Mack F Problems by year

The spring seat plate, located between the axle housing and the suspension springs, may deform due to spring bending. As a result, the clamping force in the assembly may be reduced. Loss of clamping force could cause spring failure and the axle will...

In the event of turbocharger compressor wheel failure, one or more of the four capscrews that hold the turbocharger together may be struck by parts of the compressor wheel, resulting in the capscrews being damaged. If these capscrews are damaged to the point...

The steel brackets on the suspension beam were found to be deficient due to excessive shrinkage and low mechanical properties. Failure of one or both of these brackets could cause a separation of the axle housing from the suspension.

Delays of up to about 2 seconds may exist in the brake application times to the brakes on the bogie axles in the presence of certain types of wheel speed sensor signal discontinuities or distortions that may occur as a result of sensor wire failure. This...

Deficiencies, in the form of forging laps, cracks and excessive decarburization during heat treatment, exist in the steering knuckles. Stresses imposed with integral hydraulic power steering may lead to a failure in the area of the steering arm attaching...

An axle "no brake" condition could result from an eaton controller internal electrical malfunction. This condition may cause the anti-wheel lock valve solenoid to be continuously energized and prevent the brakes from being applied on one of the axles. As a...

The tee bracket, which is mounted on the front axle of the bogie, may fail due to vibration brought on by road surface irregularities. Bracket failure would leave the tee bracket unsupported and cause broken hose connector fittings. This would result in...

A deficiency exists in the welds securing the rear spring insulator bracket to the axle housing. This is due to improper positioning of the weld, in relationship to the bracket and axle housing. Failure of the welds would cause separation of the spring...

The involved vehicles do not conform to federal motor vehicle safety standard no. 209, "Seatbelt assemblies". Although the seatbelts in question performed marginally with respect to the 5000 lb. Load requirement, additional testing confirmed that the anchor...

The flex blade fans on the involved vehicles may develop cracks in the laminated stiffener as a result of fatigue during operation. If such a condition exists and the cracks go undetected, continued operation could cause pieces of the stiffener to break off.

The front wheel rim clamp studs, installed on the involved vehicles, may not have been manufactured correctly, causing a brittle condition in the thread root area. The studs could eventually crack and break when wheel nuts are tightened to specifications.