- The problem
- On certain trucks equipped with truck hub units manufactured by skf exclusively for use on arvinmeritor's ff98x series non-drive steer axles, the hub unit bearings can wear prematurely.
- The risk
- Seizure of the bearings can cause wheel separation or wheel end fire.
- The fix
- Dealers will replace all front axle hubs. Notification began july 16, 2003. The manufacturer has advised us that parts will not be available until september 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy with a reasonable time should contact peterbilt at 940-591-4201 or kenworth 425-828-5440.
Vehicle safety record
2000 Kenworth T600 Problems, complaints & recalls
No owner complaints about the 2000 Kenworth T600 have been filed with NHTSA. It is covered by 7 recalls, the latest in April 2003 for the hub.
NHTSA data checked
DMore problems than a typical T600 year, for its age
- Complaints
- 0
- Recalls
- 7
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
2000 Kenworth T600 recalls 7
Recall repairs are free. Your dealer fixes them whether or not you bought the car there - check your VIN at nhtsa.gov/recalls to see if yours is done. What to do
- The problem
- Heavy duty trucks equipped with trw tie rod ends on certain arvinmeritor and dana axles. Peterbilt will recall 1,434 vehicles equipped with arvinmeritor axles manufactured from december 11, 1999, to may 14, 2000, and from july 22 to september 30, 2000. Kenworth will recall 859 vehicles equipped with arvinmeritor vehicles manufactured from december 11, 1999, to may 23, 2000, and from july 27, 2000, to september 30, 2000 and kennworth will recall an additional 4,151 vehicles equipped with dana axles and manufactured from june 23 to december 6, 1999, and from may 23 to september 30, 2000. The tie rod and drag link ball stud ends contain bearings that are below the specified case depth and/or hardness.
- The risk
- This can lead to premature wear with possible separation of the ball stud from the socket, increasing the risk of loss of control of the vehicle.
- The fix
- Dealers will remove and replace all affected tie rods and drag links with different designed ends. Owner notification began july 15, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact peterbilt at 1-940-591-4201 or kenworth at 1-425-828-5440.
- The problem
- On some heavy duty trucks equipped with alcoa fujikura ltd. (Afl) power distribution boxes (pd box), the pd boxes were manufactured with insufficient torque applied to the nut of the main power feed-through stud.
- The risk
- Insufficient torque can lead to (1) electrical arcing of the wires inside of the pd box, or (2) an interrupted power supply to the vehicle's electrical system, either of which can lead to a loss of vehicle electrical power and possibly vehicle control without warning.
- The fix
- Dealers will inspect and tighten the nut on the main power feed-through stud. Owner notification began february 25, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1-425-828-5440.
- The problem
- Vehicle description: heavy duty trucks equipped with trw tie rod ends on certain meritor axles. The tie rod and drag link ball stud ends contain bearings that are below the specified case depth and/or hardness.
- The risk
- This can lead to premature wear with possible separation of the ball stud from the socket, increasing the risk of loss of control of the vehicle.
- The fix
- Dealers will remove and replace all affected tie rods and drag links with different designed ends. Owner notification began october 24, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact peterbilt at 1-940-591-4000 or kenworth at 1-425-828-5000.
- The problem
- Vehicle description: vehicles equipped with 54" rear axle spacing configuration of the airglide 200 suspension with the service application identified as logger, dump truck, or tanker. The rear suspension is regularly subjected to extreme articulation, resulting in flexing of the joint.
- The risk
- Failure of the lower sway arm attaching bolts could result in loss of vehicle control.
- The fix
- Dealers will replace the lower sway arm brackets. Owner notification began march 27, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1-425-828-5000.
- The problem
- Vehicle description: heavy duty trucks equipped with an optional firewall-mounted circuit breaker. The main cab power and battery power leads were attached incorrectly. This condition can result in the main cab power being unprotected.
- The risk
- If a wiring short occurred anywhere along the cab power circuit, the available battery power could arc and cause subsequent damage to the vehicle or a fire.
- The fix
- Dealers will inspect and correct the problem, as needed. Owner notification began february 26, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1-425-828-5000.
- The problem
- Vehicle description: heavy duty trucks equipped with eaton autoshift gen ii transmission assemblies. Due to a software problem in the transmission assemblies, the transmission will select the wrong gear.
- The risk
- If an inappropriate gear is selected without the driver's knowledge, the vehicle will react differently than expected, possibly resulting in injury or crash.
- The fix
- Dealers will replace the autoshift transmissions. Eaton performed the campaign for the kenworth portion. However peterbilt will be conducting their own campaign.
What owners say
Be the first T600 owner to share.
Problems or none - your experience is exactly what the next buyer is looking for. Write it now
No complaints about the 2000 Kenworth T600 yet
No owner has filed a complaint about this vehicle with NHTSA. If yours has a problem, share it here and report it to NHTSA.
Kenworth T600: every year compared
All T600 years2000 Kenworth T600 vs rivals
| Vehicle | Complaints | Recalls | Grade | |
|---|---|---|---|---|
| 2000 Kenworth T600 | 0 | 7 | D | |
| 2000 Kenworth W900 | 7 | 9 | C | Compare |
| 2000 Kenworth T2000 | 2 | 6 | C | Compare |
| 2000 Kenworth Conventional Series | 2 | 0 | - | Compare |
| 2000 Kenworth T800 | 1 | 10 | C | Compare |
| 2000 Kenworth T800B | 1 | 0 | C | Compare |
| 2000 Kenworth Kenworth | 1 | 0 | A | Compare |
More sales usually means more complaints, so compare similar vehicles of the same year. The grade compares each vehicle with its own model's other years.
Questions about the 2000 Kenworth T600
Does the 2000 Kenworth T600 have any recalls?
Yes - NHTSA lists 7 recalls for the 2000 Kenworth T600: hub (April 2003); tie rod assembly (July 2002); wiring (February 2002); tie rod assembly (August 2001) and more. Recall repairs are free at any authorized dealer. Enter your VIN at nhtsa.gov/recalls to see whether yours has been fixed.
How many complaints has the 2000 Kenworth T600 had?
None have been filed with NHTSA so far.
Is the 2000 Kenworth T600 a reliable vehicle?
Its Safety Index is 38 out of 100 (grade D: more problems than a typical Kenworth T600 year, for its age). The index weighs complaints, crashes, fires, injuries, deaths and recalls against how long the vehicle has been on the road, compared with the same model's other years. It is not a measure of every repair - read the complaints and owner experiences, and have any used vehicle inspected before you buy.
Which Kenworth T600 years have the most complaints?
2005 (4), 1997 (2), 2003 (2). See every Kenworth T600 year compared.
What should I do if my 2000 Kenworth T600 has a problem?
If it is a safety problem, stop driving it if it is unsafe and contact your dealer. Report it to NHTSA at nhtsa.gov/report-a-safety-problem - enough reports start investigations and recalls - and share your experience here so other owners know what to look for.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data