2006 Kenworth T600 problems
Share of all 1 complaints. One complaint can name more than one area. Tap an area for its complaints and recalls.
2006 Kenworth T600 recalls 8
Recall repairs are free. Your dealer fixes them whether or not you bought the car there - check your VIN at nhtsa.gov/recalls to see if yours is done. What to do
- The problem
- Paccar is recalling 130 my 2004-2009 t2000, t800, t600, w900 and t660 kenworth trucks built with an ag400 rear suspension, long stroke brake chambers, and wide base tires (super singles). These vehicles may develop an increase in lateral and vertical axle movement. This movement may cause part or parts of the brake assembly (brake cam tube support, brake chamber bracket, brake chamber, brake spider) to develop fatigue cracks, possibly resulting in the failure of the part or parts within the brake assembly.
- The risk
- A failure may reduce vehicle brake performance, increasing the risk of a crash.
- The fix
- Dealers will install the cam tube support brackets on all of the rear axle wheel ends. Inspect the rear axle brake assembly and replace it if cracked. The recall is expected to begin during november 2008. Owners may contact kenworth at 1-425-828-5440.
- The problem
- Paccar is recalling 4,883 my 2006-2009 kenworth t600, t660, t800, w900, t2000 and my 2008-2009 peterbilt 365, 367, 379, 384, 386, 387, 388 and 389 trucks. Inadequate stiffness of the diesel particulate filter (dpf) bracket could result in separation of the dpf from the chassis.
- The risk
- A vehicle crash could occur if another vehicle strikes the dpf on the roadway.
- The fix
- Paccar is working with caterpillar to repair these vehicles (please see 08e041). Owners may contact caterpillar at 1-800-447-4986 or kenworth at 1-425-828-5440 or peterbilt at 1-940-591-4196.
- The problem
- On certain trucks equipped with caterpillar c11, c13 or c15 engines, the oil fill cap can become dislodged due to cap damage or improper installation and become lodged in the u-joint of the steering driveline and steering gear.
- The risk
- If the cap becomes dodged in this area, it may result in difficulty steering the vehicle or cause complete steering lock-up increasing the risk of a crash.
- The fix
- Paccar is working with caterpillar to repair these vehicles. Revised oil cap retention based on the engine model/configuration will be incorporated to prevent steering lock-up. The recall began during december 2007. Owners may contact caterpillar at 1-800-447-4986 or kenworth at 425-828-5440.
- The problem
- On certain trucks, the removable tow hitch ,when used to tow or lift a vehicle, can fail due to defective material in the tow hitch.
- The risk
- If the tow hitch assembly fails while a vehicle is being towed or lifted, it may cause an accident that could result in personal injury or death.
- The fix
- Dealers will replace the tow pin assembly free of charge. The recall began on september 4, 2007. Owners may contact kenworth at 425-828-5440 or peterbilt at 940-591-4201.
- The problem
- On certain trucks, an ra529 king pin release air valve was manufactured with the internal spool installed backwards. This results in the air option of the king pin release system being inoperable. To correct this situation, the vehicle's air lines were reversed rather than replacing the valve.
- The risk
- With the lines reversed, the king pin can be released without the driver's knowledge. When this occurs, the driver could drive away and the trailer could become disengaged, increasing the risk of a crash.
- The fix
- Kenworth will inspect the king pin release system and suspect valve. If any vehicles have a nonconforming valve or incorrect plumbing, it will be replaced and re-plumbed. The recall began on november 29, 2006. Owners may contact kenworth at 1-425-828-5440.
- The problem
- On certain tractors equipped with caterpillar diesel engines, the variable valve actuation oil line may wear against the sharp edge of the cylinder head if not positioned correctly.
- The risk
- The oil line may be cut on the cylinder head causing an oil leak and a possible fire.
- The fix
- Caterpillar, in conjunction with paccar, will be conducting the owner notification and remedy for this campaign free of charge. Owners may call caterpillar at 309-675-6496, kenworth at 425-828-5440, or peterbilt at 940-591-4201.
- The problem
- On certain trucks equipped with the bendix electronic stability control (esp) system, the system uses multiple sensors and an electronic control unit (ecu) to control vehicle under steer, over-steer, and rollover situations. The system relies on vehicle sensors to be functioning and aligned properly. The steering angle sensor has the potential to be misaligned with the steering column shaft, thereby providing incorrect information to the bendix ecu.
- The risk
- This condition could affect vehicle throttle control and braking, thereby leading to loss of vehicle steering control which could cause a crash without warning.
- The fix
- Because of the immediate and substantial risk, kenworth and peterbilt dealers will first deactivate the yaw control feature of the bendix esp system preventing inadvertent esp activation. When parts are available, the steering column will be replaced to insure proper alignment of the steering shaft sensor and the full esp system will be reactivated. The recall began on december 7, 2005. Parts to complete the remedy are estimated to be available in early 2006. Owners may contact kenworth at 1-425-828-5440 or peterbilt at 1-940-591-4201.
What owners say
Problems or none - your experience is exactly what the next buyer is looking for. Write it now
1 complaints about the 2006 Kenworth T600
Newest first, as filed with NHTSA by owners.
Front axle was over weight by 800 lbs. It was 1200 lbs overweight without a trlr and full of fuel. Kenworth refuses to accept responsibility for it. Chp issued a ticket and I was fined $161 as a result. Vehicle was improperly manufactured. *Jb
Kenworth T600: every year compared
All T600 years2006 Kenworth T600 vs rivals
| Vehicle | Complaints | Recalls | Grade | |
|---|---|---|---|---|
| 2006 Kenworth T600 | 1 | 8 | D | |
| 2006 Kenworth T2000 | 7 | 7 | D | Compare |
| 2006 Kenworth T800 | 4 | 13 | D | Compare |
| 2006 Kenworth W900 | 1 | 11 | C | Compare |
| 2006 Kenworth C500 | 1 | 5 | D | Compare |
More sales usually means more complaints, so compare similar vehicles of the same year. The grade compares each vehicle with its own model's other years.
Questions about the 2006 Kenworth T600
Does the 2006 Kenworth T600 have any recalls?
Yes - NHTSA lists 8 recalls for the 2006 Kenworth T600: service brakes, air (June 2009); suspension (September 2008); diesel (September 2008); engine and engine cooling (June 2007) and more. Recall repairs are free at any authorized dealer. Enter your VIN at nhtsa.gov/recalls to see whether yours has been fixed.
What are the most common problems with the 2006 Kenworth T600?
By the complaints owners filed with NHTSA, the most common problem areas are the suspension (1), wheels & tires (1).
How many complaints has the 2006 Kenworth T600 had?
1 complaints have been filed with NHTSA, the first on August 27, 2007 and the latest on August 27, 2007. Of these, 0 describe a crash and 0 a fire, and together they report 0 injuries and 0 deaths.
Is the 2006 Kenworth T600 a reliable vehicle?
Its Safety Index is 32 out of 100 (grade D: more problems than a typical Kenworth T600 year, for its age). The index weighs complaints, crashes, fires, injuries, deaths and recalls against how long the vehicle has been on the road, compared with the same model's other years. It is not a measure of every repair - read the complaints and owner experiences, and have any used vehicle inspected before you buy.
Which Kenworth T600 years have the most complaints?
2005 (4), 1997 (2), 2003 (2). See every Kenworth T600 year compared.
What should I do if my 2006 Kenworth T600 has a problem?
If it is a safety problem, stop driving it if it is unsafe and contact your dealer. Report it to NHTSA at nhtsa.gov/report-a-safety-problem - enough reports start investigations and recalls - and share your experience here so other owners know what to look for.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data