On certain trucks equipped with parker single check valves (scv) provided by bendix. The defect exists in the parker scv that connects with the supply port of the sr-7 spring brake modulating valve. After prolonged use of the parker scv, the valve body...
Brakes
Mack CV Brake problems by year
1 complaints filed with NHTSA about the Mack CV's brakes. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
Brake complaints by model year
Brake recalls
On certain trucks equipped with bendix sr-7 spring brake modulating valves, the internal rubber check valve may leak causing a delay in the application of the spring brakes to park the vehicle after the operator pulls the dash valve button.
Certain trucks equipped with a front glad hand option fail to comply with the performance criteria requirements of federal motor vehicle safety standard no. 121, 'Air brake systems.'
On certain trucks equipped with a legris air manifold, the brass push-to-connect cartridge may unexpectedly separate from the plastic housing.
On certain trucks equipped with sr-7 bendix brake valves, the check valve inside the valve cavity may not properly set, causing internal air leakage. If the check valve does not properly seat, the resulting leakage can cause a delay in the application of the...
On certain class 8 chassis built with hendrickson lift axles which contained webb brake drums, the brake drums could experience premature crack of the braking surface resulting in reduction or complete loss of braking on that wheel end or loss of brake drum...
Certain trucks fail to comply with the requirements of federal motor vehicle safety standard no. 121, "Air brake systems." The front brake chamber on some 18,000 lb. And 20,000 lb front axle assemblies is too small to meet stopping distance requirements.
Certain heavy duty vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 121, "Air brake systems." Improper seating of the check valve retainer in the brass fitting housing has occurred. It is possible for the air brake...
On certain trucks equipped with meritor wabco pneumatic anitlock brake system (abs) valve packages, the assembly bolts on these valve packages were not tightened correctly.
Vehicle description: heavy duty trucks equipped with certain meritor-wabco brake system two and four port relay valves. The valve may stick open when a high-pressure application is released.
Latest CV brake complaints
This vehicle is a 2003 mack truck model cv and is a straight frame dump truck with three rear tandem axles. Stopping is achieved through a standard air brake system where compressed air is used as the energy medium. The brake pedal effort of the operator is used only to modulate the air pressure applied to the brake chambers. This truck conforms to the dual brake system. Although the energy source is compressed air, the transmission of energy from the brake chamber to the friction surfaces involves lever arms and...
Read the full complaint
cams. The compressed air in the spring brake chamber maintains pressure on the spring during normal operation. When the brakes are activated, the air is relieved allowing the spring to decompress and apply the friction surfaces to the drums through the mechanical linkage. The fire patterns indicate that the fire was localized and originated from friction produced by the brake pads against the drum on the center right rear tandem wheels. The friction produced temperatures in excess of the ignition temperature of the tires causing them to ignite. There was no physical evidence of any electrical failure. The spring brake chamber is identified as mgm 3431157, m092702, 190e 4100 p7. Conclusion the fire was localized and produced by friction. The friction resulted from the brake pads against the drums of the center rear right tandem brakes. This friction produced sufficient temperatures to ignite the tires. The application of the brakes that produced the fire resulted from a failure of the spring brake chamber or its controlling service relay valve. The loss of air pressure resulted in the spring activation of that particular brake. *Jb
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data